ICC Vapor Recovery – VT 2025/2026
Exam Questions and Verified Answers |
Already Graded A+
Type of sealant you should you use on a Phil-Tite Ball Float nipple: - 🧠
ANSWER ✔✔Pipe dope
Number of open valves on the clean air separator: - 🧠 ANSWER ✔✔One
You must be CERTIFIED by Healy to re-connect a Healy breakaway, True
or False? - 🧠 ANSWER ✔✔False
The type of pressure gauge is recommended to test Healy Vac - 🧠
ANSWER ✔✔SYSA gauge measuring 0-100 WC
On new construction, after July 1, 2004, Can you install an in-ground Spill
Bucket? - 🧠 ANSWER ✔✔YES-When Piping is monitored and with VAC
,According to Executive Order 201 - Healy P/V Valve should be torqued at -
🧠 ANSWER ✔✔20-50 ft-lbs
For a fire to burn, these (3) three primary elements must exist: - 🧠
ANSWER ✔✔Fuel, Oxygen, Ignition Source
When working with Electrical - Lock Out Tag Out procedures are under
these guidelines. - 🧠 ANSWER ✔✔CAL-OSHA
Organization that certifies vapor recovery systems. - 🧠 ANSWER ✔✔CARB
or ARB
According to RP 500, a level II technician may NOT inspect this part. - 🧠
ANSWER ✔✔Replace VP 1000 Healy Pump
where hanging hardware repairs must be tracked. - 🧠 ANSWER ✔✔GDF
maintenance log
approved sealant when assembling a Phil-Tite Drop Tube. - 🧠 ANSWER
✔✔JB-Kwik
Material direct bury OPW container sleeve shall be made of. - 🧠 ANSWER
✔✔Stainless steel
, What P/V vent cap shall be tightened to. - 🧠 ANSWER ✔✔20-50 ft lbs
From dispenser to manifold - 2" diameter vapor piping ( 2" ID) and From
manifold to tank - 3" diameter vapor piping (3" ID) - 🧠 ANSWER ✔✔Vapor
piping
What is the maximum run for vapor piping? - 🧠 ANSWER ✔✔No maximum
run
How you know a nozzle spout is bad. - 🧠 ANSWER ✔✔'BAD O-rinqs
According to PEI RP 300, on a balance Stage II vapor recovery system
nozzle, Vapors typically flow in what direction of the coaxial hose? - 🧠
ANSWER ✔✔The outside pathway
What is the maximum allowable number of P/V caps allowed on a UST fuel
system? - 🧠 ANSWER ✔✔One
On a Healy Air Separator, there are four Ball Valves, the following shall be
observed? - 🧠 ANSWER ✔✔One valve shall remain open on top
The Pressure settings for the UST Vent Cap is. - 🧠 ANSWER ✔✔.0+-
0.5inches H2O Negative Pressure 1,0+-2.0 inches H2O Positive Pressure
COPYRIGHT©PROFFKERRYMARTIN 2025/2026. YEAR PUBLISHED 2025. COMPANY REGISTRATION NUMBER: 619652435. TERMS OF USE.
PRIVACY STATEMENT. ALL RIGHTS RESERVED
Exam Questions and Verified Answers |
Already Graded A+
Type of sealant you should you use on a Phil-Tite Ball Float nipple: - 🧠
ANSWER ✔✔Pipe dope
Number of open valves on the clean air separator: - 🧠 ANSWER ✔✔One
You must be CERTIFIED by Healy to re-connect a Healy breakaway, True
or False? - 🧠 ANSWER ✔✔False
The type of pressure gauge is recommended to test Healy Vac - 🧠
ANSWER ✔✔SYSA gauge measuring 0-100 WC
On new construction, after July 1, 2004, Can you install an in-ground Spill
Bucket? - 🧠 ANSWER ✔✔YES-When Piping is monitored and with VAC
,According to Executive Order 201 - Healy P/V Valve should be torqued at -
🧠 ANSWER ✔✔20-50 ft-lbs
For a fire to burn, these (3) three primary elements must exist: - 🧠
ANSWER ✔✔Fuel, Oxygen, Ignition Source
When working with Electrical - Lock Out Tag Out procedures are under
these guidelines. - 🧠 ANSWER ✔✔CAL-OSHA
Organization that certifies vapor recovery systems. - 🧠 ANSWER ✔✔CARB
or ARB
According to RP 500, a level II technician may NOT inspect this part. - 🧠
ANSWER ✔✔Replace VP 1000 Healy Pump
where hanging hardware repairs must be tracked. - 🧠 ANSWER ✔✔GDF
maintenance log
approved sealant when assembling a Phil-Tite Drop Tube. - 🧠 ANSWER
✔✔JB-Kwik
Material direct bury OPW container sleeve shall be made of. - 🧠 ANSWER
✔✔Stainless steel
, What P/V vent cap shall be tightened to. - 🧠 ANSWER ✔✔20-50 ft lbs
From dispenser to manifold - 2" diameter vapor piping ( 2" ID) and From
manifold to tank - 3" diameter vapor piping (3" ID) - 🧠 ANSWER ✔✔Vapor
piping
What is the maximum run for vapor piping? - 🧠 ANSWER ✔✔No maximum
run
How you know a nozzle spout is bad. - 🧠 ANSWER ✔✔'BAD O-rinqs
According to PEI RP 300, on a balance Stage II vapor recovery system
nozzle, Vapors typically flow in what direction of the coaxial hose? - 🧠
ANSWER ✔✔The outside pathway
What is the maximum allowable number of P/V caps allowed on a UST fuel
system? - 🧠 ANSWER ✔✔One
On a Healy Air Separator, there are four Ball Valves, the following shall be
observed? - 🧠 ANSWER ✔✔One valve shall remain open on top
The Pressure settings for the UST Vent Cap is. - 🧠 ANSWER ✔✔.0+-
0.5inches H2O Negative Pressure 1,0+-2.0 inches H2O Positive Pressure
COPYRIGHT©PROFFKERRYMARTIN 2025/2026. YEAR PUBLISHED 2025. COMPANY REGISTRATION NUMBER: 619652435. TERMS OF USE.
PRIVACY STATEMENT. ALL RIGHTS RESERVED
