CM 2215 Midterm
OSHA can get a warrant in order to enter the premises - answer What is an option for
OSHA if they refuse an inspector on the job site?
TRIR rates - answer What is the major tool used to measure they safety level in an
organization?
when it's a construction site - answer when can a focused inspection be done?
all contractors - answer which contractors are required to have an emergency response
plan?
receiving a tetanus shot - answer what is an example that represents a first aid case
under OSHA's general recording criteria?
Nixon – answer OSHA signed into law in 1970 by which president?
general contractor - answer regarding focused inspections on multi-employer worksites,
who must assume responsibility for coordinating safety efforts?
guardrails, safety nets, and harnesses - answer an employee walking/working surface
with an unprotected side or edge, which is 6 feet or more above a lower level, shall be
protected from falling by the use of what methods?
employee involvement - answeras far as safety goes, management commitment and
_____ are complimentary.
management commitment - answerregarding safety, an organizations actions and
______ clearly communicate what is important to that organization.
controlling employer - answeron a multi-employer job site, which employer has the
overall responsibility for the implementation of an effective safety and health program?
hazard - answera person must be exposed to a _____ for an accident to occur.
fall, struck by, caught in between, electrical shock - answerfocused inspection initiative
enables OSHA to focus on which hazards? (focus four)
7 - answeremployee has ____ working days to record an accident.
3 - answerthe ladder side rails must extend ____ feet above the upper landing surface.
, repair costs for damaged equipment and doctor's bills - answerwhat are the direct costs
of an accident?
compliance officer can be fined no more than $1,000, be imprisoned for no more than 6
months, or both. - answerwhat is the maximum consequence for an OSHA compliance
officer who gives an employer advanced notice of an upcoming inspection?
imminent danger, death, complaints, scheduled inspections - answerwhat is the order of
precedence for OSHA inspections?
discipline policy that supports the work rules, written work rules, documentation of
training according to the work rules - answerwhat can be used in defense against an
OSHA inspection?
be an injury/illness, job related, be a new case, and meet general criteria - answerwhat
must be present in order for an accident to be reported to OSHA?
2 - answerequipment and spoil piles must be kept ____ feet away from the edge of a
trench.
ANSI - answerhard hats must meet _____ specifications.
employer - answerthe ____ must provide a workplace that is free from recognized
hazards.
probability x severity - answerrisk equals what?
5 - answerworkers must be protected from cave ins when trenches are more than ____
feet deep.
prevention of hazards from forming - answerwhat is the best method of hazard control?
Z87 - answersafety glasses should be marked with a ____ to show that they would pass
a mass and velocity test.
85 - answerhearing loss typically begins to occur at exposures to noise levels of ____
dB.
competent person - answeran employee who is able to recognize a hazards associated
with the work area, is appointed by the employer and is authorized to take action
private sector employees - answerwho is covered under OSHA's jurisdiction?
vertical standard - answerstandard that applies to everything that involves elevated
work, applies to specific industries
OSHA can get a warrant in order to enter the premises - answer What is an option for
OSHA if they refuse an inspector on the job site?
TRIR rates - answer What is the major tool used to measure they safety level in an
organization?
when it's a construction site - answer when can a focused inspection be done?
all contractors - answer which contractors are required to have an emergency response
plan?
receiving a tetanus shot - answer what is an example that represents a first aid case
under OSHA's general recording criteria?
Nixon – answer OSHA signed into law in 1970 by which president?
general contractor - answer regarding focused inspections on multi-employer worksites,
who must assume responsibility for coordinating safety efforts?
guardrails, safety nets, and harnesses - answer an employee walking/working surface
with an unprotected side or edge, which is 6 feet or more above a lower level, shall be
protected from falling by the use of what methods?
employee involvement - answeras far as safety goes, management commitment and
_____ are complimentary.
management commitment - answerregarding safety, an organizations actions and
______ clearly communicate what is important to that organization.
controlling employer - answeron a multi-employer job site, which employer has the
overall responsibility for the implementation of an effective safety and health program?
hazard - answera person must be exposed to a _____ for an accident to occur.
fall, struck by, caught in between, electrical shock - answerfocused inspection initiative
enables OSHA to focus on which hazards? (focus four)
7 - answeremployee has ____ working days to record an accident.
3 - answerthe ladder side rails must extend ____ feet above the upper landing surface.
, repair costs for damaged equipment and doctor's bills - answerwhat are the direct costs
of an accident?
compliance officer can be fined no more than $1,000, be imprisoned for no more than 6
months, or both. - answerwhat is the maximum consequence for an OSHA compliance
officer who gives an employer advanced notice of an upcoming inspection?
imminent danger, death, complaints, scheduled inspections - answerwhat is the order of
precedence for OSHA inspections?
discipline policy that supports the work rules, written work rules, documentation of
training according to the work rules - answerwhat can be used in defense against an
OSHA inspection?
be an injury/illness, job related, be a new case, and meet general criteria - answerwhat
must be present in order for an accident to be reported to OSHA?
2 - answerequipment and spoil piles must be kept ____ feet away from the edge of a
trench.
ANSI - answerhard hats must meet _____ specifications.
employer - answerthe ____ must provide a workplace that is free from recognized
hazards.
probability x severity - answerrisk equals what?
5 - answerworkers must be protected from cave ins when trenches are more than ____
feet deep.
prevention of hazards from forming - answerwhat is the best method of hazard control?
Z87 - answersafety glasses should be marked with a ____ to show that they would pass
a mass and velocity test.
85 - answerhearing loss typically begins to occur at exposures to noise levels of ____
dB.
competent person - answeran employee who is able to recognize a hazards associated
with the work area, is appointed by the employer and is authorized to take action
private sector employees - answerwho is covered under OSHA's jurisdiction?
vertical standard - answerstandard that applies to everything that involves elevated
work, applies to specific industries
