• Falsches Dokument? Kostenlos tauschen
  • Geschrieben von Student*innen, die bestanden haben
  • Sofort verfügbar nach Zahlung
  • Online lesen oder als PDF
Verkaufen
Wo studierst du
Deine Sprache
Document preview thumbnail
Vorschau 2 aus 11 Seiten
Prüfung

HVAC: EPA 608 Certification Study Guide Updated 2025 with complete solution

Document preview thumbnail
Vorschau 2 aus 11 Seiten

Recover - to remove any refrigerant in any condition from system and store in external container without necessarily testing or processing in any way What are the leak repair requirements for comfort cooling appliances and commercial appliances containing 50 pounds or more of refrigerant? - The leak rate exceeds 15% in comfort cooling appliances How does a centrifugal purge unit work? - A centrifugal purge unit takes its suction from the top of the condenser, removes the air from the system, and returns the refrigerant to the evaporator. Does refrigerant go out of the system in low pressure or does air and moisture go in? Why? - A low-pressure system operates in a vacuum (below atmospheric pressure) to enter the refrigeration system. ASHRAE Standard 15-1994 - Requires refrigerant sensor that will sound alarm and automatically start ventilation system in occupied equipment rooms where refrigerant from leak will concentrate At what point in the system should you charge a low pressure system and what should you start the charge with? - Charge through the evaporator charging valve as this is the lowest point on a low pressure system. First charge the system with vapor until the refrigeration saturation temperature reaches 36 degrees F or the vapor pressure reaches 16.9" Hg vacuum Bubble Point - Occurs when saturation temp in condenser changes refrigerant from vapor to liquid Compound Gauge - Typically blue and measures low pressure (psig) and vacuum (inHg). Compressor - Takes low pressure, low temp vapor and changes it to a high-temp, high-pressure, superheated vapor and delivers it to the condenserCondenser - Rejects heat from system and changes refrigerant from high-temp, high-pressure vapor into high-pressure, high-temp liquid Describe two ways to speed up recovery - Pack the recovery cylinder in ice and/or apply heat to the appliance. Recover as much as possible in the liquid phase. Dew Point - Occurs when saturation temp in evaporator causes refrigerant to change from liquid to vapor Evaporator - Absorbs heat into system from space to be cooled. Absorption of heat causes refrigerant to boil. Upon leaving, refrigerant changed to low pressure, low temperature vapor Find pressure for R-22 at 70 degree F. - 121.4 psi Find the pressure for R-12 at 80 degrees F. - 84.4 psi Foaming at start-up may be found in what component? What does this mean? - Refrigerant in the oil will cause oil foaming in the compressor at start-up High Pressure Gauge - Red and measures high side (discharge) pressure. 0 to 500 psi How can you check if a tank contains excess air or non-condensables? - Check pressure inside recovery tank after allowing temp of cylinder to stabilize to room temperature After removal of liquid, about how much vapor will remain in the system on a 350 ton R-11 chiller? - 100lbs How can you release trapped refrigerants in the oil? - Necessary to heat and tap compressor with mallet several times or use vacuum pump How can you speed up the vapor recovery process on Type III systems? - A heater on the recovery vessel side will help evacuate the vapor fasterHow many inches of mercury vacuum is required for HCFC-22 appliances containing more than 200lbs. of refrigerant using equipment after Nov. 15th, 1993. - 0 Inches Hg How must you recover refrigerant from a parallel system? Why? - Isolate a parallel compressor system in order to recover refrigerant. Failure to isolate a parallel compressor system will cause an open equalization that will prevent refrigerant recovery

Inhaltsvorschau

HVAC: EPA 608 Certification Study
Guide
Recover - to remove any refrigerant in any condition from system and store in external container
without necessarily testing or processing in any way



What are the leak repair requirements for comfort cooling appliances and commercial appliances
containing 50 pounds or more of refrigerant? - The leak rate exceeds 15% in comfort cooling
appliances



How does a centrifugal purge unit work? - A centrifugal purge unit takes its suction from the top
of the condenser, removes the air from the system, and returns the refrigerant to the evaporator.



Does refrigerant go out of the system in low pressure or does air and moisture go in? Why? - A
low-pressure system operates in a vacuum (below atmospheric pressure) to enter the refrigeration
system.



