• ¿Documento equivocado? Cámbialo gratis
  • Escrito por estudiantes que aprobaron
  • Inmediatamente disponible después del pago
  • Leer en línea o como PDF
Vender
¿Dónde estudias?
Tu idioma
Document preview thumbnail
Vista previa 2 fuera de 15 páginas
Examen

Epa 608 Type Iii

Document preview thumbnail
Vista previa 2 fuera de 15 páginas

Identify the pressure corresponding to 32 degrees F for R-123: ________. A) 23 inches of Hg vacuum B) 20 inches of Hg vacuum C) 17 inches of Hg vacuum D) 11 inches of Hg vacuum - answer-b) 20 inches of Hg vacuum A hydrostatic tube test kit is used to: _________. A) blow all water from the tubes B) remove any water from the machine C) vent refrigerant D) determine if a tube leaks - answer-d) determine if a tube leaks Excessive running of a purge system on a low pressure chiller generally indicates that the: ___________. A) air sensors are faulty B) ambient temperature is too high C) efficiency of the purge unit is too low D) system is leaking - answer-d) system is leaking When recovering vapor from a low pressure refrigeration system: __________. A) water pumps should all be on, and the recovery compressor should be off B) system water pumps should be on, the recovery compressor should be on, and the recovery condenser water should be off C) the systems water pumps, the recovery compressor, and the recovery condenser water should all be on D) system water pumps should be off, and the recovery compressor should be on - answer-c) the systems water pumps, the recovery compressor, and the recovery condenser water should all be on ASHRAE Standard 15 - 1994 requires equipment room refrigerant sensors for what safety group classifications? A) A1 B) B2 C) A2 D) All refrigerant safety group classifications. - answer-d) All refrigerant safety group classifications If you are using a recovery machine manufactured BEFORE November 15, 1993, you must evacuate any low-pressure appliance to _______ before making a major repair. A) 0 psig B) 15 inches of Hg vacuum C) 25 inches of Hg vacuum D) 25mm of Hg absolute - answer-c) 25 inches of Hg vacuum A rupture disc on a recovery vessel for low pressure refrigerants relieves at: ________. A) 5 psig B) 10 psig C) 15 psig D) 20 psig - answer-c) 15 psig The primary water source for a recovery unit condensing coil is: _________. A) chilled water B) condenser water C) local municipal water supply D) de-ionized water - answer-c) local municipal water supply Which of the following repairs that would ALWAYS be considered "major" under EPA's regulations? A) replacement of an evaporator coil B) replacement of a filter-drier C) replacement of a switch D) replacement of a purge unit - answer-a) replacement of an evaporator coil According to the EPA, there is approximately ________ of refrigerant vapor left in an average 350 ton R-11 chiller at 0 psig pressure once all the R-11 liquid has been removed. A) None. B) 10 pounds. C) 20 pounds. D) 100 pounds. - answer-d) 100 pounds. A centrifugal chiller's rupture disk is connected to the chiller's: ________. A) condenser B) evaporator C) liquid line D) economizer - answer-b) evaporator When charging a chiller, refrigerant vapor is introduced into the system before charging with liquid. That is because: ___________. A) vapor charging increases pressure slowly, preventing failure of the rupture disc B) vapor charging is faster than liquid charging C) liquid charging is more difficult to control than vapor charging D) liquid charged into a deep vacuum will cause the refrigerant to boil and lower temperatures enough to freeze the water in the tubes - answer-d) liquid charged into a deep vacuum will cause the refrigerant to boil and lower temperatures enough to freeze the water in the tubes To determine how much vapor to charge into an evacuated chiller, you should charge with vapor until: __________. A) the system pressure corresponds to a refrigerant saturation temperature of 36 degrees F B) the recovery unit liquid level drops C) you have charged with vapor for 15 minutes D) the recovery unit pressure drops - answer-a) the system pressure corresponds to a refrigerant saturation temperature of 36 degrees F When there is excessive moisture collecting in the purge unit of a low pressure refrigeration s

Vista previa del contenido

EPA 608 Type III EXAM WITH ANSWERS
Identify the pressure corresponding to 32 degrees F for R-123: ________.

A) 23 inches of Hg vacuum
B) 20 inches of Hg vacuum
C) 17 inches of Hg vacuum
D) 11 inches of Hg vacuum - answer-b) 20 inches of Hg vacuum

A hydrostatic tube test kit is used to: _________.

A) blow all water from the tubes
B) remove any water from the machine
C) vent refrigerant
D) determine if a tube leaks - answer-d) determine if a tube leaks

Excessive running of a purge system on a low pressure chiller generally indicates that the:
___________.

