Pipefitter Nccer V4 study guide (A+ GUARANTEED)

OSHA approved anchorage point correct answers when working from a suspended scaffold, wear a safety belt that is securely tied to the 3 1/2 correct answers a toe board must be what minimum height to comply with OSHA safety standards for scaffolding? 30 PSI correct answers What maximum Air pressure may be used for cleaning? 18.21 in. correct answers A tank has a diameter of 58ft, the circumference of the tank is 182.23ft, one degree of diameter equals 6.07 in. Three degrees of diameter will equal? 6'-8 5/8" correct answers A piece of 2" pipe is being cut to run between two 90 Degree threaded fittings, the center to center measurement of the fittings is 7'-2 1/2" What is the cut length of the pipe? 7.3750 in. correct answers Convert 7 3/8" to decimal equivalent 255 Sq.Ft correct answers what is the area of a rectangle that is 25'-6" long and 10'-0" wide? ( A= W x L ) 40 Sq.FT correct answers what is the sq. footage of the surface area of a steel plate measuring 120 in. long by 48 in. wide? 119'-3 1/2" correct answers A 14" SCH carbon steel pipe is being installed in a pipe rack. The center line elevation of the pipe will be 120' -3 1/2". what will the bottom of pipe elevation be? 4.67 ft correct answers The decimal of 56in. is 401.1 correct answers A tank holding 3,000 Gal. of water contains of many . of water? ( one Gal. equals 0.1337 cu. ft) .25 correct answers How much is 3" in hundredths of a foot? Use two rigging sling that are double wrapped and chocked one chocker is placed about 5ft from each end of the bundle correct answers which of the following methods could be used to rig a 20 foot long bundle of six rebar rods that will be pick up by a small crane? three feet correct answers ladders use with scaffolding must extend above the landing from a minimum distance of