AMMO CDC's Module 4 Review Questions
and Answers.
Before using an electric drill, what is the first thing you should
do? - Correct answers Make sure the diameter of the hole to be
drilled is within the capacity of the drill
The purpose of cutting lubricant in most drilling operations is to
increase the - Correct answers drilling speed and the drill bit life.
Which minimum articles of safety gear must be worn when using
a bench grinder? - Correct answers Eye and face protection
An electric saw blade must be operating at what speed before it
contacts the material being cut? - Correct answers Full
How many pounds per square inch (psi) of clean, dry air is
required at the tool end of the air hose to ensure the tool is
operating safely and efficiently? - Correct answers 90
What condition would prevent an operator from applying power to
a hoist or other powered lifting device? - Correct answers An Air
Force (AF) Form 979 is attached to the unit.
What should be worn anytime there is a potential for injury from
overhead objects during a lifting operation? - Correct answers
Protective helmets
What is the most common type of lifting sling used in the
munitions career field? - Correct answers Wire rope
, The following are all good safety practices to follow when using a
lifting sling except - Correct answers inspecting the sling by
passing your bare hand over the body of the sling.
The annunciators displayed on the Fluke 8025-series multimeter
are used to distinguish among - Correct answers ohms, kilohms,
and megohms.
When the MHU-141 trailer is loaded or towed with the hinged
deck panels open, what must be done? - Correct answers The
deck-panel supports must be properly positioned and locked in
place with quick-release pins
What are the two operational modes of the Fluke 8025-series
multimeter? - Correct answers Range and hold
The steering system on the MHU-141/M trailer has a turning
radius of how many degrees? - Correct answers 40
What is the maximum load capacity of the MHU-110/M trailer? -
Correct answers 15,000 pounds
The parking brake on the MHU-110/M is applied by - Correct
answers pulling either one of two hand levers located on each side
of the front of the trailer.
How many openings (hinged door panels) are on the deck of the
MHU-226 trailer? - Correct answers Three
What type of steering aids the MHU-226 in a tighter steering
radius? - Correct answers Four-wheel double Ackerman
After 463L pallets are positioned on a rollerized trailer, what can
you use to secure the pallets to the trailer? - Correct answers MB-1
chain assemblies and/or tie-down straps
and Answers.
Before using an electric drill, what is the first thing you should
do? - Correct answers Make sure the diameter of the hole to be
drilled is within the capacity of the drill
The purpose of cutting lubricant in most drilling operations is to
increase the - Correct answers drilling speed and the drill bit life.
Which minimum articles of safety gear must be worn when using
a bench grinder? - Correct answers Eye and face protection
An electric saw blade must be operating at what speed before it
contacts the material being cut? - Correct answers Full
How many pounds per square inch (psi) of clean, dry air is
required at the tool end of the air hose to ensure the tool is
operating safely and efficiently? - Correct answers 90
What condition would prevent an operator from applying power to
a hoist or other powered lifting device? - Correct answers An Air
Force (AF) Form 979 is attached to the unit.
What should be worn anytime there is a potential for injury from
overhead objects during a lifting operation? - Correct answers
Protective helmets
What is the most common type of lifting sling used in the
munitions career field? - Correct answers Wire rope
, The following are all good safety practices to follow when using a
lifting sling except - Correct answers inspecting the sling by
passing your bare hand over the body of the sling.
The annunciators displayed on the Fluke 8025-series multimeter
are used to distinguish among - Correct answers ohms, kilohms,
and megohms.
When the MHU-141 trailer is loaded or towed with the hinged
deck panels open, what must be done? - Correct answers The
deck-panel supports must be properly positioned and locked in
place with quick-release pins
What are the two operational modes of the Fluke 8025-series
multimeter? - Correct answers Range and hold
The steering system on the MHU-141/M trailer has a turning
radius of how many degrees? - Correct answers 40
What is the maximum load capacity of the MHU-110/M trailer? -
Correct answers 15,000 pounds
The parking brake on the MHU-110/M is applied by - Correct
answers pulling either one of two hand levers located on each side
of the front of the trailer.
How many openings (hinged door panels) are on the deck of the
MHU-226 trailer? - Correct answers Three
What type of steering aids the MHU-226 in a tighter steering
radius? - Correct answers Four-wheel double Ackerman
After 463L pallets are positioned on a rollerized trailer, what can
you use to secure the pallets to the trailer? - Correct answers MB-1
chain assemblies and/or tie-down straps
