Unit of measurement for frequency (pitch) - -Hertz (Hz)
Unit of measurement for intensity (loudness) - -Decibel (dB)
Risk of damage from noise - -How loud (intensity) and how long (duration)
Steady-state or continuous noise, e.g. generator - -Lasts 1 second or longer
Impulse or Impact noise, e.g. gunfire or nail gun - -Lasts less than one second
Parts of the outer ear - -Pinna and external auditory canal
Parts of the middle ear - -Tympanic membrane, ossicles, eustachian tube
Eustachian tube (auditory tube) - -Tube connecting the middle ear to the pharynx and
equalizes middle ear space with atmospheric pressure
Conductive HL occurs here - -Outer or middle ear
Sensorineural hearing loss - -Hearing loss resulting from damage to the inner ear
(cochlea) or the auditory nerve
Noise-induced hearing loss (NIHL) - -Condition caused by the destruction of hair cells in
the inner ear, the organs responsible for hearing, as a result of sounds that are "too
long, too loud, or too close"; a sensorineural hearing loss
Mixed hearing loss - -Combination of conductive and sensorineural types in the same
ear
Middle ear bones (ossicles) - -Malleus (hammer), incus (anvil), stapes (stirrup)
Possible early symptoms/signs of noise induced hearing loss - -Tinnitus; difficulty
understanding in presence of background noise; read visual cues
Auditory effects of noise - -NIHL; tinnitus; hyperacusis
Non-auditory effects of noise - -
annoyance
sleep disturbance
attention
CAOHC
CAOHC
CAOHC
motivation
stress reactions
cardiovascular problems
endocrine problems
3 foot rule - -Good rule of thumb to recognize hazardous noise exposure
levels/situations: the rule is: if you have to shout at arms length (~3ft), in order to be
understood over the background noise, then you're likely exposed to hazardous noise
levels & should be wearing hearing protection to prevent NIHL
OSHA (Occupational Safety and Health Administration) versus National institute of
Occupational Safety and Heath (NIOSH) - -OSHA enforces regulation and NIOSH
recommends best practice based on science and research
Sound pressure level (SPL) versus hearing level (HL) - -SPL describes noise
measurements taken with a sound level meter or dosimeter; HL describes threshold
levels obtained with an audiometer; 0 dB HL is not equal to 0 dB SPL
Noise Dosimeter - -A sound measurement device used to record the amount of sound
exposure over an extended period of
time (usually a work day)
Personal vs. Area
Sound level meter - -Uses a microphone to sense pressure variations in sound waves;
the meter converts those pressures directly into decibels; provides a noise
measurement that is a snapshot in time.
Time Weighted Average (TWA) - -An evaluation of exposures that is time-weighted over
an established period. It allow the exposure levels to be averaged generally over an
eight-hour time period.
OSHA exchange rate - -5 dB; for every 5 dB you go over the PEL of 90dBA TWA you
half the allowable time of exposure
OSHA Action Level for noise - -85dBA TWA
Sound Level Meter A-weighted Scale - -OSHA requires this scale as it resembles how
the human ear responds to sound (humans hear best from 500 Hz to 4000 Hz)
Human Frequency Response at Birth - -20 Hz to 20,000 Hz (20 kHz)
Human speech frequency range - -250 Hz to 4000 Hz
Elements of a Hearing Conservation Program - -Noise hazard assessment;
engineering/administrative controls; annual hearing monitoring; annual
training/education; hearing protection; recordkeeping
CAOHC
CAOHC
OSHA Noise Amendment - -29 CFR 1910.95
Hughson-Westlake Procedure - -Common procedure for obtaining threshold; the
audiologist decreases stimulus intensity by 10 dB with a (+) response and increases by
5 dB with a (-) response
Hearing threshold level - -Lowest intensity level responded to at least 50% of the time
Excessive noise levels will impact these test frequencies during a hearing exam - -Low
frequencies e.g. 500 Hz
First frequency always tested on an occupational hearing exam - -1000 Hz
1000 Hz retest - -Done as a validity check on first ear tested; thresholds should be
within 5dB or should reinstruct patient and start test over
Presbycusis - -A gradual loss of sensorineural hearing that occurs as the body ages
Professional Supervisor In a HCP - -Responsible for oversight of Audiometric testing;
reviews problem audiograms; must be an audiologist or physician
Elements of a Hearing Conservation Program - -Mandatory and includes: exposure
monitoring, audiometric testing, hearing protection, employee training, record keeping,
and program evaluation
Noise Controls - -At the source (preferred), along the path, at the receiver
Industrial Hygienist - -Responsible for assessment of hazards that may affect workers
as well as hazards that may impact the community.
