Page 1 of 9
NEIEP 100 FINAL EXAMS (LATEST 2025 UPDATES
STUDY BUNDLE WITH COMPLETE SOLUTIONS)
QUESTIONS AND VERIFIED ANSWERS | 100%
CORRECT | GRADE A
How to turn Kg to Lbs .....ANSWER.....Multiply by 2.2
How to turn Lbs to Kg .....ANSWER.....Divide by 2.2
Wheat types of detail drawings would you expect to see on a
elevator installation job .....ANSWER.....Standardized, electrical,
structural and hoistway drawings
Installing hoistway limit switches what drawing will the mechanic
reference .....ANSWER.....Standardized detail drawing
Where should you place a lifeline when installing them
.....ANSWER.....close enough to permit tying off prior to entering
millimeters to inches .....ANSWER.....divide by 25.4
Inches to millimeters .....ANSWER.....multiply by 25.4
, Page 2 of 9
Drawings that are approved by the building owner or
representative are labeled with what term .....ANSWER.....Final
In a standard orthographic projection drawing, where is the
placement of a back view if needed .....ANSWER.....Off to one
side of the working drawing
What is the most common drawing method for showing three
sides of an object at once in the elevator industry
.....ANSWER.....Isometric Drawing
How would you describe a class 3 fit for shaft and bore
diameters .....ANSWER.....Snuggest possible allowance
Which class of bolts provides the highest level of precision
.....ANSWER.....Class 3 bolts
What is the difference between U.S standard and metric
standard threads? .....ANSWER.....U.S. standard measures threads
per inch; metric standard measures by pitch of the threads
NEIEP 100 FINAL EXAMS (LATEST 2025 UPDATES
STUDY BUNDLE WITH COMPLETE SOLUTIONS)
QUESTIONS AND VERIFIED ANSWERS | 100%
CORRECT | GRADE A
How to turn Kg to Lbs .....ANSWER.....Multiply by 2.2
How to turn Lbs to Kg .....ANSWER.....Divide by 2.2
Wheat types of detail drawings would you expect to see on a
elevator installation job .....ANSWER.....Standardized, electrical,
structural and hoistway drawings
Installing hoistway limit switches what drawing will the mechanic
reference .....ANSWER.....Standardized detail drawing
Where should you place a lifeline when installing them
.....ANSWER.....close enough to permit tying off prior to entering
millimeters to inches .....ANSWER.....divide by 25.4
Inches to millimeters .....ANSWER.....multiply by 25.4
, Page 2 of 9
Drawings that are approved by the building owner or
representative are labeled with what term .....ANSWER.....Final
In a standard orthographic projection drawing, where is the
placement of a back view if needed .....ANSWER.....Off to one
side of the working drawing
What is the most common drawing method for showing three
sides of an object at once in the elevator industry
.....ANSWER.....Isometric Drawing
How would you describe a class 3 fit for shaft and bore
diameters .....ANSWER.....Snuggest possible allowance
Which class of bolts provides the highest level of precision
.....ANSWER.....Class 3 bolts
What is the difference between U.S standard and metric
standard threads? .....ANSWER.....U.S. standard measures threads
per inch; metric standard measures by pitch of the threads
