Ironworkers Assignment Sheet 8.1
Study online at https://quizlet.com/_c7g0bz
1. which of the following is a basic method used on the c. vise
job site to bend bars?
a. torch
b. Peterson bar
c. vise
d. wrench
2. Column ties, unless otherwise specified, should pro- b. 1 1/2"
vide ______ clearance on all sides.
a. 1"
b. 1 1/2"
c. 2"
d. 2 1/2"
3. What length of bar is needed to fabricate a dou- d. 7'
ble hook #4 [#13] bar that measures 6' [1828 mm]
out-to-out?
a. 10'
b. 9'
c. 8'
d. 7'
4. What is the purpose of the hook at the end of a bar? d. to provide greater em-
a. to provide extra strength to the edge of the slab bedment in the concrete
b. to better gold beams to columns
c. to provide a form for the shape of the edge
d. to provide greater embedment in the concrete
5. Laying out of column ties begins at one end of the a. from the center of the U
bar. Where do you begin when laying out stirrups or bar or stirrup
U-bars?
a. from the center of the U bar or stirrup
1/4
Study online at https://quizlet.com/_c7g0bz
1. which of the following is a basic method used on the c. vise
job site to bend bars?
a. torch
b. Peterson bar
c. vise
d. wrench
2. Column ties, unless otherwise specified, should pro- b. 1 1/2"
vide ______ clearance on all sides.
a. 1"
b. 1 1/2"
c. 2"
d. 2 1/2"
3. What length of bar is needed to fabricate a dou- d. 7'
ble hook #4 [#13] bar that measures 6' [1828 mm]
out-to-out?
a. 10'
b. 9'
c. 8'
d. 7'
4. What is the purpose of the hook at the end of a bar? d. to provide greater em-
a. to provide extra strength to the edge of the slab bedment in the concrete
b. to better gold beams to columns
c. to provide a form for the shape of the edge
d. to provide greater embedment in the concrete
5. Laying out of column ties begins at one end of the a. from the center of the U
bar. Where do you begin when laying out stirrups or bar or stirrup
U-bars?
a. from the center of the U bar or stirrup
1/4
