• ¿Documento equivocado? Cámbialo gratis
  • Escrito por estudiantes que aprobaron
  • Inmediatamente disponible después del pago
  • Leer en línea o como PDF
Vender
¿Dónde estudias?
Tu idioma
Document preview thumbnail
Vista previa 1 fuera de 4 páginas
Examen

EPA 608 Practice exam Type 3

Document preview thumbnail
Vista previa 1 fuera de 4 páginas

The maximum test pressure for leak testing a low-pressure centrifugal chiller is - answer-10 psig Excessive operation of a purge system means - answer-The system has a leak on the sub-ambient pressure side of the system For a commercial refrigeration system with a charge of 50 pounds or more refrigerant, a substantial (or threshold) week rate will be reduced to ________ after January 1, 2019. - answer-20% For a comfort cooling system with a charge of 50 pounds or more of refrigerant, a substantial (or threshold) Leak rate will be reduced to _________ after January 1, 2019. - answer-10% According to the EPA, when all the R-123 liquid has been removed from an average 350 ton R-123 chiller and the system vapor pressure is 0 psig, the system contains - answer-100 pounds of refrigerant in the system When working with low pressure systems, the high-pressure cut off should be set to no more than _________ to avoid damaging the system or activating the pressure blow off device (rupture disk). - answer-10 psig The rupture discs on the low pressure chiller and on the recovery tank should relieve at __________ to prevent damage to the system during refrigerant transfer into or out of the system. - answer-15 psig If possible, the temperature of the equipment room where the chiller is located - answer-Should be increased to speed recovery When possible, oil in the chiller should be heated because - answer-Less refrigerant will be soluble and/or trapped in the oil at higher temperatures To prevent freezing, when recharging an evacuated water cooled chiller system with R-123, first charge with a vapor 20 pressure of at least - answer-20 in Hg vacuum When recharging a chiller, refrigerant is first added as a vapor followed by a liquid refrigerant to avoid - answer-Freezing of the water in the chiller barrels Replacing _________ is always considered a "major maintenance, service, or repair"? - answer-1.)An evaporator 2.) Condenser 3.)Compressor Low pressure systems must be evacuated to _________ before being discarded. - answer-25 mm of Hg absolute Every recovery and recycling unit must be - answer-Labeled as certified to meet EPA's requirements When disposing a system with a normal charge of more than 5 pounds and less than 50 pounds, the disposal record must be kept by the technician for - answer-3 years After reaching the required recovery vacuum, - answer-Wait a few minutes to see if the system pressure rises before opening the system up for repairs When does the EPA allow you to not evacuate to the prescribed level? - answer-When leaks in the appliance make evacuation to the prescribe level unattainable Replacement of __________ is always considered "major" under EPA's regulations. - answer-1.) A condenser 2.) A compressor 3.) An evaporator At 23.8 in Hg, r-123 boils at approximately: - answer-15°F What can you do to prevent air from entering an evacuated system? - answer-Introduce nitrogen into the evacuated system to maintain the system pressure slightly above atmospheric pressure The saturation pressure corresponding to 32°F for R-123 is - answer-20 inches of Hg vacuum According to the EPA, you should take an oil sample if - answer-The compressor has burned out Which of the following statements about R-1233zd is true? - answer-It is a SNAP approved replacement for low pressure centrifugal compressor systems and it can be used in new equipment where R-123 might have been used. ASHRAE standard 15 requires the use of rooms sensors and alarms to detect - answer-All refrigerant safety groups Which safety precautions should be adhered to for low pressure systems? - answer-Use gloves and safety goggles when working with liquid refrigerant. When pressurizing a low pressure system for a leak-detection purposes do not exceed - answer-10 psig Where is the purge unit located in a low pressure system? - answer-The top of the condenser When leak testing a low-pressure chiller the maximum pressure to use is - answer-10 psig What type of equipment can be worked on with type III certification? - answer-Low pressure In a low pressure chiller, air and other non-condensibles collect at the - answer-Top section of the condenser If a strong odor is detected during the recovery process - answer-A compressor burnout may have occurred Which organization establishes the refrigerant safety group standard? - answer-ASHRAE The EPA required evacuation level for recovery or recycling equipment used on low pressure systems is - answer-25 mm of Hg absolute When installing more than one, pressure relief valves must be installed - answer-In parallel with each other

