Smog Review Practice Study Test.

SMOG REVIEW PRACTICE STUDY TEST. 1. 1. Access printer Back of analyzer behind printer door, standard laser- jet printer 2. 2. Check printer settings Check too left hand side of printer for a steady green light 3. 3. Add paper Pull paper drawer from bottom of printer, add print- er, close drawer 4. 4. Power up analyzer Back if analyzer to the left of printer next to power cord. "A" button 5. Access main menu Has "system shutdown" (esc to get there) 6. Explain vehicle inspection selection Emission testing reprint VIR's enter training mode and verify a good rpm signal 7. Explain vehicle diagnostic selection 4 gas analysis OBD manual mode re: trouble codes readiness monitors clear codes verify rpm signal and practice OBD test 8. Explain analyzer maintenance selec- tion Gas calibration and leak check gas calibration or leak check individually status screen data file refresh network diagnostics 9. Explain station manager selection Basic administrative bookkeeping for owner Needs password 12345 10. Explain state audit selection DMV emission lab use only 11. Explain service menu selection For worldwide use 12. Explain system shut down selection Proper way to shut down emission analyzer 13. Explain computer reset and OBD re- set buttons Back of analyzer bottom right, same panel as A but- ton Reboots pc without turning ott analyzer (no warmup lockout) OBDii resets communication between smog ma- chine and car computer 14. Access training mode Vehicle inspection training mode Allows non-licensed technician to practice for prac- tical hands-on test Click on VI 3 training mode