Written by students who passed Immediately available after payment Read online or as PDF Wrong document? Swap it for free 4.6 TrustPilot
logo-home
Document preview thumbnail
Preview 2 out of 7 pages
Exam (elaborations)

NICET LEVEL 1 EXAM QUESTIONS & UPDATED CORRECT ANSWERS PASSED 100%

Document preview thumbnail
Preview 2 out of 7 pages

NICET LEVEL 1 EXAM QUESTIONS & UPDATED CORRECT ANSWERS PASSED 100% typically refers to training designed to help candidates prepare for NICET certification exams in various engineering technology and technical fields.

Content preview

NICET LEVEL 1 EXAM QUESTIONS &
UPDATED CORRECT ANSWERS
PASSED 100%
what is the maximum number of 14 AWG RHH conductors which can be installed in 1/2
rigid metal conduit? - Correct Answer ✔✔ 4 wires

Which of the following would be an appropriate mounting height for a pull station? -
Correct Answer ✔✔ 3.5'-48" to the actuator

What is the minimum flash rate for a visible notification device? - Correct Answer ✔✔ 1
flash per second

What is the minimum mounting height for audible notification devices? - Correct Answer
✔✔ 90" to the top of the device

What is the minimum mounting height for visible notification devices? - Correct Answer
✔✔ Such that the entire lens is not less then 80"

What is the formula for Ohm's Law - Correct Answer ✔✔ Voltage=Current X Resistence

When using your mult-meter to measure, you must: - Correct Answer ✔✔ Put your
meter in series with the circuit

Waterflow devices shall be tested with that frequency? - Correct Answer ✔✔ Semi-
annually

With what frequency shall ionization smoke detectors be given a functional test? -
Correct Answer ✔✔ Annually

What are the standby power requirements for a proprietary signaling system? - Correct
Answer ✔✔ 24 hours in normal operation, 5 minutes in alarm

Which of the following is a type of auxiliary protective signaling system? - Correct
Answer ✔✔ Shunt type

Remote station signaling systems are permitted to send signals to: - Correct Answer
✔✔ A UL listed central station
A receiver located at an unlisted monitoring facility
A fire department or communications center

, Non-power limited fire alarm cable shall have an insulation rating of: - Correct Answer
✔✔ 600V

Which of these HVAC systems would require duct detectors on supply and return? -
Correct Answer ✔✔ 20,000 CFM HVAC system serving a single floor
15,000 CFM HVAC system serving 3 floors
20,000 CFM HVAC system serving 2 floors

According to the IBC, which of the following use Groups require visual notification? -
Correct Answer ✔✔ Group A, E, F

Digital Alarm communicator transmitters (DACT) which use call forwarding to the DACR
shall be tested with what frequency? - Correct Answer ✔✔ Every 4 hours

When connecting 4 wires smoke detectors to a fire alarm system, the power conductors
shall be monitored for integrity. - Correct Answer ✔✔ True

Which of the following is true regarding smoke detector spacing? - Correct Answer ✔✔
Smoke detectors shall be permitted to use 30 foot spacing as a guide

A slope ceiling is defined as: - Correct Answer ✔✔ A slope of greater than 1 in 8

Which of the following is true? - Correct Answer ✔✔ Fire alarm control equipment shall
be protected with an automatic detector when not in continuously occupied areas
Positive alarm sequence requires the approval of the AHJ
FPLP cable may be substituted with CMP cable

For sprinkler systems what type of signal is fire pump running? - Correct Answer ✔✔
Alarm signal
Trouble signal

consider a fire alarm system with primary power source as commercial light power. what
type of branch circuit is permitted to supply the fire alarm system? - Correct Answer ✔✔
A dedicated branch circuit

what is type of meter is typically used to measure current in a fire alarm system -
Correct Answer ✔✔ Multimeter

where an auxiliary fire alarm system uses a shunt loop, it shall not exceed a length of
_______feets. - Correct Answer ✔✔ 750 feets

software information and as built drawing shall be maintained for the life of the system
by which of the following? - Correct Answer ✔✔ Building Owner

what is the wire resistance in ohms of 500 feets of 16 awg solid copper which is coated
at 75 degrees C? - Correct Answer ✔✔ 2.54 ohms

Document information

Uploaded on
June 11, 2026
Number of pages
7
Written in
2025/2026
Type
Exam (elaborations)
Contains
Questions & answers
£9.47

Wrong document? Swap it for free Within 14 days of purchase and before downloading, you can choose a different document. You can simply spend the amount again.
Written by students who passed
Immediately available after payment
Read online or as PDF

Seller avatar
Reputation scores are based on the amount of documents a seller has sold for a fee and the reviews they have received for those documents. There are three levels: Bronze, Silver and Gold. The better the reputation, the more your can rely on the quality of the sellers work.
STUVIA2024
3.5
(4)
Sold
28
Followers
0
Items
7400
Last sold
8 hours ago




Why students choose Stuvia

Created by fellow students, verified by reviews

Quality you can trust: written by students who passed their exams and reviewed by others who've used these revision notes.

Didn't get what you expected? Choose another document

No problem! You can straightaway pick a different document that better suits what you're after.

Pay as you like, start learning straight away

No subscription, no commitments. Pay the way you're used to via credit card and download your PDF document instantly.

Student with book image

“Bought, downloaded, and smashed it. It really can be that simple.”

Alisha Student

Working on your references?

Create accurate citations in APA, MLA and Harvard with our free citation generator.

Working on your references?

Frequently asked questions