ABYC Electrical Workbook
Study online at https://quizlet.com/_dyc2mw
1. The minimum amp circuit breaker that should be used 15 Amps
to protect a |20V water heater circuit with a
1600-watt element would be rated at
amps.
2. When testing for excessive EMF emission near a con- Gauss meter
ductor or appliance, the tool of choice is a(n):
3. The primary problem with using a series circuit to sup- voltage drop through the
ply multiple loads is that: circuit will be excessive.
4. Based on this section, the most common electrical cir- unwanted open
cuit problem in marine applications is:
5. The primary by-product of excessive electrical resis- Heat
tance is:
6. Excessive electrical resistance can be caused by undersized wire, loose
connections, and corro-
sion
7. Based on what this section has told you, the tool of TDR
choice today for tracing shorted and open circuits is
the:
8. What material is recommended for clamping conduc- Metal
tors over engines and moving machinery according to
ABYC?
9. According to ABC, acceptable minimum clearance for 9 in. (225mm)
routing wire near a dry exhaust section is:
10. 4
1/2
Study online at https://quizlet.com/_dyc2mw
1. The minimum amp circuit breaker that should be used 15 Amps
to protect a |20V water heater circuit with a
1600-watt element would be rated at
amps.
2. When testing for excessive EMF emission near a con- Gauss meter
ductor or appliance, the tool of choice is a(n):
3. The primary problem with using a series circuit to sup- voltage drop through the
ply multiple loads is that: circuit will be excessive.
4. Based on this section, the most common electrical cir- unwanted open
cuit problem in marine applications is:
5. The primary by-product of excessive electrical resis- Heat
tance is:
6. Excessive electrical resistance can be caused by undersized wire, loose
connections, and corro-
sion
7. Based on what this section has told you, the tool of TDR
choice today for tracing shorted and open circuits is
the:
8. What material is recommended for clamping conduc- Metal
tors over engines and moving machinery according to
ABYC?
9. According to ABC, acceptable minimum clearance for 9 in. (225mm)
routing wire near a dry exhaust section is:
10. 4
1/2
