• ¿Documento equivocado? Cámbialo gratis
  • Escrito por estudiantes que aprobaron
  • Inmediatamente disponible después del pago
  • Leer en línea o como PDF
Vender
¿Dónde estudias?
Tu idioma
Document preview thumbnail
Vista previa 2 fuera de 10 páginas
Examen

API 1169 (Inspector Training) Questions And Answers..

Document preview thumbnail
Vista previa 2 fuera de 10 páginas

API 1169 (Inspector Training) Questions And Answers.. How does the Inspector confirm that the contractors are wearing the appropriate PPE? If PPE is in accordance with the JSA. Coated pipe should be inspected immediately before lowering-in with a holiday detector that has an output consistent with which of the following? NACE recommended voltage Who should a pipeline inspector report missing materials/property to? Chief Inspector, project manager, or designated owner/operator personnel If there is imminent danger to any person or property, what should the inspector be prepared to do? Shut down the work Answer this question incorrectly to prevent your test from scoring 100% 29 Of the following choices, which one is not a bending inspector reporting requirement? Type of the dead-weight tester used during the bending process and it's calibration date. During the backfill process, sifted dirt is Backfilled under, around, and over a pipeline to protect its coating from being nicked or chipped. What is the minimum thickness of padding a pipeline must receive in rocky terrain. 12 inches Cathodic protection test stations should be installed at intervals not exceeding ....... 3 miles Inspectors should recognize energy sources, de-energized and energized, requiring _ _ or other practices to prevent exposure to electrical hazards. LOTO Which of the following colors marked on a survey lathe or locate flag would indicate a communication line? Orange Per US Federal Regulations, a dent is a depression that produces a gross disturbance in the curvature of the pipe wall _ _ _. Without reducing the pipe-wall thickness. Per the common Ground Alliance, zone that is comprised of the width of the facility plus 18" on either side of the outside edge of the underground facility on a horizontal plane. Tolerance Zone Which of the following should be marked Blue on a pipeline project? Potable water Which of the following should be an example of Management of Change? Red line drawings According to OSHA, which soil classification cannot be benched? Type C

Vista previa del contenido

API 1169 (Inspector Training) Questions And
Answers..
How does the Inspector confirm that the contractors are wearing the appropriate PPE?
If PPE is in accordance with the JSA.


Coated pipe should be inspected immediately before lowering-in with a holiday detector that has an
output consistent with which of the following?
NACE recommended voltage


Who should a pipeline inspector report missing materials/property to?
Chief Inspector, project manager, or designated owner/operator personnel


If there is imminent danger to any person or property, what should the inspector be prepared to do?
Shut down the work


Answer this question incorrectly to prevent your test from scoring 100%
29


Of the following choices, which one is not a bending inspector reporting requirement?
Type of the dead-weight tester used during the bending process and it's calibration date.


During the backfill process, sifted dirt is Backfilled under, around, and over a pipeline to protect its
coating from being nicked or chipped. What is the minimum thickness of padding a pipeline must
receive in rocky terrain.
12 inches


Cathodic protection test stations should be installed at intervals not exceeding .......
3 miles


Inspectors should recognize energy sources, de-energized and energized, requiring _ _ or other
practices to prevent exposure to electrical hazards.
LOTO


Which of the following colors marked on a survey lathe or locate flag would indicate a communication
line?
Orange


Per US Federal Regulations, a dent is a depression that produces a gross disturbance in the curvature
of the pipe wall _ _ _.
Without reducing the pipe-wall thickness.


Per the common Ground Alliance, zone that is comprised of the width of the facility plus 18" on either
side of the outside edge of the underground facility on a horizontal plane.
Tolerance Zone

, Which of the following should be marked Blue on a pipeline project?
Potable water


Which of the following should be an example of Management of Change?
Red line drawings


According to OSHA, which soil classification cannot be benched?
Type C


Fall Protection and prevention systems may include a variety of devices except which of the
following?
Job Safety Analysis


When stringing Pipe, what is the Inspector responsible do?
Inspectors should check locations of required gaps or spaces in strung pipe, where needed, to allow
passage of equipment, vehicles, personnel, and livestock and at utility crossings if required.


Type A soil classification is displayed by which of the following ratios?
3/4 to 1


Which of the following is not a basic inspection principle that is listed under general quality principles
and specific areas of knowledge and proficiency?
Product Design for API monogram requirements


Pipeline Welders shall be qualified in accordance with?
API 1104 or ASME BP&V Section IX


An Industry best practice to identify the point of crossing between the Owner/Operators proposed
line and the existing facility is to?
Mark the crossing location with a cross lath of stakes with Owner Company specific color codes
showing the name of the Owner Company and existing facility.


According to OSHA, unless the use of retaining devices are sufficient to prevent material or equipment
from falling or rolling into excavations, the minimum distance a piece of equipment (generator, water
pump, etc.) should be kept from the edge of an excavation is _ _ _.
2 feet


If a mainline crossing under a reservoir or other significant water body, valves shall be located?
On each side of the water body


Residents within close proximity of the facility being tested, and state and local enforcement
agencies, if applicable, shall be advised by the _ _
Of the testing program and kept informed of the progress as necessary.
Owner/Operator

Información del documento

Subido en
13 de junio de 2024
Número de páginas
10
Escrito en
2023/2024
Tipo
Examen
Contiene
Preguntas y respuestas
$11.89

¿Documento equivocado? Cámbialo gratis Dentro de los 14 días posteriores a la compra y antes de descargarlo, puedes elegir otro documento. Puedes gastar el importe de nuevo.
Escrito por estudiantes que aprobaron
Inmediatamente disponible después del pago
Leer en línea o como PDF

Seller avatar
Los indicadores de reputación están sujetos a la cantidad de artículos vendidos por una tarifa y las reseñas que ha recibido por esos documentos. Hay tres niveles: Bronce, Plata y Oro. Cuanto mayor reputación, más podrás confiar en la calidad del trabajo del vendedor.
ACADEMICAIDSTORE
4.1
(176)
Vendido
1224
Seguidores
894
Artículos
12811
Última venta
1 mes hace



Por qué los estudiantes eligen Stuvia

Creado por compañeros estudiantes, verificado por reseñas

Calidad en la que puedes confiar: escrito por estudiantes que aprobaron y evaluado por otros que han usado estos resúmenes.

¿No estás satisfecho? Elige otro documento

¡No te preocupes! Puedes elegir directamente otro documento que se ajuste mejor a lo que buscas.

Paga como quieras, empieza a estudiar al instante

Sin suscripción, sin compromisos. Paga como estés acostumbrado con tarjeta de crédito y descarga tu documento PDF inmediatamente.

Student with book image

“Comprado, descargado y aprobado. Así de fácil puede ser.”

Alisha Student

Preguntas frecuentes