ASHRAE Standard 15-1994 - Requires refrigerant sensor that will sound alarm and automatically
start ventilation system in occupied equipment rooms where refrigerant from leak will concentrate



At what point in the system should you charge a low pressure system and what should you start the
charge with? - Charge through the evaporator charging valve as this is the lowest point on a low
pressure system. First charge the system with vapor until the refrigeration saturation temperature
reaches 36 degrees F or the vapor pressure reaches 16.9" Hg vacuum



Bubble Point - Occurs when saturation temp in condenser changes refrigerant from vapor to liquid



Compound Gauge - Typically blue and measures low pressure (psig) and vacuum (inHg).



Compressor - Takes low pressure, low temp vapor and changes it to a high-temp, high-pressure,
superheated vapor and delivers it to the condenser

, Condenser - Rejects heat from system and changes refrigerant from high-temp, high-pressure
vapor into high-pressure, high-temp liquid



Describe two ways to speed up recovery - Pack the recovery cylinder in ice and/or apply heat to
the appliance. Recover as much as possible in the liquid phase.



Dew Point - Occurs when saturation temp in evaporator causes refrigerant to change from liquid
to vapor



Evaporator - Absorbs heat into system from space to be cooled. Absorption of heat causes
refrigerant to boil. Upon leaving, refrigerant changed to low pressure, low temperature vapor



Find pressure for R-22 at 70 degree F. - 121.4 psi



Find the pressure for R-12 at 80 degrees F. - 84.4 psi



Foaming at start-up may be found in what component? What does this mean? - Refrigerant in the
oil will cause oil foaming in the compressor at start-up



High Pressure Gauge - Red and measures high side (discharge) pressure. 0 to 500 psi



How can you check if a tank contains excess air or non-condensables? - Check pressure inside
recovery tank after allowing temp of cylinder to stabilize to room temperature

After removal of liquid, about how much vapor will remain in the system on a 350 ton R-11 chiller? -
100lbs



How can you release trapped refrigerants in the oil? - Necessary to heat and tap compressor with
mallet several times or use vacuum pump



How can you speed up the vapor recovery process on Type III systems? - A heater on the recovery
vessel side will help evacuate the vapor faster

Dokument Information

Hochgeladen auf
26. august 2024
Anzahl der Seiten
11
geschrieben in
2024/2025
Typ
Prüfung
Enthält
Fragen & antworten
7,94 €

Falsches Dokument? Kostenlos tauschen Innerhalb von 14 Tagen nach dem Kauf und vor dem Herunterladen kannst du ein anderes Dokument wählen. Du kannst den Betrag einfach neu ausgeben.
Geschrieben von Student*innen, die bestanden haben
Sofort verfügbar nach Zahlung
Online lesen oder als PDF

Seller avatar
Bewertungen des Ansehens basieren auf der Anzahl der Dokumente, die ein Verkäufer gegen eine Gebühr verkauft hat, und den Bewertungen, die er für diese Dokumente erhalten hat. Es gibt drei Stufen: Bronze, Silber und Gold. Je besser das Ansehen eines Verkäufers ist, desto mehr kannst du dich auf die Qualität der Arbeiten verlassen.
ACADEMICMATERIALS
4,0
(101)
Verkauft
631
Anhänger
185
Sachen
10503
Zuletzt verkauft
2 Jahren vor



Warum sich Studierende für Stuvia entscheiden

on Mitstudent*innen erstellt, durch Bewertungen verifiziert

Geschrieben von Student*innen, die bestanden haben und bewertet von anderen, die diese Studiendokumente verwendet haben.

Nicht zufrieden? Wähle ein anderes Dokument

Kein Problem! Du kannst direkt ein anderes Dokument wählen, das besser zu dem passt, was du suchst.

Bezahle wie du möchtest, fange sofort an zu lernen

Kein Abonnement, keine Verpflichtungen. Bezahle wie gewohnt per Kreditkarte oder Sofort und lade dein PDF-Dokument sofort herunter.

Student with book image

“Gekauft, heruntergeladen und bestanden. So einfach kann es sein.”

Alisha Student

Arbeitest du an deiner Quellenangabe?

Erstelle korrekte Quellenangaben in APA, MLA und Harvard mit unserem kostenlosen Zitiergenerator.

Arbeitest du an deiner Quellenangabe?

Häufig gestellte Fragen