• ¿Documento equivocado? Cámbialo gratis
  • Escrito por estudiantes que aprobaron
  • Inmediatamente disponible después del pago
  • Leer en línea o como PDF
Vender
¿Dónde estudias?
Tu idioma
Document preview thumbnail
Vista previa 3 fuera de 17 páginas
Examen

IAAI CFI Study Questions (2025)

Document preview thumbnail
Vista previa 3 fuera de 17 páginas

IAAI CFI Study Questions (2025)IAAI CFI Study Questions (2025)IAAI CFI Study Questions (2025)

Vista previa del contenido

IAAI CFI Study Questions (2025)



1. Combustible Liquid:A liquid with a flash point ABOVE 100F L L L L L L L L L




2. 12.5: If the current flowing out from an electrical panel is 12.5 amps, and it then
L L L L L L L L L L L L L L L




flows through an electrical load of 1500 watts, what is the amperage of the
L L L L L L L L L L L L L L




remaining current flow of the return circuit?
L L L L L L L




3. 1000: If a hair dryer draws 8.3amps (in a home with 120-volt service), what is the
L L L L L L L L L L L L L L L




wattage?
L




*Power (P) = current (I) x voltage (V) Watts
L L L L L L L L




= amps x volts
L L L L




4. 1987: The year of the first edition of NFPA 1033
L L L L L L L L L




5. 1.5 times: The recommended distance for securing the perimeter of a blast
L L L L L L L L L L L




scene
L




*That is, the distance from the furthest debris
L L L L L L L




6. 1100°F: What temperature in the upper gas layer causes the onset of L L L L L L L L L L L




Flashover?
L




7. 1960°F: The temperature at which copper melts L L L L L L




8. 2 W/cm2: The measurement of the radiant heat flux (from gas layer to the floor)
L L L L L L L L L L L L L L




that indicates the onset of flashover
L L L L L L




9. 240 volts: The voltage between the two hot wires at the service entrance
L L L L L L L L L L L L




cables in most single-family residences in the United States (single-phase
L L L L L L L L L L




service with three wires)
L L L L




10. 3 years: The revision cycle for NFPA 921 (timespan)
L L L L L L L L




11. 350°F:The flash point of power steering fluid L L L L L L L




12. 35-70 p.s.i.: In high-pressure fuel-injected vehicles, this is the typical range of
L L L L L L L L L L L




pressure that is used to pump fuel from a fuel tank
L L L L L L L L L L L




13. 5 and 17: The lower explosive and upper explosive limit of natural gas
L L L L L L L L L L L L




(methane)?
L




14. 680°F:The ignition temperature of power steering fluid
L L L L L L L




15. Fuel:Any substance that can undergo combustion
L L L L L L




16. Act or Omission: Two factors or situations leading to a fire that may show the
L L L L L L L L L L L L L L




nature of the incident responsibility.
L L L L L




17. Additional Investigative Recommendations: This concept should not be L L L L L L L




included in a summary report of findings.
L L L L L L L




18. Admiralty Law: A law that may govern the fire investigation of a boat L L L L L L L L L L L L





L L

, .

19. After-market Equipment: A type of device in a vehicle, which can cause an L L L L L L L L L L L L




electrical overload to factory installed wiring
L L L L L L




20. Alive and Breathing: Evidence of smoke or soot in the lungs, bronchi, and
L L L L L L L L L L L L




trachea is one of the most significant factors in confirming that, at the time of the
L L L L L L L L L L L L L L L L




fire, the victim was WHAT?
L L L L L




21 All Team Members: Those who have the responsibility for monitoring safety
L L L L L L L L L L L




conditions at the fire or explosion scene
L L L L L L L




22. 1220°F:The melting temperature of aluminum L L L L L




23. Aluminum-to-pavement sparks: Which one of these is NOT considered a L L L L L L L L L




competent ignition source? Metal-to-metal sparks,
L L L L L




Aluminum-to-pavementsparks, L




Metal-to-pavement sparks,
L L




Motor bearing sparks
L L L




24. Heat Release Rate: A meaningful analysis of a fire requires an understanding of
L L L L L L L L L L L L




the fire growth, the total heat released, and WHAT?
L L L L L L L L L




25. Arc-fault circuit interrupter: What does he term AFCI stand for? And, the "A" L L L L L L L L L L L L




specifically represents what?
L L L




26. ASTM: The organization thatdevelopsstandard methodsfor testing materials
L L L L L L L L L




27. Auto-ignition:Initiation of combustion byheat but without a spark or flame L L L L L L L L L L L




28. Backdraft: A deflagration resulting from the sudden introduction of air into a L L L L L L L L L L L




confined space containing oxygen-deficient products of incomplete combustion
L L L L L L L L




29. Backdraft: An explosion caused by a combination of combustible materials
L L L L L L L L L L L




heated to the ignition point and a sudden introduction of oxygen to support
L L L L L L L L L L L L L




combustion
L




30. Backfire Flame Arrestor: A boat device that owners fail to keep clean, which is a
L L L L L L L L L L L L L L




frequent cause of engine compartment fires on boats
L L L L L L L L




31. Ballast: A device on a fluorescent light fixture that transforms the voltage from
L L L L L L L L L L L L




normal household voltage to a higher voltage
L L L L L L L




32. Battery: The starter motor draws its energyfrom this source L L L L L L L L L




33. Beyond a Reasonable Doubt: The burden of proof in a criminal trial
L L L L L L L L L L L




34. Bimetallic Thermostats: The component that controls temperature in many L L L L L L L L




heat-producing appliances
L L




35. BLEVE: This may occur when the vapor pressure of a liquid exceeds
L L L L L L L L L L L




atmospheric pressure
L L




*And this is the most common mechanical explosion
L L L L L L L




L L

, .

