• ¿Documento equivocado? Cámbialo gratis
  • Escrito por estudiantes que aprobaron
  • Inmediatamente disponible después del pago
  • Leer en línea o como PDF
Vender
¿Dónde estudias?
Tu idioma
Document preview thumbnail
Vista previa 2 fuera de 7 páginas
Examen

C125 Midterm Revision

Document preview thumbnail
Vista previa 2 fuera de 7 páginas

Interpolation - Answer- estimating a value within the range of measured data extrapolation - Answer- projection; conjecture; V. extrapolate: infer (unknown information) from known information best fit line equation commonly takes y=mx+b format. What are your y, x, and b? - Answer- y = dependent variable (v) x = independent (n) m = slope (RT/P) b = intercept In assignment 2 (excel), students are asked to obtain the slope and intercept by rearranging the Ideal Gas Equation into y=mx+b format. The other way of achieving this goal is based on the definition of slope and y intercept. Y-intercept is where the line crosses the y-axis. In another word, it is the y-value when x=0. What is the y-intercept in assignment 2 based on this definition? - Answer- 0 In assignment 2 (excel), students are asked to obtain the slope and intercept by rearranging the Ideal Gas Equation into y=mx+b format. The other way of achieving this goal is based on the definition of slope and y intercept. The slope is defined by equation 2. When the y-intercept is 0, the slope is y/x. What is the slope in assignment 2 based on this information? Compare the slope and y-intercept obtained here to what you obtained in assignment 2. - Answer- RT/P They are the same In assignment 3 (excel), to obtain the density, which has to be the independent variable and hence be plotted on the x-axis? Which has to be the dependent variable? - Answer- independent variable = x = v (D=m/v, slope=y/x) How can the density be obtained from the graph (excel)? - Answer- Density can be found by looking at the slope R^2 - Answer- the proportion (percent) of the variation in the values of y that can be accounted for by the least squares regression line regression analysis - Answer- An analytic technique where a series of input variables are examined in relation to their corresponding output results in order to develop a mathematical or statistical relationship. What are slopes and intercepts of the following equation if time t is plotted on a-axis and lnN is plotted on y-axis? ln(N/N0) = -kt - Answer- slope = -k y-intercept = lnN0 In atomic spectra lab, Vernier angles (V) in degrees of a Hg-lamp has a linear dependence on wavelength in nm of line spectra: V = .146(wavelength) - 10.85 Predict the Vernier angle in degree for a line that has a wavelength of 510 nm - Answer- v = .146(510) - 10.85 v = 63.61 degrees In atomic spectra lab, Vernier angles (V) in degrees of a Hg-lamp has a linear dependence on wavelength in nm of line spectra: V = .146(wavelength) - 10.85 If a student found a line at Vernier angle of 76.5 degrees, what is the wavelength in nm of this line? - Answer- 76.5 = .146(wavelength) - 10.85 wavelength = 599nm On a linear regression analysis data table, where can you find m in y=mx+b? Where can you find b? - Answer- X intercept 1 Intercept Define accuracy - Answer- how close a measured value is to an accepted value Define precision - Answer- how close a series of measurements are to one another mean +/- standard deviation 3 steps - Answer- 1. round your std. deviation to contain only one significant digit (the left-most non-zero digit) 2. round your mean to the only non-zero digit the std. deviation has 3. include proper units if the mean is .98795 g/mL and the std. deviation is .00572 g/mL, how is it reported? - Answer- .988 +/- .006 g/mL % error - Answer- absolute value of the experimental value - literature value divided by the literature value Why is water from the carboy used and not from the DI tap? - Answer- We needed a consistent temperature from the water to get an accurate density Why should you not touch the weighing beaker with bare hands after weighing it? - Answer- Touching the weighing beaker with bare hands could affect the weight and become a source of error Why is it important to use the same balance when performing your weighing? - Answer- each balance is calibrated different so using different balances could affect the results If a student purposefully used 20-mL aliquot for all his trials instead of 10-mL, how will this affect the experimental result? Why? - Answer- The student would be doubling the results by going against procedure what is used to present precision? - Answer- standard deviation what is used to characterize accuracy? - Answer- percent error Round the following to the nearest hundredth using the more statistically sound convention: .335 1.02502 10.0050 7.655 - Answer- .36 1.03 10.01 7.66 A student measured the density of a metal in four trials and the density of each trial is given below. Calculate the mean, standard deviation and report them in the correct format with proper number of sig figs. 2.65 2.52 2.85 2.74 - Answer- 2.7 +/- .01 A piece of metal weighs 15.38g. It was placed in a 25mL graduated cylinder that initially contained 13.2 mL water and the new volume became 15.8 mL. What is the density of this metal? - Answer- 5.9 g/mL A student experimentally determined the mass % compisition of Ca in CaCO3 to be 38.9%. What is the real mass % composition of CaCO3? What is the % error? - Answer- real = 40.04% error = 2.858% Recall the procedure (chemical measurements). How would the following source of errors affect calculated density of water? A balance was improperly calibrated and always weigh masses 1.0g less than the real masses - Answer- no effect (take the difference) Recall the procedure (chemical measurements). How would the following source of errors affect calculated density of water? A student always read the top of the meniscus when he measured the 10 mL aliquot using graduated cylinder - Answer- The results of the experiment would be lower (division) Before we start titration, why should we rinse the burets with NaOH solution used for titration, instead of DI water? - Answer- The water left over could potentially decrease the concentration of the solution by an increase of volume of pure water What is the mass % concentraion if it was prepared by adding 10g and acetic acid to 50g of water? - Answer- 16.67 % When waiting long enough, the light pink color at end point may disappear due to CO2 from air. Explain why. - Answer- The pink color disappears due to CO2 in the air because CO2 is an acid and it dissolves into the solution. When the solution is acidic, it is clear. When the solution is basic, it turns pinks. How many grams of NaOH are there in 25 mL of a .6 mol/L NaOH solution? - Answer- .59996 What is the molarity of a H2SO4 solution if 20 mL of this solution needed 50 mL of a .5 mol/L NaOH solution to completely neutralize? - Answer- .625M What is the mass percent concentration of a .50 mol/L NaOH solution if the density of the solution is 1.0 g/mL? - Answer- 2% Consider the steps you calculated the mass % concentration of vinegar and rationalize how will the following affect the calculated mass % concentration. Measured out 11 mL vinegar sample each time instead of 10 mL - Answer- The % concentration would be unchanged because the weight is subtracted out during each calculation Consider the steps you calculated the mass % concentration of vinegar and rationalize how will the following affect the calculated mass % concentration. Before titration, rinsed the buret with DI water only without using NaOH solution - Answer- Mass % concentration would increase Consider the steps you calculated the mass % concentration of vinegar and rationalize how will the following affect the calculated mass % concentration. Some NaOH solution remains on the wall of the flask and never reach the reaction mixture - Answer- The mass % concentration would be higher because the volume will be higher Rearrange the ideal gas equation to give a y=kx+m format. Name the slope and intercept - Answer- P = 1/V (nRT) slope: nRT intercept: 0 Why must you record the column only when the height of the column of water inside the graduated cylinder is the same as the liquid level in the trough? - Answer- You need to record the volume with equal heights of liquid so that the pressures are equal. This way we can use P corrected + P gauge = P atm Students are asked to leave water in the trough so that the water will be ready for later labs, Why can't we use DI water from water faucet directly? - Answer- It is important to leave the water so that it is as close to room temperature as possible. What does it really mean when a pressure gauge reads 0? - Answer- The 0 in psi corresponds to atmospheric pressure When processing the data in part 2 (gas laws), if you plan to plot Volume on y-axis, which one do you plan to plot on x-axis, Pressure or 1/Pressure? Why? - Answer- 1/P because V and P are inversely proportional A helium balloon has a volume of 3 L and a pressure of 1.1 atm at 25 degrees C. How many grams of helium gas are there in this balloon? - Answer- .54 g NFL requires playing footballs to be inflated between 12.5 psi and 13.5 psi. However, some game balls at AFC Championship in 2015 was deflated to about 10 psi. What is the real air pressure inside a 10 psi game ball? - Answer- .68 atm An unknown gas sample has a volume of of 600 mL and a pressure of 785 torr at 22 degrees C.


