1|Page
P-99 / Low PSI Oil Burner Operator 2025 REAL EXAM
QUESTIONS |MOST TESTED QUESTIONS AND
CORRECT ANSWERS |100% ACCURATE|GET IT
RIGHT!!
All heating, combustion, and cooking equipment shall be provided
-
Acceptance tests: Boilers shall not be placed in operation upon completion of
construction until they have been ____ and an equipment use permit has been
issued by the commissioner. - (ANSWER)Inspected and tested.
Periodic boiler inspections: All boilers shall be inspected at least ____ including
chimney connections. - (ANSWER)Once a year.
Owner's annual statement: The owner of each boiler that is subject to periodic
inspections shall file an annual ____ with the commissioner, specifying the
location of each boiler and arrangement for inspection. - (ANSWER)Written
statement.
What three things must be tested for any fuel burning and storage installation
before the system can be operated? - (ANSWER)(1) Tightness of liquid fuel piping.
(2) Tightness of fuel oil storage tanks.
,2|Page
(3) Tightness of gas distribution piping.
What are instruction cards for oil burning systems? - (ANSWER)Cards giving
complete instructions for care and operation that are permanently located near
the equipment.
Every oil burning installation that is not fully automatic or requires preheating
shall be operated by, or under, the direct supervision of a person holding a ____
issued by the fire commissioner. - (ANSWER)COF
After any fuel burning equipment repair for which a licensed operator is required,
such operator shall also check the repairs and be ____ while the equipment is
started. - (ANSWER)Present.
What is abatement of air contaminants? - (ANSWER)Compliance with the air
pollution control code.
What are the 3 equipment classifications and their temperatures for the products
of combustion at the point of leaving the equipment? - (ANSWER)(1) Low Temp:
600° F or less.
(2) Medium Temp: 600° - 1000° F.
(3) High Temp: 1000° or greater.
, 3|Page
Ventilation shall be capable of providing at least ____ CFM of air for each gallon
of oil per hour required to fire the equipment to gross output. - (ANSWER)36
- -
The use of crankcase refuse oil as fuel-oil is ____. - (ANSWER)Prohibited.
Overflow pipes shall not be smaller in size than the ____ pipe. - (ANSWER)Supply.
Oil is heated in storage tanks by coils using which three possible methods? -
(ANSWER)(1) Low pressure hot water.
(2) Steam
(3) Electric heaters.
A remote control for oil burner is provided to stop what? - (ANSWER)The flow of
oil to any burner.
What are the four safety controls that shall be installed with each automatic
burner? - (ANSWER)(1) Oil temperature.
P-99 / Low PSI Oil Burner Operator 2025 REAL EXAM
QUESTIONS |MOST TESTED QUESTIONS AND
CORRECT ANSWERS |100% ACCURATE|GET IT
RIGHT!!
All heating, combustion, and cooking equipment shall be provided
-
Acceptance tests: Boilers shall not be placed in operation upon completion of
construction until they have been ____ and an equipment use permit has been
issued by the commissioner. - (ANSWER)Inspected and tested.
Periodic boiler inspections: All boilers shall be inspected at least ____ including
chimney connections. - (ANSWER)Once a year.
Owner's annual statement: The owner of each boiler that is subject to periodic
inspections shall file an annual ____ with the commissioner, specifying the
location of each boiler and arrangement for inspection. - (ANSWER)Written
statement.
What three things must be tested for any fuel burning and storage installation
before the system can be operated? - (ANSWER)(1) Tightness of liquid fuel piping.
(2) Tightness of fuel oil storage tanks.
,2|Page
(3) Tightness of gas distribution piping.
What are instruction cards for oil burning systems? - (ANSWER)Cards giving
complete instructions for care and operation that are permanently located near
the equipment.
Every oil burning installation that is not fully automatic or requires preheating
shall be operated by, or under, the direct supervision of a person holding a ____
issued by the fire commissioner. - (ANSWER)COF
After any fuel burning equipment repair for which a licensed operator is required,
such operator shall also check the repairs and be ____ while the equipment is
started. - (ANSWER)Present.
What is abatement of air contaminants? - (ANSWER)Compliance with the air
pollution control code.
What are the 3 equipment classifications and their temperatures for the products
of combustion at the point of leaving the equipment? - (ANSWER)(1) Low Temp:
600° F or less.
(2) Medium Temp: 600° - 1000° F.
(3) High Temp: 1000° or greater.
, 3|Page
Ventilation shall be capable of providing at least ____ CFM of air for each gallon
of oil per hour required to fire the equipment to gross output. - (ANSWER)36
- -
The use of crankcase refuse oil as fuel-oil is ____. - (ANSWER)Prohibited.
Overflow pipes shall not be smaller in size than the ____ pipe. - (ANSWER)Supply.
Oil is heated in storage tanks by coils using which three possible methods? -
(ANSWER)(1) Low pressure hot water.
(2) Steam
(3) Electric heaters.
A remote control for oil burner is provided to stop what? - (ANSWER)The flow of
oil to any burner.
What are the four safety controls that shall be installed with each automatic
burner? - (ANSWER)(1) Oil temperature.
