1|Page
Septic License Exam Version 2 Newest 2026 Complete
All 100 Questions And Correct Detailed Answers
(Verified Answers) |Already Graded A+||Newest
Version!!!!
All tanks must have: - Answer-2 compartments
All tanks whether pre-manufactured or constructed on site
shall be constructed so that the length is ___________
compared to the width. - Answer-at least one and one- half
(1 1/2) times... "to the width."
Septic Tanks may be made of: - Answer-Concrete, Plastic,
fiberglass, or other materials as approved by the
department.
Tank compartment partitions will be located: - Answer-Not
less than two-thirds or more than three-fourths the Length
of the tank from the Inlet end.
Compartment partitions will be constructed so a pass-thru
hole or slot equal to or greater than the diameter of the
inlet pipe is positioned below the liquid surface with a
, 2|Page
_____________________________. - Answer-Minimum
25% to a maximum of 50% of the total liquid depth.
Total liquid depth for larger poured-in-place tanks shall
have a maximum of ______________inches - Answer-66
inches
True or False: Walls and bottom of poured-in-place septic
tanks must be reinforced. - Answer-True
How can a Septic tank be reinforced? - Answer-six inch by
6 inch (6"x6") No.10 gage welded steel reinforcing wire
OR fibrous reinforcing material conforming to ASTM
specifications for such materials.
How must Tank Lids be Reinforced? - Answer-using three-
eights steel reinforcing rods (rebar) which shall be spaced
twelve inches (12") on center each way extending a
minimum of two and one half (2 1/2") inches and a
maximum of three (3") from the outside edge of the tank
lid.
Septic License Exam Version 2 Newest 2026 Complete
All 100 Questions And Correct Detailed Answers
(Verified Answers) |Already Graded A+||Newest
Version!!!!
All tanks must have: - Answer-2 compartments
All tanks whether pre-manufactured or constructed on site
shall be constructed so that the length is ___________
compared to the width. - Answer-at least one and one- half
(1 1/2) times... "to the width."
Septic Tanks may be made of: - Answer-Concrete, Plastic,
fiberglass, or other materials as approved by the
department.
Tank compartment partitions will be located: - Answer-Not
less than two-thirds or more than three-fourths the Length
of the tank from the Inlet end.
Compartment partitions will be constructed so a pass-thru
hole or slot equal to or greater than the diameter of the
inlet pipe is positioned below the liquid surface with a
, 2|Page
_____________________________. - Answer-Minimum
25% to a maximum of 50% of the total liquid depth.
Total liquid depth for larger poured-in-place tanks shall
have a maximum of ______________inches - Answer-66
inches
True or False: Walls and bottom of poured-in-place septic
tanks must be reinforced. - Answer-True
How can a Septic tank be reinforced? - Answer-six inch by
6 inch (6"x6") No.10 gage welded steel reinforcing wire
OR fibrous reinforcing material conforming to ASTM
specifications for such materials.
How must Tank Lids be Reinforced? - Answer-using three-
eights steel reinforcing rods (rebar) which shall be spaced
twelve inches (12") on center each way extending a
minimum of two and one half (2 1/2") inches and a
maximum of three (3") from the outside edge of the tank
lid.
