Exam Complete Solutions
What fire hydrant has water filled up to the nut? - ANS-Wet Barrel Keep apparatus
away from trenches to avoid? - ANS-Secondary Collapse Which standpipe class is
only meant for use by the fire department? - ANS-Class 1
National Fire incident reporting system use ____ for run codes? - ANS-Standardized
Codes
What is interference with evidence? - ANS-Spoliation
What hose roll is compact and easy to carry? - ANS-Twin Donut Roll
How do you properly dry hose? - ANS-Hang them
LPG is _____ in its natural form? - ANS-Gas
Fire that has used all its oxygen and fuel load is in what stage? - ANS-Decay How
many feet should your ladder be when operating near power lines? - ANS-10 Feet
What type of rope construction is required for life safety? - ANS-Block Creel What is L
in LUNAR? - ANS-Location
What is N in LUNAR? - ANS-Name
What are the structural supports at the rungs? - ANS-Beams
What happens when life safety rope is deemed unserviceable? - ANS-Downgrade to
utility rope
After inspecting the portable generator what is the last step? - ANS-Complete
Documents
,Standard for retroreflective vest? - ANS-ANSI 207/107
Fire standard for fire gloves? - ANS-NFPA 1971
Fire standard for Life and Safety? - ANS-NFPA 1500
Which company rescues victims and downed firefighters? - ANS-Rescue Company
Which construction company always have a collapse zone? - ANS-Type V What
tool is used to shear off locks? - ANS-K tool
Master streams flows how much water? - ANS-350 GPMs
How do you fight a car fire? - ANS-Uphill
A slab door can be? - ANS-Solid or Hollow core
How do you face the fire truck in traffic? - ANS-Facing away from traffic
What type of structural collapse occurs when the floor and/or roof assemblies on both
sides of a load-bearing wall collapse, allowing a good chance of victim survival? -
ANS-A-frame
In the OATH method of signaling on a search line, two tugs represents - ANS-A
- advance
Which of the following is an example of a push/pull tool? - ANS-Pike pole
Cutting edges on axes should be inspected for: - ANS-chips, cracks, or spurs
When caring for an unprotected metal surface, use a metal file to: - ANS-remove burrs
from cutting edge.
NFPA® 1931 requires that single, roof combination and extension ladders must support
a maximum load of: - ANS-750 lbs. (340 kg)
Ground ladders should be service tested before being placed in service, ___ while in
service, and after use that exposes the ladder to high heat or rough treatment. -
, ANS-once each year
Which of the following describes the BEST placement of a ladder to be used for entry or
rescue from a window? - ANS-Ladder tip slightly below sill, or wedged under sill lip
Which of the following is a reason that modern construction may tend to contain fires for
longer periods of time? - ANS-Energy efficient designs
What should a firefighter do before stepping off a ladder, parapet wall, or other place of
safety onto the roof of a burning building, especially if the roof surface is obscured by
smoke or darkness? - ANS-Sound the roof for structural integrity by striking with an axe
What type of hose is designed for drafting water from static water supplies or
connecting to a fire hydrant? - ANS-Hard-suction hose
What type of fire hose damage can weaken the jacket which can lead to ruptures under
pressure? - ANS-Organic damage
Which of the following equipment is necessary for service testing? - ANS-Nozzles with
shutoff valves
The test site for service testing should be: - ANS-on a slight grade.
Which of the following procedures should be followed when service testing fire hose? -
ANS-Stand away from the discharge valve connection when charging hose
Which action of firefighting foam creates a barrier between the fuel and the fire? -
ANS-Separating
Foam lowers surface tension of water, allowing it to ___ fires in Class A materials.
- ANS-penetrate
Class A foam extinguishes and/or prevents ignition by: - ANS-allowing water to
penetrate fuels.
When applied to solid fuels, Class A foam blankets the fuel, controls flames, then: -
ANS-breaks down, releasing water to cool the fuel.
Class B foams are especially effective on: - ANS-hydrocarbon fuels and polar solvents.
