ICC Vapor Recovery 2 Exam| 60 Questions All Answered Correctly| Latest 2025/2026

ICC Vapor Recovery 2 Exam| 60 Questions All Answered Correctly| Latest 2025/2026 After backfilling the vapor return and vent lines, the maximum pressure drop through the system shall not exceed ________at 60 cubic feet per hour as determined by TP-201.4, Dynamic Backpressure. a. 0.75 inches WC b. 0.5 inches WC c. 0.32 inches WC d. 0.55 inches WC c. 0.5 inches WC CARB's most recent vapor recovery regulations are known as: a. EVR (enhanced vapor recovery) b. CVR (California vapor recovery) c. PVR (protective vapor recovery) d. ORVR (onboard refueling vapor recovery) a. EVR (enhanced vapor recovery) A valve installed in a motor-vehicle fueling hose designed to separate with little or no product a. breakaway b. hose clamp c. sheer valve d. flow limiter a. breakaway A Gilbarco Vapor VAC/OPW Vapor Saver system is consdered to have a vapor recovery equipment defect (VRED) if the vapor escape guard on an OPW 12 VW nozzle is missing or damaged on at least ____ % of the circumference of the device. a. 25 b. 50 c. 75 d. 100 c. 75 The two point Phase I vapor recovery system requires that a separate vapor recovery riser pipe be installed in the tank and be equipped with a: a. drop tube b. locking block valve c. pressure/vacuum vent d. vapor recovery adaptor d. vapor recovery adaptor.... When removing liquid from a sump or spill bucket and the liquid contains fuel, it must be: a. managed as hazardous waste b. pumped into a bucket to evaporate c. scooped or balled onto the concrete pad d. put it in a sealed container and put into a dump a. managed as hazardous waste One of the approved methods of overfill prevention is to have an overfill device that will automatically shut off the fill to the tank when the tank is at a maximum of ____ % full