AUTOMOTIVE COLLISION ASE PRACTICE EXAM
ACTUAL EXAM COMPLETE QUESTIONS AND
CORRECT DETAILED ANSWERS (VERIFIED
ANSWERS) |ALREADY GRADED A+||BRAND
NEW!!.
Which of these terms may be used to describe a cut-and join sectionong
location with no backing?
A. rolled sleeve
B. short sleeve
C. closed butt
D. open butt ✔✔CORRECT ANSWER✔✔D. open butt
An outer rocker panel is being sectioned on a utilized vehicle. The
preferred method of reattaching the part would be:
A. industry standard generic welding guidelines
B. vehicle specific welding guidelines
C. AWS welding guidelines
D. welder manufacture guidelines ✔✔CORRECT ANSWER✔✔B. vehicle
specific welding guidelines
, On a vehicle that has suffered a severe rear end collision, the technician
notices damage to the motor mounts. This would be considered:
A. primary damage
B. direct damage
C. inertial damage
D. lateral damage ✔✔CORRECT ANSWER✔✔C. inertia damage
An aluminum exterior panel has a dent that is to be repaired. Technician
A says that it is acceptable to use the same metal file for steel as for
aluminum. Technician B says that it is acceptable to use aluminum filler
for the repair. Who is right? ✔✔CORRECT ANSWER✔✔D. Neither A nor
B
Metal repairs are being made on a fender. Technician A says that the
dolly to perform the repair should match the contour of the panel.
Technician B says that picks and spoons should not be used to repair the
panel. Who is right?
A. A only
B. B only
C. Both A and B
D. Neither A nor b ✔✔CORRECT ANSWER✔✔A. A only
Technician A says that when replacing a door skin, the door glass should
be removed. Technician B says that when replacing a door skin, it's not
necessary to test fit the door to the vehicle. Who is right?
ACTUAL EXAM COMPLETE QUESTIONS AND
CORRECT DETAILED ANSWERS (VERIFIED
ANSWERS) |ALREADY GRADED A+||BRAND
NEW!!.
Which of these terms may be used to describe a cut-and join sectionong
location with no backing?
A. rolled sleeve
B. short sleeve
C. closed butt
D. open butt ✔✔CORRECT ANSWER✔✔D. open butt
An outer rocker panel is being sectioned on a utilized vehicle. The
preferred method of reattaching the part would be:
A. industry standard generic welding guidelines
B. vehicle specific welding guidelines
C. AWS welding guidelines
D. welder manufacture guidelines ✔✔CORRECT ANSWER✔✔B. vehicle
specific welding guidelines
, On a vehicle that has suffered a severe rear end collision, the technician
notices damage to the motor mounts. This would be considered:
A. primary damage
B. direct damage
C. inertial damage
D. lateral damage ✔✔CORRECT ANSWER✔✔C. inertia damage
An aluminum exterior panel has a dent that is to be repaired. Technician
A says that it is acceptable to use the same metal file for steel as for
aluminum. Technician B says that it is acceptable to use aluminum filler
for the repair. Who is right? ✔✔CORRECT ANSWER✔✔D. Neither A nor
B
Metal repairs are being made on a fender. Technician A says that the
dolly to perform the repair should match the contour of the panel.
Technician B says that picks and spoons should not be used to repair the
panel. Who is right?
A. A only
B. B only
C. Both A and B
D. Neither A nor b ✔✔CORRECT ANSWER✔✔A. A only
Technician A says that when replacing a door skin, the door glass should
be removed. Technician B says that when replacing a door skin, it's not
necessary to test fit the door to the vehicle. Who is right?
