Page | 1
NEIEP 200 FINAL REVIEW 2026
QUESTIONS AND ANSWERS| ACE
YOUR GRADES.
1. How often must hoist ropes be resocketed for an overhead
drum machine without any special safety shackles? - correct
answer -Once a year
2. Which drive groove configuration requires the use of a double-
wrapped secondary sheave? - correct answer -U-grooves
3. All cab modernization should be performed at what floor? -
correct answer -Top floor
4. What devices would you use to prevent the machine bedplate
from lifting on one end as the elevator starts or stops? - correct
answer -Tie downs
5. The star symbol is used on the COP for what? - correct answer
-To designate the main floor
, Page | 2
6. When using rope wedge clamps, which of the following must
be done? - correct answer -Use a wedge and socket sized
correctly for the rope
7. What is an effective method for checking pre-heated babbit
before pouring? - correct answer -Heat it to a point where it will
char a soft piece of pine
8. Which of the wire rope constructions listed below is the most
wear resistant? - correct answer -6 X 19 Seale
9. How many seizings are required on each side of the cut for
preformed rope according to ASME? - correct answer -1
10. what is the constructional stretch of a 500 ft. fiber core, 8
strand rope rated at 3/4% (.0075) of rope stretch per 100 foot?
- correct answer -3.75 ft. [ (100 X .0075)5 ]
NEIEP 200 FINAL REVIEW 2026
QUESTIONS AND ANSWERS| ACE
YOUR GRADES.
1. How often must hoist ropes be resocketed for an overhead
drum machine without any special safety shackles? - correct
answer -Once a year
2. Which drive groove configuration requires the use of a double-
wrapped secondary sheave? - correct answer -U-grooves
3. All cab modernization should be performed at what floor? -
correct answer -Top floor
4. What devices would you use to prevent the machine bedplate
from lifting on one end as the elevator starts or stops? - correct
answer -Tie downs
5. The star symbol is used on the COP for what? - correct answer
-To designate the main floor
, Page | 2
6. When using rope wedge clamps, which of the following must
be done? - correct answer -Use a wedge and socket sized
correctly for the rope
7. What is an effective method for checking pre-heated babbit
before pouring? - correct answer -Heat it to a point where it will
char a soft piece of pine
8. Which of the wire rope constructions listed below is the most
wear resistant? - correct answer -6 X 19 Seale
9. How many seizings are required on each side of the cut for
preformed rope according to ASME? - correct answer -1
10. what is the constructional stretch of a 500 ft. fiber core, 8
strand rope rated at 3/4% (.0075) of rope stretch per 100 foot?
- correct answer -3.75 ft. [ (100 X .0075)5 ]