NRR - -Noise Reduction Rating; number determined in a laboratory
Hearing protection derating - -OSHA recommends to reduce NRR in half
Hearing protection types - -Noise reduction devices worn over the ear (noise muffs) or
inside the ear canal (earplugs) in work or recreational settings with high noise levels
Best hearing protection - -The one that is worn (consistently and properly)
Dual hearing protection NRR - -After derating add additional 5dB of protection
Inverse square law for noise - -For every doubling of distance away from a noise source
you reduce the level by 6 dB
CAOHC
CAOHC
Noise doubling rule - -If you add two identical noise sources you add 3dB to the Level
(100 dB + 100 dB = 103 dB)
Administrative noise controls - -Changes made by employer such as changing work
schedules to reduce noise hazard risk to employees
OSHA standard threshold shift - -10dB average change at 2000 Hz, 3000 Hz, and 4000
Hz, when compared to a baseline , in one or both ears
OSHA Recordable Standard Threshold Shift for Hearing Loss - -3 criteria: 10dB
average shift at 2, 3, and 4kHz, compared to baseline, AND 25 dB average HL at 2, 3,
and 4 kHz in the same ear on current audiograms, AND determined to be work-related
Collapsing ear canal - -Occurs naturally in some individuals during audiometric testing
earphones cause auricle to move forward collapsing the canal and causing an artificial
hearing loss; Insert earphones should be used
Cochlea - -A coiled, bony, fluid-filled tube in the inner ear through which sound waves
trigger nerve impulses; damage from hazardous noise occurs here.
Microprocessor audiometer - -Automated computer controlled audiometer
Tinnitus - -A jingling; a ringing or buzzing in the ear
Type of hearing test done by a certified occupational Hearing conservationist (COHC) - -Air Conduction Pure Tone Threshold Test
Hearing Threshold Level (HTL) are recorded on this - -Audiogram (can be serial or
graphic)
Baseline Hearing Test Must Be Done Within - -6 months of starting employment
(exception for mobile vans is up to 1 year)
Type of Hearing Loss that is treatable (medically or surgically) - -Conductive hearing
loss
Temporary Threshold Shift (TTS) - -Brief exposure to intense noise that will ordinarily
recover with auditory rest
Hearing Thresholds Tested are: - -500, 1000, 2000, 3000, 4000, and 6000 Hz; 8000 Hz
is optional but recommended.
Audiometric zero is: - -0 dB HL; this is not an absence of sound
HL scale has been normalized to healthy adult hearing
CAOHC
CAOHC
Vertical axis on a graphic Audiogram shows this: - -Intensity levels which are measured
in Decibels (softest at the top, loudest at the bottom)
Horizontal axis on a graphic Audiogram shows this: - -Frequencies which are measured
in Hertz (low to high going from left to right)
Hearing Baselines are reestablished when you have an STS because: - -You don't want
to identify the same shift each year
Days to notify individual of an STS in writing - -21 days
OSHA versus NIOSH Noise Permissible Exposure Limit (PEL) - -90 dBA PEL for
OSHA; 85 dBA PEL recommended by NIOSH
OSHA recommendations for Audiometric Records - -Maintain for duration of
employment; NIOSH recommends duration of employment + 30 years
Sound Level Meter Microphone Type Required by OSHA - -Minimum of Type 2
microphone
Formable Earplugs are: - -Disposable when no longer return to shape and soiled
Pre-formed earplugs: - -Can be washed with mild soap and water and reusable
Noise muff cushions - -Should completely cover ear and seal against the face; cushions
should be replaced when damaged and no longer seal effectively.
