ICC Vapor Recovery 1| 60 Questions| With Complete Solutions
Which of the following is not considered "hanging The three elements in a fire triangle are ____?
hardware"?
A. oxygen, fuel, & LEL
a. nozzle B. fuel, fire, & carbon dioxide
b. swivel C. fuel, oxygen, & ignition source
c. whip hose D. ignition source, carbon dioxide, & fuel -
d. shear valve - ANSWER -d. shear valve ANSWER -C. fuel, oxygen, & ignition
source
Per Executive Order. VR-201-E, if the dispensing
vacuum of the Healy VP-1000 pump is below According to PEI RP-300, a combustible gas
____ inches of WC, the dispenser should be indicator is used to?
removed from service.
A. determine carbon dioxide levels
A. 50 B. monitor benzene, toluene, & ethyl benzene
B. 60 levels
C. 75 C. determine the (UEL) upper explosion limit of
D. 100 - ANSWER -B. 60 gasoline
D. detect vapor leaks in the vapor recovery
system - ANSWER -D. detect vapor leaks in
the vapor recovery system
In a coaxial hose for a balance system, the
product flows through the ____?
A. the belllows Per CP-201, liquid traps in the dispenser vapor
B. the inner hose piping are:
C. the outer hose
D. both hoses - ANSWER -B. the inner A. Not allowed
hose B. Allowed only with an assist system
C. Allowed if approved by CARB
D. Allowed when hoses with liquid removal
systems are used
Per the Vapor Recovery Equipment Defects List E. detect vapor leaks in the vapor recovery
(VRED), the ____ of any component required to system - ANSWER -A. Not allowed
be used by the system's EO. Is not considered a
defect.
A. absence Which of the following is not an overfill device?
B. proper installation
C. disconnection A. ball-float
D. improper installation - ANSWER -B. B. spill-bucket
proper installation C. tank overfill alarm
D. drop-tube flapper valve - ANSWER -B.
spill-bucket
, ICC Vapor Recovery 1| 60 Questions| With Complete Solutions
A. 80
Piping should have a minimum and maximum B. 90
slope of ____ inch C. 95
D. 75 - ANSWER -C. 95
A. 1/16"-1/8"
B. 1/8"-1/4"
C. 1/8"-3/16"
D. 1/4"-1/2" - ANSWER -B. 1/8"-1/4" In the PEI #300 manual, pressure decay,
dynamic back pressure, and A/L testing satisfy
who's testing requirements?
What is the appropriate way to clean up a small A. CARB
spill of gasoline? B. water resources
C. environmental health
A. allow the product to evaporate from the area D. fire department - ANSWER -A. CARB
B. wash the spilled product from the area with
water
C. apply absorbent to the affected area and
leave to soak up fuel When removing liquid from a sump or spill bucket
D. apply absorbent to the affected area, then and the liquid contains fuel, it must ____?
remove & dispose of absorbent in accordance
with applicable requirements - ANSWER - A. be managed as hazardous waste
D. apply absorbent to the affected area, then B. pumped into a bucket to evaporate
remove & dispose of absorbent in accordance C. scooped or bailed onto the concrete pad to
with applicable requirements evaporate
D. put into a sealed container, then put into the
trash container - ANSWER -A. be managed
as hazardous waste
Placing a bare copper wire from the ____ to the
____ with it's ends exposed is helpful with pipe
run locating.
Before working on any electrical circuits always
A. tank monitor to emergency shut-off switch de-energize and use
B. tank to turbine
C. vapor recovery bucket to interstitial monitor A. NFPA
D. dispenser pipe run to the tank turbine - B. OSHA
ANSWER -D. dispenser pipe run to the C. ICC
tank turbine D. UBC - ANSWER -A. NFPA
One of the approved methods of overfill The two point Phase I vapor recovery system
prevention is to have an overfill device that will requires that a separate vapor recovery riser pipe
automatically shut off fill into the tank when the be installed in the tank and be equipped with a
tank is a maximum of ____ % full. ____?
