UH-60M MTPC Written Examination Part I
Study online at https://quizlet.com/_16pxdw
1. What are a maintenance test pilot's MTP's and ME's will perform a minimum of four
annual requirements for iterations of iterations of each 4000 series maintenance test pilot
maneuvers? task annually. ME's will perform two iterations from
each crew station with access to the flight controls
annually.
2. What references can be used to de- The 3 28 23, or the applicable AWR or MWO.
termine if maintenance performed
requires an MTF or an MOC, besides
the appropriate maintenance manu-
al?
3. What chapters in the IETM should Chapters 2, 3, and 4. Troubleshooting schematics
be referenced when trying to trou- are at the end of each work package.
bleshoot?
4. The maintenance test flight manual Engine flushes, flat pitch track and balance, engine
tells us that an MTP in the left seat and oil cooler vibration checks, and maintenance
with any individual in the right seat operational checks that can be completed at flat
briefed to monitor the flight controls pitch.
may perform single engine ground
run ups with the rotor system turning
at flat pitch for what purposes?
5. What does section five contain in the Charts and forms.
MTF manual?
6. What manual is referenced when AR 700-138.
completing the monthly 1352 status
report?
7. What is the goal for overall FMC? At least 75%.
, UH-60M MTPC Written Examination Part I
Study online at https://quizlet.com/_16pxdw
8. Non Mission Capable for Mainte- No more than 10%.
nance.
9. Non Mission Capable for Supply. No more than 10%.
10. Partially Mission Capable. No more than 5%.
11. How long do you have to accomplish 84 hours.
an MTF after the MOC was completed
before NMCM time starts?
12. If a weather restriction prevents 24 hours.
you from performing an MTF, how
long do you have to accomplish the
MTF after the weather restriction no
longer exists?
13. What is the purpose of a data bus? To provide a medium for the exchange of data and
information between various systems.
14. When a 1553 data bus coupler has Using three thousand ohm stub terminators. This
unused terminal stubs, how are they simulates the resistance within the disconnected
terminated? sub-component.
15. Are 1553 data bus couplers inter- Yes.
changeable?
16. What must be done on the input/out- Terminated with a Red-Banded 78 ohm bus termi-
put connector on the last bus coupler nator. This creates the loop and a serial circuit.
in the series?
17. Where is the B4 Data Bus Coupler In the transition section on the left side.
located?
, UH-60M MTPC Written Examination Part I
Study online at https://quizlet.com/_16pxdw
18. How do we identify 1553 wiring in the Wiring with light blue shrink wrap.
UH-60 Mike?
19. What is used as the bus controller for The first FMS to boot up properly.
the 1553 data bus?
20. What are some components that are All four MFD's, both FMS's, both EGI's, the VOR
connected to the 1553 data bus? receiver, the A.P.R. 39, "I.V. Hums" (IVHMS), both
Arc-201's, both Arc-231's, the Transponder, the ADF
receiver, the I-Hud, ICS ICU, "See Moss" (CMWS),
and Tacan.
21. Who determines industry standard "Air Ink," (ARINC). Aeronautical Radio, Incorporated,
for how avionics are designed and established in 1929.
built?
22. What primary version of the "Air Ink," The "Air Ink," (ARINC) 4 29 version.
(ARINC) data bus is used in the UH-60
Mike?
23. Why is the Army using "Air Ink," (AR- "Air Ink," (ARINC) allows the Army to buy and quickly
INC) bus systems? integrate commercial off the shelf avionics systems.
24. How do we identify the "Air Ink," (AR- Black twisted pair.
INC) 4 29 wiring in the UH-60 Mike?
25. What are the four major components FCC's 1 and 2, EGI's 1 and 2, DCU's 1 and 2, and
on the "Air Ink," (ARINC) 4 29 Data ADC's 1 and 2.
Bus?
26. Are "Air Ink," (ARINC) 4 29 busses "You knee directional" (Unidirectional).
"you knee directional" (unidirection-
al) or bidirectional?
