Millwright prep level 4 conventional alignment Exam Questions With Verified Answers
Millwright prep level 4 conventional alignment Exam Questions With Verified Answers When equipment is aligned, the _________ are collinear - answerShaft center lines Rotating shafts are usually aligned with the ________ in Place. - answerCouplings The two ways that a coupling must be aligned are __________. - answerRim and face The outer diameter of a coupling is also called the _________. - answerRim Offset misalignment is also called _________ misalignment. - answerParallel Vertical offset occurs when one of the coupling halves is _________ the other. - answerHigher or lower than One of the units, the driver or the driver, must be tilted on its base to correct _________. - answerVertical angularity One of the units must be rotated on its base to correct _______. - answerHorizontal angularity Only one kind of alignment can occur at a time. - answerFalse
Geschreven voor
- Instelling
- Millwright
- Vak
- Millwright
Documentinformatie
- Geüpload op
- 19 april 2024
- Aantal pagina's
- 2
- Geschreven in
- 2023/2024
- Type
- Tentamen (uitwerkingen)
- Bevat
- Vragen en antwoorden
Onderwerpen
-
millwright prep level 4 conventional alignment exa
Ook beschikbaar in voordeelbundel