NCCER Level 1 Module 10 Basic Electrical
Construction Drawings Already Passed
A cutaway view of a building or object is known as
a(n)______. - ans-Sectional drawing
What is the total connected load of Circuit A-1 if each of the
Type C lighting fixtures in the figure above has a total lamp
and ballast load of 150VA? - ans-1,200VA
In which division of the MasterFormat is electronic safety
covered? - ans-Division 28
A section line on a drawing shows - ans-The location of the
section on the plan
, On electrical drawings, a solid line with a solid circle at the
end indicates wiring______. - ans-Turn down
An electrical drafting line with a double arrowhead
represents - ans-A branch circuit homerun
Which of the following are used in electrical drafting lines to
show the number of circuits? - ans-Arrowheads
In dimension drawings, the dimensions written on the
drawing are - ans-The actual dimensions
Which of the following is used in an electrical diagram to
show wiring concealed in a floor? - ans-A dashed line
The architects scale is designed so that one inch equals one
foot - ans-False
A circle with two parallel lines drawn through it is the symbol
normally used for ______. - ans-Duplex receptacles
Construction Drawings Already Passed
A cutaway view of a building or object is known as
a(n)______. - ans-Sectional drawing
What is the total connected load of Circuit A-1 if each of the
Type C lighting fixtures in the figure above has a total lamp
and ballast load of 150VA? - ans-1,200VA
In which division of the MasterFormat is electronic safety
covered? - ans-Division 28
A section line on a drawing shows - ans-The location of the
section on the plan
, On electrical drawings, a solid line with a solid circle at the
end indicates wiring______. - ans-Turn down
An electrical drafting line with a double arrowhead
represents - ans-A branch circuit homerun
Which of the following are used in electrical drafting lines to
show the number of circuits? - ans-Arrowheads
In dimension drawings, the dimensions written on the
drawing are - ans-The actual dimensions
Which of the following is used in an electrical diagram to
show wiring concealed in a floor? - ans-A dashed line
The architects scale is designed so that one inch equals one
foot - ans-False
A circle with two parallel lines drawn through it is the symbol
normally used for ______. - ans-Duplex receptacles
