Fanuc Certification
Turning the Teach Pendant On: - ANS-Gives motion control solely to the operator via
the Teach Pendant
What must be accomplished to avoid hard-stops and over-travels? - ANS-Set Axis
Limits
SHIFT and the hardkey COORD will display the following menu: - ANS-The "jog" menu
SHIFT and POINT are needed to do what? - ANS-Record the current position of the
robot
In the motion command "JP[2] 100% FINE", If you wanted to change the "FINE"
component to a "CNT100" what buttons would you press? - ANS-Select component,
then press [CHOICE]
To switch manually from one program to another, you have to be in which screen? -
ANS-Select
How many Robot I/O points are standard on a controller? - ANS-16
Which soft key is pressed to display the current motion instruction defaults from the
EDIT screen? - ANS-POINT
When creating a program, which hard key should be pressed? - ANS-Select
When using the Prog Adjust utility, which statement is correct? - ANS-Pressing
CLR_ADJ or CLR_ALL will save the current enabled data values
Which of these tasks can be performed from the FILE menu? - ANS-Get a directory of
the default device
If while jogging the robot, you get an "In singularity" error, what must you do? -
ANS-Joint jog J5 +/- at least 10 degrees
The "Program Header Information" at the DETAIL softkey enables you to modify the
following program information, except: - ANS-Active Tool Frame
Turning the Teach Pendant On: - ANS-Gives motion control solely to the operator via
the Teach Pendant
What must be accomplished to avoid hard-stops and over-travels? - ANS-Set Axis
Limits
SHIFT and the hardkey COORD will display the following menu: - ANS-The "jog" menu
SHIFT and POINT are needed to do what? - ANS-Record the current position of the
robot
In the motion command "JP[2] 100% FINE", If you wanted to change the "FINE"
component to a "CNT100" what buttons would you press? - ANS-Select component,
then press [CHOICE]
To switch manually from one program to another, you have to be in which screen? -
ANS-Select
How many Robot I/O points are standard on a controller? - ANS-16
Which soft key is pressed to display the current motion instruction defaults from the
EDIT screen? - ANS-POINT
When creating a program, which hard key should be pressed? - ANS-Select
When using the Prog Adjust utility, which statement is correct? - ANS-Pressing
CLR_ADJ or CLR_ALL will save the current enabled data values
Which of these tasks can be performed from the FILE menu? - ANS-Get a directory of
the default device
If while jogging the robot, you get an "In singularity" error, what must you do? -
ANS-Joint jog J5 +/- at least 10 degrees
The "Program Header Information" at the DETAIL softkey enables you to modify the
following program information, except: - ANS-Active Tool Frame
