Nccer Millwright Practice Exam 2
unusual If the seal was not properly aligned or there is excessive wear in some bearing or shaft,_______ wear tracks will be the indicator sharpened brass putty knife For removing hard to remove gasket materials found on sealing surfaces, ______ is recommended Conducted on the job Apprenticeship training is_______ distance Charting alignment on a graph requires a chart that is divided into thousandths of an inch vertically for the indicator readings and into whole inches horizontally for the__________ hidden The orthographic drawing may contain a dashed or _______ line Radiation In order to shoot through a test object and project an image onto a detector or a sheet of film, radiography uses a source of penetrating called _______ *scribe circles *transfer measurements *compare distances measure angles Which of the following task would you not perform with dividers? 10% The over speed trip device is actuated when the turbine reaches a predetermined limit usually _________% above normal full-load speed high Positive results in an offset measurement mean that the MTBM is _____ or on the 3-o'clock side. offset m
Información del documento
- Subido en
- 28 de abril de 2024
- Número de páginas
- 12
- Escrito en
- 2023/2024
- Tipo
- Examen
- Contiene
- Preguntas y respuestas
