TCFP INSPECTOR'S CLASS CORRECT
100%
Which duty is not the responsibility of a level I Inspector?
A) Handle citizen complaints related to fire and life safety.
B) Perform plans reviews.
C) Interpret and apply adopted codes and standards.
D) Determine occupancy loads for single-use buildings. - ANSWER Perform plans
reviews.
Most of the consensus standards that relate to fire and life safety are developed by the
following organizations except:
ASTM International,
National Fire Protection Assoc.,
American National Standards Institute,
Underwriters Laboratories - ANSWER American National Standards Institute
Regarding Commercial Kitchen Hood Systems, pipe penetrations of the exhaust hood
require what?
a. Minimum 18 inch clearance to combustible materials
b. Printed manufacturer guidelines of spacing on the pipe itself
c. Gas shut off valve and electrical shunt accessibility
d. A liquid tight continuous external weld - ANSWER A liquid tight continuous external
weld
A independent, non-profit organization that tests products for their intended use and
certifies them as safe describes:
A) ASTM International
B) American National Standards Institute
C) Underwriters Laboratories Inc.
D) Standards Council of Canada - ANSWER Underwriters Laboratories Inc.
Which is not one of the three general types of drawings used to show structure, facility,
or site information?
A. Plot plan
B. Aerial view
C. Floor plan
D. Elevation view - ANSWER Aerial view
Structural lumber has a moisture content of ___________% or less.
25%
19%
15%
12% - ANSWER 19%
, Which of the following occupancies does not fall under state and local regulations?
A). Day care
B). Jail
C). Post office
D). Medical facility - ANSWER Post office
The typical life cycle of a model code edition is ___ years.
a. 5-7
b. 2-3
c. 7-10
d. 3-5 - ANSWER 3-5
For Dry systems exceeding 500 gallons, there must be a quick opening device installed
unless water is delivered to the system test connection within a specific time frame.
What is this time frame?
A. 30 seconds
B. 60 seconds
C. Not more than 30 seconds
D. Not more than 60 seconds - ANSWER Not more than 60 seconds
Which of the following is an inspector not authorized to do?
A. Issue a summons.
B. Issue citations.
C. File complaints for code violations.
D. Prosecute an offender in a court of law. - ANSWER Prosecute an offender in a court
of law.
While exercising enforcement power, it is essential that the inspector ensure that the
rights of the accused are protected and that ______________ is practiced.
A.) Worksite Safety
B.) Due Process
C.) Customer Appreciation
D.) Strict Compliance - ANSWER Due Process
T or F Federal and some state/provincial-owned buildings located within the local
jurisdiction are required to comply with local codes. - ANSWER False
An educational occupancy is any building or portion of a building that is used for the
purpose of education of ___ or more persons from preschool through the 12th grade.
a. 6
b. 5
c. 10
d. 2 - ANSWER 6
100%
Which duty is not the responsibility of a level I Inspector?
A) Handle citizen complaints related to fire and life safety.
B) Perform plans reviews.
C) Interpret and apply adopted codes and standards.
D) Determine occupancy loads for single-use buildings. - ANSWER Perform plans
reviews.
Most of the consensus standards that relate to fire and life safety are developed by the
following organizations except:
ASTM International,
National Fire Protection Assoc.,
American National Standards Institute,
Underwriters Laboratories - ANSWER American National Standards Institute
Regarding Commercial Kitchen Hood Systems, pipe penetrations of the exhaust hood
require what?
a. Minimum 18 inch clearance to combustible materials
b. Printed manufacturer guidelines of spacing on the pipe itself
c. Gas shut off valve and electrical shunt accessibility
d. A liquid tight continuous external weld - ANSWER A liquid tight continuous external
weld
A independent, non-profit organization that tests products for their intended use and
certifies them as safe describes:
A) ASTM International
B) American National Standards Institute
C) Underwriters Laboratories Inc.
D) Standards Council of Canada - ANSWER Underwriters Laboratories Inc.
Which is not one of the three general types of drawings used to show structure, facility,
or site information?
A. Plot plan
B. Aerial view
C. Floor plan
D. Elevation view - ANSWER Aerial view
Structural lumber has a moisture content of ___________% or less.
25%
19%
15%
12% - ANSWER 19%
, Which of the following occupancies does not fall under state and local regulations?
A). Day care
B). Jail
C). Post office
D). Medical facility - ANSWER Post office
The typical life cycle of a model code edition is ___ years.
a. 5-7
b. 2-3
c. 7-10
d. 3-5 - ANSWER 3-5
For Dry systems exceeding 500 gallons, there must be a quick opening device installed
unless water is delivered to the system test connection within a specific time frame.
What is this time frame?
A. 30 seconds
B. 60 seconds
C. Not more than 30 seconds
D. Not more than 60 seconds - ANSWER Not more than 60 seconds
Which of the following is an inspector not authorized to do?
A. Issue a summons.
B. Issue citations.
C. File complaints for code violations.
D. Prosecute an offender in a court of law. - ANSWER Prosecute an offender in a court
of law.
While exercising enforcement power, it is essential that the inspector ensure that the
rights of the accused are protected and that ______________ is practiced.
A.) Worksite Safety
B.) Due Process
C.) Customer Appreciation
D.) Strict Compliance - ANSWER Due Process
T or F Federal and some state/provincial-owned buildings located within the local
jurisdiction are required to comply with local codes. - ANSWER False
An educational occupancy is any building or portion of a building that is used for the
purpose of education of ___ or more persons from preschool through the 12th grade.
a. 6
b. 5
c. 10
d. 2 - ANSWER 6