Which of the following is not considered "hanging The three elements in a fire triangle are ____?
hardware"?
A. oxygen, fuel, & LEL
a. nozzle B. fuel, fire, & carbon dioxide
b. swivel C. fuel, oxygen, & ignition source
c. whip hose D. ignition source, carbon dioxide, & fuel -
d. shear valve - ANSWER -d. shear valve ANSWER -C. fuel, oxygen, & ignition
source
Per Executive Order. VR-201-E, if the dispensing
vacuum of the Healy VP-1000 pump is below According to PEI RP-300, a combustible gas
____ inches of WC, the dispenser should be indicator is used to?
removed from service.
A. determine carbon dioxide levels
A. 50 B. monitor benzene, toluene, & ethyl benzene
B. 60 levels
C. 75 C. determine the (UEL) upper explosion limit of
D. 100 - ANSWER -B. 60 gasoline
D. detect vapor leaks in the vapor recovery
system - ANSWER -D. detect vapor leaks in
the vapor recovery system
In a coaxial hose for a balance system, the
product flows through the ____?
A. the belllows Per CP-201, liquid traps in the dispenser vapor
B. the inner hose piping are:
C. the outer hose
D. both hoses - ANSWER -B. the inner A. Not allowed
hose B. Allowed only with an assist system
C. Allowed if approved by CARB
D. Allowed when hoses with liquid removal
systems are used
Per the Vapor Recovery Equipment Defects List E. detect vapor leaks in the vapor recovery
(VRED), the ____ of any component required to system - ANSWER -A. Not allowed
be used by the system's EO. Is not considered a
defect.
A. absence Which of the following is not an overfill device?
B. proper installation
C. disconnection A. ball-float
D. improper installation - ANSWER -B. B. spill-bucket
proper installation C. tank overfill alarm
D. drop-tube flapper valve - ANSWER -B.
spill-bucket
, ICC Vapor Recovery 1| 60 Questions| With Complete Solutions
A. 80
Piping should have a minimum and maximum B. 90
slope of ____ inch C. 95
D. 75 - ANSWER -C. 95
A. 1/16"-1/8"
B. 1/8"-1/4"
C. 1/8"-3/16"
D. 1/4"-1/2" - ANSWER -B. 1/8"-1/4" In the PEI #300 manual, pressure decay,
dynamic back pressure, and A/L testing satisfy
who's testing requirements?
What is the appropriate way to clean up a small A. CARB
spill of gasoline? B. water resources
C. environmental health
A. allow the product to evaporate from the area D. fire department - ANSWER -A. CARB
B. wash the spilled product from the area with
water
C. apply absorbent to the affected area and
leave to soak up fuel When removing liquid from a sump or spill bucket
D. apply absorbent to the affected area, then and the liquid contains fuel, it must ____?
remove & dispose of absorbent in accordance
with applicable requirements - ANSWER - A. be managed as hazardous waste
D. apply absorbent to the affected area, then B. pumped into a bucket to evaporate
remove & dispose of absorbent in accordance C. scooped or bailed onto the concrete pad to
with applicable requirements evaporate
D. put into a sealed container, then put into the
trash container - ANSWER -A. be managed
as hazardous waste
Placing a bare copper wire from the ____ to the
____ with it's ends exposed is helpful with pipe
run locating.
Before working on any electrical circuits always
A. tank monitor to emergency shut-off switch de-energize and use
B. tank to turbine
C. vapor recovery bucket to interstitial monitor A. NFPA
D. dispenser pipe run to the tank turbine - B. OSHA
ANSWER -D. dispenser pipe run to the C. ICC
tank turbine D. UBC - ANSWER -A. NFPA
One of the approved methods of overfill The two point Phase I vapor recovery system
prevention is to have an overfill device that will requires that a separate vapor recovery riser pipe
automatically shut off fill into the tank when the be installed in the tank and be equipped with a
tank is a maximum of ____ % full. ____?