Hearing Aids and Hearing Test - -Tests are to be done without hearing aids
Function of the Outer Ear - -Collecting sound and sending it to the eard
Vista previa del contenido
CAOHC
CAOHC HEARING CERTIFICATION
EXAM LATEST VERSION 2025
Unit of measurement for frequency (pitch) - -Hertz (Hz)
Unit of measurement for intensity (loudness) - -Decibel (dB)
Risk of damage from noise - -How loud (intensity) and how long (duration)
Steady-state or continuous noise, e.g. generator - -Lasts 1 second or longer
Impulse or Impact noise, e.g. gunfire or nail gun - -Lasts less than one second
Parts of the outer ear - -Pinna and external auditory canal
Parts of the middle ear - -Tympanic membrane, ossicles, eustachian tube
Eustachian tube (auditory tube) - -Tube connecting the middle ear to the pharynx and
equalizes middle ear space with atmospheric pressure
Conductive HL occurs here - -Outer or middle ear
Sensorineural hearing loss - -Hearing loss resulting from damage to the inner ear
(cochlea) or the auditory nerve
Noise-induced hearing loss (NIHL) - -Condition caused by the destruction of hair cells in
the inner ear, the organs responsible for hearing, as a result of sounds that are "too
long, too loud, or too close"; a sensorineural hearing loss
Mixed hearing loss - -Combination of conductive and sensorineural types in the same
ear
Middle ear bones (ossicles) - -Malleus (hammer), incus (anvil), stapes (stirrup)
Possible early symptoms/signs of noise induced hearing loss - -Tinnitus; difficulty
understanding in presence of background noise; read visual cues
Auditory effects of noise - -NIHL; tinnitus; hyperacusis
Non-auditory effects of noise - -
annoyance
sleep disturbance
attention
CAOHC
, CAOHC
motivation
stress reactions
cardiovascular problems
endocrine problems
3 foot rule - -Good rule of thumb to recognize hazardous noise exposure
levels/situations: the rule is: if you have to shout at arms length (~3ft), in order to be
understood over the background noise, then you're likely exposed to hazardous noise
levels & should be wearing hearing protection to prevent NIHL
OSHA (Occupational Safety and Health Administration) versus National institute of
Occupational Safety and Heath (NIOSH) - -OSHA enforces regulation and NIOSH
recommends best practice based on science and research
Sound pressure level (SPL) versus hearing level (HL) - -SPL describes noise
measurements taken with a sound level meter or dosimeter; HL describes threshold
levels obtained with an audiometer; 0 dB HL is not equal to 0 dB SPL
Noise Dosimeter - -A sound measurement device used to record the amount of sound
exposure over an extended period of
time (usually a work day)
Personal vs. Area
Sound level meter - -Uses a microphone to sense pressure variations in sound waves;
the meter converts those pressures directly into decibels; provides a noise
measurement that is a snapshot in time.
Time Weighted Average (TWA) - -An evaluation of exposures that is time-weighted over
an established period. It allow the exposure levels to be averaged generally over an
eight-hour time period.
OSHA exchange rate - -5 dB; for every 5 dB you go over the PEL of 90dBA TWA you
half the allowable time of exposure
OSHA Action Level for noise - -85dBA TWA
Sound Level Meter A-weighted Scale - -OSHA requires this scale as it resembles how
the human ear responds to sound (humans hear best from 500 Hz to 4000 Hz)
Human Frequency Response at Birth - -20 Hz to 20,000 Hz (20 kHz)
Human speech frequency range - -250 Hz to 4000 Hz
Elements of a Hearing Conservation Program - -Noise hazard assessment;
engineering/administrative controls; annual hearing monitoring; annual
training/education; hearing protection; recordkeeping
CAOHC