NIMS CNC Mill Certification
A drill chuck style tool holder can be used to hold smaller endmills (T/F) - ANS-False
Activates circular interpolation clockwise - ANS-G02
Activates circular interpolation counterclockwise - ANS-G03
Activates deep-hole peck drilling cycle - ANS-G83
Activates fast-peck drilling cycle - ANS-G73
Activates linear interpolation - ANS-G01
Activates single-pass drilling - ANS-G81
Activates single-pass drilling with dwell - ANS-G82
At this depth, peck drilling should be used instead of single pass drilling - ANS-3 times
the diameter of the drill bit
Attributes of a collet style tool holder - ANS-Provide minimal runout but also have
minimal holding power. Should not be used in high torque operations.
Coolant off - ANS-M09
Coolant on - ANS-M08
Indicates end of canned cycle - ANS-G80
Indicates the Z coordinate that a tool returns to after each operation in a canned cycle -
ANS-R-value/R-plane
P-word value that equals one second - ANS-P1000
Plunge Cutting - ANS-When a endmill is plunged directly into the material, similar to a
drill bit.
Sets the distance drilled in-between each peck cycle - ANS-Q-word
A drill chuck style tool holder can be used to hold smaller endmills (T/F) - ANS-False
Activates circular interpolation clockwise - ANS-G02
Activates circular interpolation counterclockwise - ANS-G03
Activates deep-hole peck drilling cycle - ANS-G83
Activates fast-peck drilling cycle - ANS-G73
Activates linear interpolation - ANS-G01
Activates single-pass drilling - ANS-G81
Activates single-pass drilling with dwell - ANS-G82
At this depth, peck drilling should be used instead of single pass drilling - ANS-3 times
the diameter of the drill bit
Attributes of a collet style tool holder - ANS-Provide minimal runout but also have
minimal holding power. Should not be used in high torque operations.
Coolant off - ANS-M09
Coolant on - ANS-M08
Indicates end of canned cycle - ANS-G80
Indicates the Z coordinate that a tool returns to after each operation in a canned cycle -
ANS-R-value/R-plane
P-word value that equals one second - ANS-P1000
Plunge Cutting - ANS-When a endmill is plunged directly into the material, similar to a
drill bit.
Sets the distance drilled in-between each peck cycle - ANS-Q-word
