Pipefitter Nccer V4
Study Guide.
OSHA approved anchorage point - ✔✔✔ANSWER-when working from a
suspended scaffold, wear a safety belt that is securely tied to the
3 1/2 - ✔✔✔ANSWER-a toe board must be what minimum height to comply with
OSHA safety standards for scaffolding?
30 PSI - ✔✔✔ANSWER-What maximum Air pressure may be used for cleaning?
18.21 in. - ✔✔✔ANSWER-A tank has a diameter of 58ft, the circumference of the
tank is 182.23ft, one degree of diameter equals 6.07 in.
Three degrees of diameter will equal?
6'-8 5/8" - ✔✔✔ANSWER-A piece of 2" pipe is being cut to run between two 90
Degree threaded fittings, the center to center measurement of the fittings is 7'-2
1/2"
What is the cut length of the pipe?
, 7.3750 in. - ✔✔✔ANSWER-Convert 7 3/8" to decimal equivalent
255 Sq.Ft - ✔✔✔ANSWER-what is the area of a rectangle that is 25'-6" long and
10'-0" wide? ( A= W x L )
40 Sq.FT - ✔✔✔ANSWER-what is the sq. footage of the surface area of a steel
plate measuring 120 in. long by 48 in. wide?
119'-3 1/2" - ✔✔✔ANSWER-A 14" SCH carbon steel pipe is being installed in a
pipe rack. The center line elevation of the pipe will be 120' -3 1/2". what will the
bottom of pipe elevation be?
4.67 ft - ✔✔✔ANSWER-The decimal of 56in. is
401.1 - ✔✔✔ANSWER-A tank holding 3,000 Gal. of water contains of many cu.ft.
of water? ( one Gal. equals 0.1337 cu. ft)
.25 - ✔✔✔ANSWER-How much is 3" in hundredths of a foot?
Use two rigging sling that are double wrapped and chocked one chocker is placed
about 5ft from each end of the bundle - ✔✔✔ANSWER-which of the following
methods could be used to rig a 20 foot long bundle of six rebar rods that will be
pick up by a small crane?
three feet - ✔✔✔ANSWER-ladders use with scaffolding must extend above the
landing from a minimum distance of
Study Guide.
OSHA approved anchorage point - ✔✔✔ANSWER-when working from a
suspended scaffold, wear a safety belt that is securely tied to the
3 1/2 - ✔✔✔ANSWER-a toe board must be what minimum height to comply with
OSHA safety standards for scaffolding?
30 PSI - ✔✔✔ANSWER-What maximum Air pressure may be used for cleaning?
18.21 in. - ✔✔✔ANSWER-A tank has a diameter of 58ft, the circumference of the
tank is 182.23ft, one degree of diameter equals 6.07 in.
Three degrees of diameter will equal?
6'-8 5/8" - ✔✔✔ANSWER-A piece of 2" pipe is being cut to run between two 90
Degree threaded fittings, the center to center measurement of the fittings is 7'-2
1/2"
What is the cut length of the pipe?
, 7.3750 in. - ✔✔✔ANSWER-Convert 7 3/8" to decimal equivalent
255 Sq.Ft - ✔✔✔ANSWER-what is the area of a rectangle that is 25'-6" long and
10'-0" wide? ( A= W x L )
40 Sq.FT - ✔✔✔ANSWER-what is the sq. footage of the surface area of a steel
plate measuring 120 in. long by 48 in. wide?
119'-3 1/2" - ✔✔✔ANSWER-A 14" SCH carbon steel pipe is being installed in a
pipe rack. The center line elevation of the pipe will be 120' -3 1/2". what will the
bottom of pipe elevation be?
4.67 ft - ✔✔✔ANSWER-The decimal of 56in. is
401.1 - ✔✔✔ANSWER-A tank holding 3,000 Gal. of water contains of many cu.ft.
of water? ( one Gal. equals 0.1337 cu. ft)
.25 - ✔✔✔ANSWER-How much is 3" in hundredths of a foot?
Use two rigging sling that are double wrapped and chocked one chocker is placed
about 5ft from each end of the bundle - ✔✔✔ANSWER-which of the following
methods could be used to rig a 20 foot long bundle of six rebar rods that will be
pick up by a small crane?
three feet - ✔✔✔ANSWER-ladders use with scaffolding must extend above the
landing from a minimum distance of