Study online at https://quizlet.com/_16pxdw
1. What are a maintenance test pilot's MTP's and ME's will perform a minimum of four
annual requirements for iterations of iterations of each 4000 series maintenance test pilot
maneuvers? task annually. ME's will perform two iterations from
each crew station with access to the flight controls
annually.
2. What references can be used to de- The 3 28 23, or the applicable AWR or MWO.
termine if maintenance performed
requires an MTF or an MOC, besides
the appropriate maintenance manu-
al?
3. What chapters in the IETM should Chapters 2, 3, and 4. Troubleshooting schematics
be referenced when trying to trou- are at the end of each work package.
bleshoot?
4. The maintenance test flight manual Engine flushes, flat pitch track and balance, engine
tells us that an MTP in the left seat and oil cooler vibration checks, and maintenance
with any individual in the right seat operational checks that can be completed at flat
briefed to monitor the flight controls pitch.
may perform single engine ground
run ups with the rotor system turning
at flat pitch for what purposes?
5. What does section five contain in the Charts and forms.
MTF manual?
6. What manual is referenced when AR 700-138.
completing the monthly 1352 status
report?
7. What is the goal for overall FMC? At least 75%.
, UH-60M MTPC Written Examination Part I
Study online at https://quizlet.com/_16pxdw
8. Non Mission Capable for Mainte- No more than 10%.
nance.
9. Non Mission Capable for Supply. No more than 10%.
10. Partially Mission Capable. No more than 5%.
11. How long do you have to accomplish 84 hours.
an MTF after the MOC was completed
before NMCM time starts?
12. If a weather restriction prevents 24 hours.
you from performing an MTF, how
long do you have to accomplish the
MTF after the weather restriction no
longer exists?
13. What is the purpose of a data bus? To provide a medium for the exchange of data and
information between various systems.
14. When a 1553 data bus coupler has Using three thousand ohm stub terminators. This
unused terminal stubs, how are they simulates the resistance within the disconnected
terminated? sub-component.
15. Are 1553 data bus couplers inter- Yes.
changeable?
16. What must be done on the input/out- Terminated with a Red-Banded 78 ohm bus termi-
put connector on the last bus coupler nator. This creates the loop and a serial circuit.
in the series?
17. Where is the B4 Data Bus Coupler In the transition section on the left side.
located?
, UH-60M MTPC Written Examination Part I
Study online at https://quizlet.com/_16pxdw
18. How do we identify 1553 wiring in the Wiring with light blue shrink wrap.
UH-60 Mike?
19. What is used as the bus controller for The first FMS to boot up properly.
the 1553 data bus?
20. What are some components that are All four MFD's, both FMS's, both EGI's, the VOR
connected to the 1553 data bus? receiver, the A.P.R. 39, "I.V. Hums" (IVHMS), both
Arc-201's, both Arc-231's, the Transponder, the ADF
receiver, the I-Hud, ICS ICU, "See Moss" (CMWS),
and Tacan.
21. Who determines industry standard "Air Ink," (ARINC). Aeronautical Radio, Incorporated,
for how avionics are designed and established in 1929.
built?
22. What primary version of the "Air Ink," The "Air Ink," (ARINC) 4 29 version.
(ARINC) data bus is used in the UH-60
Mike?
23. Why is the Army using "Air Ink," (AR- "Air Ink," (ARINC) allows the Army to buy and quickly
INC) bus systems? integrate commercial off the shelf avionics systems.
24. How do we identify the "Air Ink," (AR- Black twisted pair.
INC) 4 29 wiring in the UH-60 Mike?
25. What are the four major components FCC's 1 and 2, EGI's 1 and 2, DCU's 1 and 2, and
on the "Air Ink," (ARINC) 4 29 Data ADC's 1 and 2.
Bus?
26. Are "Air Ink," (ARINC) 4 29 busses "You knee directional" (Unidirectional).
"you knee directional" (unidirection-
al) or bidirectional?
