MKC SWE Study Guide (MKC Knight
donation)- | WITH COMPLETE SOLUTIONS
Types of gate valves
Parallel and wedge
CAGE code
Commercial and government entity code
Hard fouling in a heat exchanger
Deposits that significantly reduce heat transfer efficiency.
Hydraulic actuator bench test pressure
On and one half times the operating pressure and hold for five minutes
Modes of operation on Ultra-Sep OWS
Operate and clean mode
Component boosting pressure in Ultra Sep OWS
Process Pump
Ensign changes since 1776
26
Improperly seated piston rings indication
Dull appearance and may have areas of black carbon where blow by is occurring.
Checks for properly seated piston rings
Visual and operational parameters.
AC generator windings touching
Open Circuit
, Process of converting mechanical energy to electrical energy
Electromagnetic induction.
NSTM chapter for DEMPS maintenance
Not specified in the notes.
SSS in clutches
Not specified in the notes.
Brakes used in gas turbines
Disk brake
Hydraulic filter change frequency on jet drive powered HPU
Not specified in the notes.
Types of line shaft bearings
Ring-oiled and disc-oiled
Max angle on the E-BAC unit for operation
Not specified in the notes.
Fuel sample test before acceptance
Clear and bright
Fluid spec for hot flushing on L/O systems
MIL-PRF
Torque for pressure vessel end cap on village marine R/O
Do not overtighten
Dew point in HVAC unit
The point at which condensation develops.
Oil filter on HP air compressor
donation)- | WITH COMPLETE SOLUTIONS
Types of gate valves
Parallel and wedge
CAGE code
Commercial and government entity code
Hard fouling in a heat exchanger
Deposits that significantly reduce heat transfer efficiency.
Hydraulic actuator bench test pressure
On and one half times the operating pressure and hold for five minutes
Modes of operation on Ultra-Sep OWS
Operate and clean mode
Component boosting pressure in Ultra Sep OWS
Process Pump
Ensign changes since 1776
26
Improperly seated piston rings indication
Dull appearance and may have areas of black carbon where blow by is occurring.
Checks for properly seated piston rings
Visual and operational parameters.
AC generator windings touching
Open Circuit
, Process of converting mechanical energy to electrical energy
Electromagnetic induction.
NSTM chapter for DEMPS maintenance
Not specified in the notes.
SSS in clutches
Not specified in the notes.
Brakes used in gas turbines
Disk brake
Hydraulic filter change frequency on jet drive powered HPU
Not specified in the notes.
Types of line shaft bearings
Ring-oiled and disc-oiled
Max angle on the E-BAC unit for operation
Not specified in the notes.
Fuel sample test before acceptance
Clear and bright
Fluid spec for hot flushing on L/O systems
MIL-PRF
Torque for pressure vessel end cap on village marine R/O
Do not overtighten
Dew point in HVAC unit
The point at which condensation develops.
Oil filter on HP air compressor