A) air sensors are faulty
B) ambient temperature is too high
C) efficiency of the purge unit is too low
D) system is leaking - answer-d) system is leaking

When recovering vapor from a low pressure refrigeration system: __________.

A) water pumps should all be on, and the recovery compressor should be off
B) system water pumps should be on, the recovery compressor should be on, and the
recovery condenser water should be off
C) the systems water pumps, the recovery compressor, and the recovery condenser water
should all be on
D) system water pumps should be off, and the recovery compressor should be on - answer-
c) the systems water pumps, the recovery compressor, and the recovery condenser water
should all be on

ASHRAE Standard 15 - 1994 requires equipment room refrigerant sensors for what safety
group classifications?

A) A1
B) B2
C) A2
D) All refrigerant safety group classifications. - answer-d) All refrigerant safety group
classifications

If you are using a recovery machine manufactured BEFORE November 15, 1993, you must
evacuate any low-pressure appliance to _______ before making a major repair.

A) 0 psig
B) 15 inches of Hg vacuum
C) 25 inches of Hg vacuum
D) 25mm of Hg absolute - answer-c) 25 inches of Hg vacuum

A rupture disc on a recovery vessel for low pressure refrigerants relieves at: ________.

, A) 5 psig
B) 10 psig
C) 15 psig
D) 20 psig - answer-c) 15 psig

The primary water source for a recovery unit condensing coil is: _________.

A) chilled water
B) condenser water
C) local municipal water supply
D) de-ionized water - answer-c) local municipal water supply

Which of the following repairs that would ALWAYS be considered "major" under EPA's
regulations?

A) replacement of an evaporator coil
B) replacement of a filter-drier
C) replacement of a switch
D) replacement of a purge unit - answer-a) replacement of an evaporator coil

According to the EPA, there is approximately ________ of refrigerant vapor left in an average
350 ton R-11 chiller at 0 psig pressure once all the R-11 liquid has been removed.

A) None.
B) 10 pounds.
C) 20 pounds.
D) 100 pounds. - answer-d) 100 pounds.

A centrifugal chiller's rupture disk is connected to the chiller's: ________.

A) condenser
B) evaporator
C) liquid line
D) economizer - answer-b) evaporator

When charging a chiller, refrigerant vapor is introduced into the system before charging with
liquid. That is because: ___________.

A) vapor charging increases pressure slowly, preventing failure of the rupture disc
B) vapor charging is faster than liquid charging
C) liquid charging is more difficult to control than vapor charging
D) liquid charged into a deep vacuum will cause the refrigerant to boil and lower
temperatures enough to freeze the water in the tubes - answer-d) liquid charged into a deep
vacuum will cause the refrigerant to boil and lower temperatures enough to freeze the water
in the tubes

To determine how much vapor to charge into an evacuated chiller, you should charge with
vapor until: __________.

A) the system pressure corresponds to a refrigerant saturation temperature of 36 degrees F
B) the recovery unit liquid level drops
C) you have charged with vapor for 15 minutes
D) the recovery unit pressure drops - answer-a) the system pressure corresponds to a
refrigerant saturation temperature of 36 degrees F

Información del documento

Subido en
11 de noviembre de 2024
Número de páginas
15
Escrito en
2024/2025
Tipo
Examen
Contiene
Preguntas y respuestas
$11.99

¿Documento equivocado? Cámbialo gratis Dentro de los 14 días posteriores a la compra y antes de descargarlo, puedes elegir otro documento. Puedes gastar el importe de nuevo.
Escrito por estudiantes que aprobaron
Inmediatamente disponible después del pago
Leer en línea o como PDF

Seller avatar
Los indicadores de reputación están sujetos a la cantidad de artículos vendidos por una tarifa y las reseñas que ha recibido por esos documentos. Hay tres niveles: Bronce, Plata y Oro. Cuanto mayor reputación, más podrás confiar en la calidad del trabajo del vendedor.
TOPDOCTOR
5.0
(1)
Vendido
10
Seguidores
5
Artículos
3387
Última venta
1 año hace



Por qué los estudiantes eligen Stuvia

Creado por compañeros estudiantes, verificado por reseñas

Calidad en la que puedes confiar: escrito por estudiantes que aprobaron y evaluado por otros que han usado estos resúmenes.

¿No estás satisfecho? Elige otro documento

¡No te preocupes! Puedes elegir directamente otro documento que se ajuste mejor a lo que buscas.

Paga como quieras, empieza a estudiar al instante

Sin suscripción, sin compromisos. Paga como estés acostumbrado con tarjeta de crédito y descarga tu documento PDF inmediatamente.

Student with book image

“Comprado, descargado y aprobado. Así de fácil puede ser.”

Alisha Student

Preguntas frecuentes