CM 2215 Final Exam
When stopping a fall, a personal fall arrest system shall bring an employee to a
complete stop and limit the maximum deceleration distance to _______ feet. -
answer3.5
Personal fall arrest systems, when stopping a fall, shall be rigged such that an
Employee cannot free fall more than ______ feet or contact any lower level - answer6
The top rail of a guardrail system must be a height of ____ inches +/- 3 inches
above the walking/working level. - answer42
The top rail of a guardrail system must support _______ pounds. - answer200
The mid rail of a guardrail system must hold ____ pounds. - answer150
The toe board of a guardrail system must hold ____ pounds. - answer50
On temporary stairs, handrails (to provide adequate handholds for employees
grasping to prevent falling) shall have a minimum clearance of ____ inches
between the handrail and walls. - answer3
A controlled decking zone can only be used as fall protection up to a maximum
height of _____ feet. - answer30
A PFAS anchor must be capable of supporting ______ pounds of force per
worker attached to it. - answer5000
Controlled access warning lines must be at least ____ feet from the edge. - answer6
When mechanical equipment is being used perpendicular to the roof edge, the
warning lines cannot be closer than _______ feet. - answer10
OSHA defines a hole as a gap or void ____ inches or more in its least dimension,
in a floor, roof, or other walking/working surface. - answer2
A hole cover must support ___ times the maximum intended load. - answer2
Hole covers must be ___________ to prevent displacement. - answersealed
Hole covers must be marked with the word "HOLE" or "COVER" or ________
coded. - answercolor
, The six steps of incident investigation are: - answer1. Preserve & document the scene
2. Collect facts through interviews
3. Develop an event sequence timeline
4. Determine the causes
5. Recommend improvements
6. Write the report
The best time to interview witnesses is______________________. -
answerimmediately following the event
Incident investigation should NOT be about _________________. - answerwho is to
blame
The primary reason for an incident investigation is ________________________. -
answerto identify the cause and prevent it from happening again
An accident is _________________________________. - answeran unplanned event
that results in personal injury or property damage
An incident is __________________________________. - answeran unplanned event
that does not result in personal injury but may result in property damage or is worthy of
recording
A near miss is _________________________________. - answeran event that does
not result in an injury or damage
JSA stands for - answerJob Safety Analysis
The four steps of conducting a JSA are: - answer1. Identify job to be examined
2. Identify steps/tasks for job
3. Define hazards associated with each task
4. Identify control(s) to address each hazard
Incident Rates allow for a comparative level of __________ and _________ among
different _____________, _____________, and _______________. - answerinjuries
and illnesses
industries, organizations, and operations
The formula for incident rates is - answer# incidents x 200,000 / employee hours
worked
The typical incident rate formula is based on _______ workers working ________ hours
per year. - answer100
200,000
TRIR stands for: - answerTotal Recordable Incident Rate
When stopping a fall, a personal fall arrest system shall bring an employee to a
complete stop and limit the maximum deceleration distance to _______ feet. -
answer3.5
Personal fall arrest systems, when stopping a fall, shall be rigged such that an
Employee cannot free fall more than ______ feet or contact any lower level - answer6
The top rail of a guardrail system must be a height of ____ inches +/- 3 inches
above the walking/working level. - answer42
The top rail of a guardrail system must support _______ pounds. - answer200
The mid rail of a guardrail system must hold ____ pounds. - answer150
The toe board of a guardrail system must hold ____ pounds. - answer50
On temporary stairs, handrails (to provide adequate handholds for employees
grasping to prevent falling) shall have a minimum clearance of ____ inches
between the handrail and walls. - answer3
A controlled decking zone can only be used as fall protection up to a maximum
height of _____ feet. - answer30
A PFAS anchor must be capable of supporting ______ pounds of force per
worker attached to it. - answer5000
Controlled access warning lines must be at least ____ feet from the edge. - answer6
When mechanical equipment is being used perpendicular to the roof edge, the
warning lines cannot be closer than _______ feet. - answer10
OSHA defines a hole as a gap or void ____ inches or more in its least dimension,
in a floor, roof, or other walking/working surface. - answer2
A hole cover must support ___ times the maximum intended load. - answer2
Hole covers must be ___________ to prevent displacement. - answersealed
Hole covers must be marked with the word "HOLE" or "COVER" or ________
coded. - answercolor
, The six steps of incident investigation are: - answer1. Preserve & document the scene
2. Collect facts through interviews
3. Develop an event sequence timeline
4. Determine the causes
5. Recommend improvements
6. Write the report
The best time to interview witnesses is______________________. -
answerimmediately following the event
Incident investigation should NOT be about _________________. - answerwho is to
blame
The primary reason for an incident investigation is ________________________. -
answerto identify the cause and prevent it from happening again
An accident is _________________________________. - answeran unplanned event
that results in personal injury or property damage
An incident is __________________________________. - answeran unplanned event
that does not result in personal injury but may result in property damage or is worthy of
recording
A near miss is _________________________________. - answeran event that does
not result in an injury or damage
JSA stands for - answerJob Safety Analysis
The four steps of conducting a JSA are: - answer1. Identify job to be examined
2. Identify steps/tasks for job
3. Define hazards associated with each task
4. Identify control(s) to address each hazard
Incident Rates allow for a comparative level of __________ and _________ among
different _____________, _____________, and _______________. - answerinjuries
and illnesses
industries, organizations, and operations
The formula for incident rates is - answer# incidents x 200,000 / employee hours
worked
The typical incident rate formula is based on _______ workers working ________ hours
per year. - answer100
200,000
TRIR stands for: - answerTotal Recordable Incident Rate