Información del documento

Subido en
3 de junio de 2023
Número de páginas
7
Escrito en
2022/2023
Tipo
Examen
Contiene
Preguntas y respuestas
$10.49

¿Documento equivocado? Cámbialo gratis Dentro de los 14 días posteriores a la compra y antes de descargarlo, puedes elegir otro documento. Puedes gastar el importe de nuevo.
Escrito por estudiantes que aprobaron
Inmediatamente disponible después del pago
Leer en línea o como PDF

Seller avatar
Los indicadores de reputación están sujetos a la cantidad de artículos vendidos por una tarifa y las reseñas que ha recibido por esos documentos. Hay tres niveles: Bronce, Plata y Oro. Cuanto mayor reputación, más podrás confiar en la calidad del trabajo del vendedor.
STUDYGUIDESET
3.2
(6)
Vendido
48
Seguidores
17
Artículos
2528
Última venta
3 semanas hace



Por qué los estudiantes eligen Stuvia

Creado por compañeros estudiantes, verificado por reseñas

Calidad en la que puedes confiar: escrito por estudiantes que aprobaron y evaluado por otros que han usado estos resúmenes.

¿No estás satisfecho? Elige otro documento

¡No te preocupes! Puedes elegir directamente otro documento que se ajuste mejor a lo que buscas.

Paga como quieras, empieza a estudiar al instante

Sin suscripción, sin compromisos. Paga como estés acostumbrado con tarjeta de crédito y descarga tu documento PDF inmediatamente.

Student with book image

“Comprado, descargado y aprobado. Así de fácil puede ser.”

Alisha Student

Preguntas frecuentes

Ups! No podemos cargar tu documento ahora. Inténtalo de nuevo o contacta con soporte.