Escrito por estudiantes que aprobaron Inmediatamente disponible después del pago Leer en línea o como PDF ¿Documento equivocado? Cámbialo gratis 4,6 TrustPilot
logo-home
Document preview thumbnail
Vista previa 2 fuera de 9 páginas
Examen

ASE - Auto Maintenance and Light Repair Study Guide Questions and An- swers

Document preview thumbnail
Vista previa 2 fuera de 9 páginas

ASE - Auto Maintenance and Light Repair Study Guide Questions and An- swers

Vista previa del contenido

ASE - Auto Maintenance and Light Repair Study Guide Questions and An
swers
Study online at https://quizlet.com/_i3iham
1. Technician A says that when pressure testing a radiator cap, a special adapter
is needed. Technician B says the best way to check thermostat operation is
while it is in the engine. Who is right?: Tech A
2. A technician is checking resistance in an engine's spark plug wires using an
ohmmeter. A general rule is to replace a wire if resistance is over:: 30,000 ohms
3. Technician A says that in an ignition system, the voltage supplied to the coil
during starting is battery voltage. Technician B says the coil uses electromag-
netic induction to create high voltage. Who is right?: Both techs
4. A front wheel drive vehicle with an automatic transaxle has excessive vi-
bration. Technician A says that the vibration could be caused by worn en-
gine/transaxle mounts. Technician B says that the vibration could be caused
by a misaligned engine/transaxle subframe. Who is right?: Both techs
5. A technician suspects that a faulty camshaft sensor causes a driveability
complaint. The sensor is equipped with a three-wire connector. What type of
sensor is this?: a Hall effect type
6. All of the following can cause a problem in the Hydro-boost system EXCEPT:
A. loose power steering pump belt
B. leaking power steering hoses
C. low power steering pump pressure
D. leaking check valve: D
7. Technician A says that if a wire is getting too hot, it's a sign of higher-than-nor-
mal current flowing through. Technician B says the wire would heat up if some
of the individual strands are broken inside the wire insulation. Who is right?: Both
techs
8. Technician A says electrical connectors can be disconnected with the ignition
switch ON, as long as the technician is using a ground strap. Technician B says
when welding on a vehicle, the technician needs to use a static wrist strap. Who
is right?: Neither
9. Technician A says the thermostat maintains maximum engine operating tem-
perature. Technician B says if the engine continuously runs hot, install a cooler
thermostat. Who is right?: Neither
1/9

, ASE - Auto Maintenance and Light Repair Study Guide Questions and An
swers
Study online at https://quizlet.com/_i3iham
10. A vehicle equipped with a MacPherson strut suspension is in the repair shop
for new tires and an alignment. The technician noticed that the vehicle has
some play in the lift-side inner tie-rod. What should the technician tell the
customer?
A. It is not a problem that will affect alignment.
B. He can align the front end, but the tie-rod should be replaced soon
C. The inner tie-rod needs to be replaced before an alignment can be per-
formed
D. He can set the vehicle alignment to compensate for the play in the inner
tie-rod: C.
11. An engine is losing coolant, yet has no external leaks. Technician A says to
run the engine and see if there is white smoke out of the exhaust. Technician
B says to find out if the engine's emission system uses a catalytic converter
before running the test above. Who is right?: both
12. LED bulbs can remain effective for up to how long depending on the size of
the bulb and the conditions to which the bulb is exposed?: 15000 hours
13. All of the following should be performed during a preliminary transmission
inspection EXCEPT:
A. check transmission fluid level
B. visually check wiring and electrical connections
C. check the condition of the filter
D. check for fluid leaks: C
14. A smeary film on the windshield is an indication of:
A. evaporator core leak
B. water valve leak
C. heater core leak
D. restricted drain hose: C
15. Technician A says that all power should be removed from a circuit before
testing the circuit with an ammeter. Technician B says that all power should
be removed from a circuit before testing the circuit with an ohmmeter. Who is
right?: Tech B
2/9

Información del documento

Subido en
18 de octubre de 2025
Número de páginas
9
Escrito en
2025/2026
Tipo
Examen
Contiene
Preguntas y respuestas
$12.99

¿Documento equivocado? Cámbialo gratis Dentro de los 14 días posteriores a la compra y antes de descargarlo, puedes elegir otro documento. Puedes gastar el importe de nuevo.
Escrito por estudiantes que aprobaron
Inmediatamente disponible después del pago
Leer en línea o como PDF

Seller avatar
Los indicadores de reputación están sujetos a la cantidad de artículos vendidos por una tarifa y las reseñas que ha recibido por esos documentos. Hay tres niveles: Bronce, Plata y Oro. Cuanto mayor reputación, más podrás confiar en la calidad del trabajo del vendedor.
BrittieDonald
3.4
(101)
Vendido
460
Seguidores
162
Artículos
22019
Última venta
2 días hace



Por qué los estudiantes eligen Stuvia

Creado por compañeros estudiantes, verificado por reseñas

Calidad en la que puedes confiar: escrito por estudiantes que aprobaron y evaluado por otros que han usado estos resúmenes.

¿No estás satisfecho? Elige otro documento

¡No te preocupes! Puedes elegir directamente otro documento que se ajuste mejor a lo que buscas.

Paga como quieras, empieza a estudiar al instante

Sin suscripción, sin compromisos. Paga como estés acostumbrado con tarjeta de crédito y descarga tu documento PDF inmediatamente.

Student with book image

“Comprado, descargado y aprobado. Así de fácil puede ser.”

Alisha Student

Preguntas frecuentes