36. Boiling Point: The temperature or point at which the vapor pressure of a L L L L L L L L L L L L




liquid equals the external pressure applied
L L L L L L




37. Bonding: The process of electrically connecting two or more conductive L L L L L L L L L




objects 38. Bottom Passenger Side of the Windshield: Most engine fires
L L L L L L L L L L L




typically penetrate the interior compartment at this location of the vehicle
L L L L L L L L L L L




39. Brass Prongs (male ends): An investigator can closely examine this component
L L L L L L L L L L L




of a cord to determine if it was plugged into a receptacle
L L L L L L L L L L L L




40 Calcination: The chemical and physical changes that occur in gypsum wallboard
L L L L L L L L L L L




surfaces during a fire
L L L L




41. Carbon Monoxide: A narcotic gas that one might be exposed to in the fire L L L L L L L L L L L L L




42. Carbon Monoxide: The levels of this toxin dissipate over time after removal from L L L L L L L L L L L L




the fire environment.
L L L




43. Carbon Monoxide Poisoning: This toxic condition does NOT cause a cherry- pink L L L L L L L L L L L




coloration to the skin of the fire victim and is NOT visible on all skin types
L L L L L L L L L L L L L L L L




44. Carburetor Backfire: This occurrence is the most common open-flame L L L L L L L L




ignition source in non-fuel injected vehicles
L L L L L L




45. Ceiling jet: When the fire plume reaches the ceiling of a room and moves L L L L L L L L L L L L L




laterally along the ceiling
L L L L




46. Christmas Tree: An item in the home that burns at a peak HRR of 3000- L L L L L L L L L L L L L L




5000kW, which is hotter than a pool of gasoline or a polyurethane chair
L L L L L L L L L L L L L




47. Clean Burn: This occurs when intense radiated heat or direct flame contacts a L L L L L L L L L L L L




surface during the fire, burning away deposits
L L L L L L L




48. Collapsed Furniture Springs: This is a fire effect to furniture that does NOT L L L L L L L L L L L L




provide the investigators with clues concerning the type of ignition source, but can
L L L L L L L L L L L L L




show fire spread and intensity
L L L L L




49. Color: A fire characteristic that is NOT necessarily an accurate indicator of the L L L L L L L L L L L L




flame temperature
L L




50. Color Codes: This feature distinguishes the heat-sensitive bulbs of sprinklerL L L L L L L L L




heads from each other
L L L L




51. Combustion: A chemical process of oxidation, which occurs at a rate fast L L L L L L L L L L L




enough to produce heat and usually light in the form of either a glow or a flame
L L L L L L L L L L L L L L L L L




52. Compartmentation: A building design feature that aims to limit the fire to its L L L L L L L L L L L L




origin.
L




53. Competent Ignition Source: Located at the origin, these should be L L L L L L L L L




considered individually during the development of a cause hypothesis
L L L L L L L L L




54. Complete PPE: This should be donned when dealing with hazardous L L L L L L L L L




chemicals 55. Conduction: An example of heat transfer, when the heating of a steel
L L L L L L L L L L L L L L




beam to an unexposed part of a building results in a fire in that location
L L L L L L L L L L L L L L L




3 / Lg Lg



17

Información del documento

Subido en
4 de agosto de 2025
Número de páginas
17
Escrito en
2025/2026
Tipo
Examen
Contiene
Preguntas y respuestas
$15.49

¿Documento equivocado? Cámbialo gratis Dentro de los 14 días posteriores a la compra y antes de descargarlo, puedes elegir otro documento. Puedes gastar el importe de nuevo.
Escrito por estudiantes que aprobaron
Inmediatamente disponible después del pago
Leer en línea o como PDF

Seller avatar
Los indicadores de reputación están sujetos a la cantidad de artículos vendidos por una tarifa y las reseñas que ha recibido por esos documentos. Hay tres niveles: Bronce, Plata y Oro. Cuanto mayor reputación, más podrás confiar en la calidad del trabajo del vendedor.
TestBankPrep
4.9
(298)
Vendido
65
Seguidores
7
Artículos
1269
Última venta
2 días hace



Por qué los estudiantes eligen Stuvia

Creado por compañeros estudiantes, verificado por reseñas

Calidad en la que puedes confiar: escrito por estudiantes que aprobaron y evaluado por otros que han usado estos resúmenes.

¿No estás satisfecho? Elige otro documento

¡No te preocupes! Puedes elegir directamente otro documento que se ajuste mejor a lo que buscas.

Paga como quieras, empieza a estudiar al instante

Sin suscripción, sin compromisos. Paga como estés acostumbrado con tarjeta de crédito y descarga tu documento PDF inmediatamente.

Student with book image

“Comprado, descargado y aprobado. Así de fácil puede ser.”

Alisha Student

Preguntas frecuentes