Vista previa del contenido

EPA 608 Practice exam Type 3
The maximum test pressure for leak testing a low-pressure centrifugal chiller
is - answer-10 psig

Excessive operation of a purge system means - answer-The system has a
leak on the sub-ambient pressure side of the system

For a commercial refrigeration system with a charge of 50 pounds or more
refrigerant, a substantial (or threshold) week rate will be reduced to ________
after January 1, 2019. - answer-20%

For a comfort cooling system with a charge of 50 pounds or more of
refrigerant, a substantial (or threshold) Leak rate will be reduced to _________
after January 1, 2019. - answer-10%

According to the EPA, when all the R-123 liquid has been removed from an
average 350 ton R-123 chiller and the system vapor pressure is 0 psig, the
system contains - answer-100 pounds of refrigerant in the system

When working with low pressure systems, the high-pressure cut off should
be set to no more than _________ to avoid damaging the system or activating
the pressure blow off device (rupture disk). - answer-10 psig

The rupture discs on the low pressure chiller and on the recovery tank should
relieve at __________ to prevent damage to the system during refrigerant
transfer into or out of the system. - answer-15 psig

If possible, the temperature of the equipment room where the chiller is
located - answer-Should be increased to speed recovery

When possible, oil in the chiller should be heated because - answer-Less
refrigerant will be soluble and/or trapped in the oil at higher temperatures

To prevent freezing, when recharging an evacuated water cooled chiller
system with R-123, first charge with a vapor 20 pressure of at least - answer-
20 in Hg vacuum

When recharging a chiller, refrigerant is first added as a vapor followed by a
liquid refrigerant to avoid - answer-Freezing of the water in the chiller barrels

Replacing _________ is always considered a "major maintenance, service, or
repair"? - answer-1.)An evaporator 2.) Condenser 3.)Compressor

Información del documento

Subido en
11 de noviembre de 2024
Número de páginas
4
Escrito en
2024/2025
Tipo
Examen
Contiene
Preguntas y respuestas
$9.49

¿Documento equivocado? Cámbialo gratis Dentro de los 14 días posteriores a la compra y antes de descargarlo, puedes elegir otro documento. Puedes gastar el importe de nuevo.
Escrito por estudiantes que aprobaron
Inmediatamente disponible después del pago
Leer en línea o como PDF

Seller avatar
Los indicadores de reputación están sujetos a la cantidad de artículos vendidos por una tarifa y las reseñas que ha recibido por esos documentos. Hay tres niveles: Bronce, Plata y Oro. Cuanto mayor reputación, más podrás confiar en la calidad del trabajo del vendedor.
TOPDOCTOR
5.0
(1)
Vendido
10
Seguidores
5
Artículos
3387
Última venta
1 año hace



Por qué los estudiantes eligen Stuvia

Creado por compañeros estudiantes, verificado por reseñas

Calidad en la que puedes confiar: escrito por estudiantes que aprobaron y evaluado por otros que han usado estos resúmenes.

¿No estás satisfecho? Elige otro documento

¡No te preocupes! Puedes elegir directamente otro documento que se ajuste mejor a lo que buscas.

Paga como quieras, empieza a estudiar al instante

Sin suscripción, sin compromisos. Paga como estés acostumbrado con tarjeta de crédito y descarga tu documento PDF inmediatamente.

Student with book image

“Comprado, descargado y aprobado. Así de fácil puede ser.”

Alisha Student

Preguntas frecuentes