Which of the following is a property of an electromagnetic field built around a conductor that opposes
any changes in current flow in a circuit? - CORRECT ANSWER Impedance
_____________ is obtained by repeat positive actions on a daily basis - CORRECT ANSWER
Professionalism
Which of the following markings is used for nonconductive optical fiber general-purpose cables? -
CORRECT ANSWER OFNG
The installer must take responsibility to know, understand, and _______ all aspects of a job. - CORRECT
ANSWER communicate
Cable installation companies are dependent on ________ for new and repeat business. - CORRECT
ANSWER customers
Which of the following refers to a set of rules issued by governmental body at the state level within the
US? - CORRECT ANSWER Regulations
What is the specified performance level for Category 6 cable? - CORRECT ANSWER 250 MHz
Which type of optical fiber cable should be color coded with an Orange outer cable sheath? - CORRECT
ANSWER MM with a 100um core diameter
Listening carefully, respecting values, & seeking the understanding of others is all apart of - CORRECT
ANSWER Effective communication
__________ is the movement of electrical energy in the form of electrical signals from point to point. -
CORRECT ANSWER Transmission
, Which of the following is the primary benefit of using wall-mounted racks and cabinets in place of
traditional equipment racks? - CORRECT ANSWER Takes up less space within the equipment room
The number of cycles a signal is repeated in a given time is known as: - CORRECT ANSWER Frequency
Which topology uses a linear configuration that places all network devices on one length of cable? -
CORRECT ANSWER Bus
If 60 cycles in 1s is 60 Hz, then 1,000,000 cycles in 1s is - CORRECT ANSWER 1 Megahertz (MHz)
Which of the following is a building-serving space that houses large pieces of common active
equipment? - CORRECT ANSWER ER
Which of the following is designed to provide protection from harmful chemicals? - CORRECT ANSWER
Rubber gloves
Which phase of testing includes documenting the test results? - CORRECT ANSWER Phase 3
Which of the following are typically used to support cables between a cable tray and work area outlets?
- CORRECT ANSWER J-Hooks
Which of the following PPE item must always be worn when working with or handling optical fiber? -
CORRECT ANSWER Eye Protection
Which of the following is used to equalize potential differences between SBB's on the same floor? -
CORRECT ANSWER BBC
Which type of optical fiber cable should be color coded with a RED outer cable sheath? - CORRECT
ANSWER Dispersion-shifted SM optical fiber
Which of the following connector styles is presently used within optical fiber cabling systems (i.e., its not
a legacy connector)? - CORRECT ANSWER Small Form Factor