Seattle FEX-1 Starter Exam with Questions & Answers 2025/2026
Conductivity
What type of test is necessary on a Co2
hose before installation?
50', 50', 50'
What is the maximum travel distance for a
Class B fire extinguisher? (Light hazard,
Ordinary Hazard, Extra Hazard)
Nationally recognized standards
Administrative Rating 9.01.04 states that
________ are to be followed.
20BC
A 10 Ft sq. heptane tank should have a
______ rated extinguisher protecting it.
Destroyed
An aluminum shell extinguisher that was in
a room that had a fire should be what?
5/3
A Co2 should be hydrotested to what
stamped operating pressure?
Does not require hydrotesting
A cartridge less than 2 in. in diameter and
2 ft. in length __________?
Red square
What is the identification mark for a class B
fire extinguisher?
70
What room temperature is used for a
ratings test on fire extinguishers?
Quick check
What does an inspection of a fire
extinguisher consist of?
Agent
What is not looked at during a quick
check?
Maintenance shall be done how often? Yearly
Extinguishing agent
Maintenance does not include a thorough
examination of which part of an
extinguisher?
Calcium Chloride, destroyed
Any stainless steel subjected to
______________ should be __________
January 1986
Labeling of test procedure started in
_________________?
No higher than 5 ft
An extinguisher with a weight no exceeding
40 lbs. shall be mounted how high?
An extinguisher with a weight in excess of No higher than 3 1/2 inches
40 lbs. shall be mounted how high?
What is not a disadvantage of dry chemical Low rating
extinguishers?
What rating does two 2 1/2 gallon water 2A
extinguishers have?
Fire equipment maintenance if the Tenant and owner
responsibility of whom?
Loaded-stream fire extinguishes shall have Annually
the agent replaced when?
Class D extinguishers have what type of None
numerical rating?
Cartridge operated extinguishers shall be The manufacturer's test pressure
hydrostatically tested to ________?
Conductivity
What type of test is necessary on a Co2
hose before installation?
50', 50', 50'
What is the maximum travel distance for a
Class B fire extinguisher? (Light hazard,
Ordinary Hazard, Extra Hazard)
Nationally recognized standards
Administrative Rating 9.01.04 states that
________ are to be followed.
20BC
A 10 Ft sq. heptane tank should have a
______ rated extinguisher protecting it.
Destroyed
An aluminum shell extinguisher that was in
a room that had a fire should be what?
5/3
A Co2 should be hydrotested to what
stamped operating pressure?
Does not require hydrotesting
A cartridge less than 2 in. in diameter and
2 ft. in length __________?
Red square
What is the identification mark for a class B
fire extinguisher?
70
What room temperature is used for a
ratings test on fire extinguishers?
Quick check
What does an inspection of a fire
extinguisher consist of?
Agent
What is not looked at during a quick
check?
Maintenance shall be done how often? Yearly
Extinguishing agent
Maintenance does not include a thorough
examination of which part of an
extinguisher?
Calcium Chloride, destroyed
Any stainless steel subjected to
______________ should be __________
January 1986
Labeling of test procedure started in
_________________?
No higher than 5 ft
An extinguisher with a weight no exceeding
40 lbs. shall be mounted how high?
An extinguisher with a weight in excess of No higher than 3 1/2 inches
40 lbs. shall be mounted how high?
What is not a disadvantage of dry chemical Low rating
extinguishers?
What rating does two 2 1/2 gallon water 2A
extinguishers have?
Fire equipment maintenance if the Tenant and owner
responsibility of whom?
Loaded-stream fire extinguishes shall have Annually
the agent replaced when?
Class D extinguishers have what type of None
numerical rating?
Cartridge operated extinguishers shall be The manufacturer's test pressure
hydrostatically tested to ________?
