EPA SECTION 608 TYPE I, TYPE II , TYPE III Correct 100%

What is typically used on small appliances as a service aperture or other device for adding or removing refrigerant? a. A straight piece of tubing that is entered using a piercing access tube. b. A line located 15 inches below the compressor. c. A valve installed at the factory which has a ¼ inch diameter and machine threads. d. A service aperture is not present because small appliances are exempt from this requirement. - ANSWER a. A straight piece of tubing that is entered using a piercing access tube. What type of appliances are technicians certified to service after passing the type 1 examination? a. Appliances containing 5 pounds or less of refrigerant that have been hermetically sealed and charged at the factory. b. Split systems containing 5 pounds or less of refrigerant that have been hermetically sealed and charged at the factory. c. Appliances containing 5 pounds or less of refrigerant that have an open drive compressor and have been charged at the factory. d. Motor vehicle air conditioning equipment. - ANSWER a. Appliances containing 5 pounds or less of refrigerant that have been hermetically sealed and charged at the factory.