Tattoo machine (100% Correct Answers)

A -bar Correct Answers Armature bar 1.5 is standard length When a bar is flat on front coil we are coil has between .010-.012 Correct Answers Smaller creates more power it is noticeable (more coil is more power) You should be careful of small gaps as the air bar can hit the coil when the machine is running Correct Answers And this will cause it to rattle or Deflection of the a bar. It will Make that a bar bounce off of the rear coil and hit the front coil in correctly Armature bar should be Correct Answers Plain steel and no chrome. The coil cord should not extend over coil cap very much coils with too much Coors showing tend to run hot. Also they run sporadically after a short time your machine can run in consistently and will require more voltage to compensate Push the a bar down on the front coil hold machine up to the light and check Correct Answers For dust Lent etc. this can cause your machine to rattle and deflect believe it or not just blow debris with air can or pouty lips Do not allow front spring to Correct Answers Hangover the rear of the amateur Bar this can create a buzz and undue birbration Armature bar rear and coil Correct Answers Are aligned A longer a bar extending past rear is fine Correct Answers Creates a longer stroke and usually a longer a bar and is 1.625 long Angle of contact screws does not matter much Correct Answers As long as it turns on it's doing it's job however when the spring strikes the contact on the up stroke the angle of the contact screw can have an effect of the overall vibration of your machine. Once your machine is set up correctly it should Correct Answers The angle should remain the same because the Contacts crew should head at the very end or front of the spring choose a front spring that is correct for your application A short spring Correct Answers Will be faster. That same spring but the higher angle will be faster yet a lower angle makes it slower and softer hit All metals are measured on the Correct Answers Rockwell scale and find it best to be 48-51