NIMS Test #1 Questions and Answers
Brush - Answer-The safest way to remove chips from a lathe or milling machine
Common injury from using a hand file - Answer-Being stabbed bu the tang (file without handle)
MSD - Answer-Material Safety Data Sheet (page 707)
NFPA - Answer-National Fire Protection Association
HMIS - Answer-Hazardous Material Identification System or Hazardous Material Information System
Green - Answer-The color that is not found on a HMIS label
Threshold Limit Value (TLV) - Answer-The safe limit of unprotected exposure to a material
MSDS information on new chemicals and materials found in the workplace can be reviewed and
discussed at? - Answer-Right to know seminars and classes, and safety meetings
, Occupational Safety and Health Administration (OSHA) - Answer-The acronym for the government
agency that regulates safety
Why are shops towels or oily rags stored in a red fireproof can with a lid? - Answer-To prevent fires
through spontaneous combustion
What is the first course of action for when a material (solid) becomes lodged in the eye? - Answer-Pull
the top lid over the bottom lid
Stop bleeding by applying pressure to the wound - Answer-The first action to take with a bleeding
wound
Lift with the legs and keep back straight - Answer-The best technique for lifting
What can happen while operating the lathe with long hair, dangling jewelry, or loose clothing? -
Answer-Operator can be pulled toward the machine if anything is caught
When working on material stored overhead using cranes or hoists, government safety regulations state
that a person must? - Answer-Wear a hard hat
When working on machinery producing flying chips, the most important PPE a machinist must wear is? -
Answer-Safety glasses
What should you do when operating a milling machine? - Answer-Adjust the work only when the cutter
is stopped
The best technique for milling on a vertical mill that is not equipped with an automatic table is to? -
Answer-Conventional Mill
Brush - Answer-The safest way to remove chips from a lathe or milling machine
Common injury from using a hand file - Answer-Being stabbed bu the tang (file without handle)
MSD - Answer-Material Safety Data Sheet (page 707)
NFPA - Answer-National Fire Protection Association
HMIS - Answer-Hazardous Material Identification System or Hazardous Material Information System
Green - Answer-The color that is not found on a HMIS label
Threshold Limit Value (TLV) - Answer-The safe limit of unprotected exposure to a material
MSDS information on new chemicals and materials found in the workplace can be reviewed and
discussed at? - Answer-Right to know seminars and classes, and safety meetings
, Occupational Safety and Health Administration (OSHA) - Answer-The acronym for the government
agency that regulates safety
Why are shops towels or oily rags stored in a red fireproof can with a lid? - Answer-To prevent fires
through spontaneous combustion
What is the first course of action for when a material (solid) becomes lodged in the eye? - Answer-Pull
the top lid over the bottom lid
Stop bleeding by applying pressure to the wound - Answer-The first action to take with a bleeding
wound
Lift with the legs and keep back straight - Answer-The best technique for lifting
What can happen while operating the lathe with long hair, dangling jewelry, or loose clothing? -
Answer-Operator can be pulled toward the machine if anything is caught
When working on material stored overhead using cranes or hoists, government safety regulations state
that a person must? - Answer-Wear a hard hat
When working on machinery producing flying chips, the most important PPE a machinist must wear is? -
Answer-Safety glasses
What should you do when operating a milling machine? - Answer-Adjust the work only when the cutter
is stopped
The best technique for milling on a vertical mill that is not equipped with an automatic table is to? -
Answer-Conventional Mill
