The area where laminar becomes turbulent is called? - ANSWER
Transition region
Separation along an aerodynamic object occurs because -
ANSWER Because of adverse pressure gradient and the shape of
the object
Ground effect has a tendency to make an airplane behave like it
has a - ANSWER higher aspect ratio
When a wing is within 1/10 of its span to the surface, its
induced drag is reduced - ANSWER by nearly half
What are two forces that act parallel to the flight path in normal
flight - ANSWER Thrust and drag
L/Dmax occurs at a specific angle of attack - ANSWER True
,What happens to Vx and Vy as altitude increases? - ANSWER Vx
IAS increases, Vy IAS decreases
Wind is not a factor for - ANSWER Endurance
Which statement is true concerning airplanes - ANSWER
Parasite drag increases as velocity increases
Flying the "backside" of the power curve means that _______
decreases the _______ increases - ANSWER TAS, power
required
Climb performance is determined by the amount of - ANSWER
Excess power
What is an advantage of a steep approach angle of a shallow
approach angle? - ANSWER A steep angle allows you to clear
obstacles in the landing oath
Newton's 3rd law states that for every action there is an equal
and opposite reaction, this describes - ANSWER Thrust, and why
the airplane moves forward
, On landing - ANSWER The weight of the aircraft determines
frictional force
Landing roll distance depends on the - ANSWER All of these
What is an important characteristic of wind shear - ANSWER It
can be present at any level and can exist in both a horizontal
and vertical direction
During an approach, the most important and easily recognized
means of being alerted to possible wind shear is monitoring the
- ANSWER Power and vertical velocity required to remain on the
proper glide path
A microburst can have downward wind velocities as strong as -
ANSWER 6,000fpm
Where does your glide speed occur on the power required
curve - ANSWER Maximum L/D
What is the take off distance to clear a 50' obstacle using 0 flaps
- ANSWER 3,000