ASE MLR CERTIFICATION TEST WITH CORRECT
QUESTIONS AND ACTUAL ANSWERS GRADED
A+[BRAND NEW].
Both A and B - ANSWERS-Technician observes that the brake fluid
level is at the "Min" mark in the master cylinder reservoir. Tech A
says that worn front pads could be the cause. Tech B says that a
leak in the brake hydraulic system could be the cause. Who is
right?
A only - ANSWERS-The tires of a vehicle are being rotated and
balanced. Tech A says that the wheel weight retaining clips must
be matched to the rim profile. Tech B says that directional tires
are rotated in a criss-cross pattern. Who is right?
Safely exit the building - ANSWERS-When a shop fire cannot be
immediately contained, the best thing to do is warn others in the
area, and:
300 amps for 15 seconds - ANSWERS-A fully charged battery rated
at 600 CCA, the ambient temperature is 70 degrees which of
these current and time periods should be used?
B only - ANSWERS-A vehicle's halogen headlamp bulbs are being
replaced. Technician A says the glass part of the bulb can only be
handled with bare hands. Technician B says the headlamp may
need to be removed. Who is right?
, 0.728 - ANSWERS-On a Metric Micrometer upper sleeve reading
5.0mm with lower sleeve reading 0.50mm and a thimble reading
of 0.01mm what is the overall reading?
A only - ANSWERS-The fuel filter on a fuel-injected vehicle is being
replaced. Tech A says the fuel pressure should be relieved
before removing the filter. Tech B says that the arrow on the fuel
filter should point towards the fuel tank. Who is right?
The brake pedal feels low and spongy - ANSWERS-Which of these
is an indication of air in the brake hydraulic system?
Anaerobic - ANSWERS-Which of these cures in the absence of air?
Fluid contaminated brake linings - ANSWERS-A grabbing brake
condition can be caused by any of these EXCEPT:
Visually verify that the oil filter gasket is properly installed -
ANSWERS-When performing an oil filter change on a vehicle with
a spin on oil filter, the technician must:
Voltage regulation - ANSWERS-A vehicle's battery prematurely
fails. A charging system output test shows the generator
(alternator) is producing a constant 16.0 volts. This could indicate
a failed:
Seal should be lubricated with transmission fluid - ANSWERS-A
transmission equipped with a filter is being serviced. When
installing the new filter, the:
Both A and B - ANSWERS-While inspecting the rear axle wheel
studs on a rear-wheel drive vehicle, the technician observed that
one stud is damaged. Technician A says that all the wheel studs
QUESTIONS AND ACTUAL ANSWERS GRADED
A+[BRAND NEW].
Both A and B - ANSWERS-Technician observes that the brake fluid
level is at the "Min" mark in the master cylinder reservoir. Tech A
says that worn front pads could be the cause. Tech B says that a
leak in the brake hydraulic system could be the cause. Who is
right?
A only - ANSWERS-The tires of a vehicle are being rotated and
balanced. Tech A says that the wheel weight retaining clips must
be matched to the rim profile. Tech B says that directional tires
are rotated in a criss-cross pattern. Who is right?
Safely exit the building - ANSWERS-When a shop fire cannot be
immediately contained, the best thing to do is warn others in the
area, and:
300 amps for 15 seconds - ANSWERS-A fully charged battery rated
at 600 CCA, the ambient temperature is 70 degrees which of
these current and time periods should be used?
B only - ANSWERS-A vehicle's halogen headlamp bulbs are being
replaced. Technician A says the glass part of the bulb can only be
handled with bare hands. Technician B says the headlamp may
need to be removed. Who is right?
, 0.728 - ANSWERS-On a Metric Micrometer upper sleeve reading
5.0mm with lower sleeve reading 0.50mm and a thimble reading
of 0.01mm what is the overall reading?
A only - ANSWERS-The fuel filter on a fuel-injected vehicle is being
replaced. Tech A says the fuel pressure should be relieved
before removing the filter. Tech B says that the arrow on the fuel
filter should point towards the fuel tank. Who is right?
The brake pedal feels low and spongy - ANSWERS-Which of these
is an indication of air in the brake hydraulic system?
Anaerobic - ANSWERS-Which of these cures in the absence of air?
Fluid contaminated brake linings - ANSWERS-A grabbing brake
condition can be caused by any of these EXCEPT:
Visually verify that the oil filter gasket is properly installed -
ANSWERS-When performing an oil filter change on a vehicle with
a spin on oil filter, the technician must:
Voltage regulation - ANSWERS-A vehicle's battery prematurely
fails. A charging system output test shows the generator
(alternator) is producing a constant 16.0 volts. This could indicate
a failed:
Seal should be lubricated with transmission fluid - ANSWERS-A
transmission equipped with a filter is being serviced. When
installing the new filter, the:
Both A and B - ANSWERS-While inspecting the rear axle wheel
studs on a rear-wheel drive vehicle, the technician observed that
one stud is damaged. Technician A says that all the wheel studs