What fire hydrant has water filled up to the nut? - ANS-Wet Barrel Keep apparatus
away from trenches to avoid? - ANS-Secondary Collapse Which standpipe class is
only meant for use by the fire department? - ANS-Class 1
National Fire incident reporting system use ____ for run codes? - ANS-Standardized
Codes
What is interference with evidence? - ANS-Spoliation
What hose roll is compact and easy to carry? - ANS-Twin Donut Roll
How do you properly dry hose? - ANS-Hang them
LPG is _____ in its natural form? - ANS-Gas
Fire that has used all its oxygen and fuel load is in what stage? - ANS-Decay How
many feet should your ladder be when operating near power lines? - ANS-10 Feet
What type of rope construction is required for life safety? - ANS-Block Creel What is L
in LUNAR? - ANS-Location
What is N in LUNAR? - ANS-Name
What are the structural supports at the rungs? - ANS-Beams
What happens when life safety rope is deemed unserviceable? - ANS-Downgrade to
utility rope
After inspecting the portable generator what is the last step? - ANS-Complete
Documents
,Standard for retroreflective vest? - ANS-ANSI 207/107
Fire standard for fire gloves? - ANS-NFPA 1971
Fire standard for Life and Safety? - ANS-NFPA 1500
Which company rescues victims and downed firefighters? - ANS-Rescue Company
Which construction company always have a collapse zone? - ANS-Type V What
tool is used to shear off locks? - ANS-K tool
Master streams flows how much water? - ANS-350 GPMs
How do you fight a car fire? - ANS-Uphill
A slab door can be? - ANS-Solid or Hollow core
How do you face the fire truck in traffic? - ANS-Facing away from traffic
What type of structural collapse occurs when the floor and/or roof assemblies on both
sides of a load-bearing wall collapse, allowing a good chance of victim survival? -
ANS-A-frame
In the OATH method of signaling on a search line, two tugs represents - ANS-A
- advance
Which of the following is an example of a push/pull tool? - ANS-Pike pole
Cutting edges on axes should be inspected for: - ANS-chips, cracks, or spurs
When caring for an unprotected metal surface, use a metal file to: - ANS-remove burrs
from cutting edge.
NFPA® 1931 requires that single, roof combination and extension ladders must support
a maximum load of: - ANS-750 lbs. (340 kg)
Ground ladders should be service tested before being placed in service, ___ while in
service, and after use that exposes the ladder to high heat or rough treatment. -
, ANS-once each year
Which of the following describes the BEST placement of a ladder to be used for entry or
rescue from a window? - ANS-Ladder tip slightly below sill, or wedged under sill lip
Which of the following is a reason that modern construction may tend to contain fires for
longer periods of time? - ANS-Energy efficient designs
What should a firefighter do before stepping off a ladder, parapet wall, or other place of
safety onto the roof of a burning building, especially if the roof surface is obscured by
smoke or darkness? - ANS-Sound the roof for structural integrity by striking with an axe
What type of hose is designed for drafting water from static water supplies or
connecting to a fire hydrant? - ANS-Hard-suction hose
What type of fire hose damage can weaken the jacket which can lead to ruptures under
pressure? - ANS-Organic damage
Which of the following equipment is necessary for service testing? - ANS-Nozzles with
shutoff valves
The test site for service testing should be: - ANS-on a slight grade.
Which of the following procedures should be followed when service testing fire hose? -
ANS-Stand away from the discharge valve connection when charging hose
Which action of firefighting foam creates a barrier between the fuel and the fire? -
ANS-Separating
Foam lowers surface tension of water, allowing it to ___ fires in Class A materials.
- ANS-penetrate
Class A foam extinguishes and/or prevents ignition by: - ANS-allowing water to
penetrate fuels.
When applied to solid fuels, Class A foam blankets the fuel, controls flames, then: -
ANS-breaks down, releasing water to cool the fuel.
Class B foams are especially effective on: - ANS-hydrocarbon fuels and polar solvents.
