Auto Final Exam (A+ Graded)

Both a and B correct answers Technician A says a load tester can be used to check the condition of a vehicles battery. Technician B says a load tester can be used to check the condition of a vehicle starting system. Who is right Oscilloscope correct answers What tool measures voltage overtime? Luminosity timing meter correct answers What tool is used when making a electrical test on a diesel engine Neither A nor B correct answers Technician a says and inductive wire tracer generates a DC voltage in the wiring being tested. Technician B says and inductive wire tracer checks for high current load in the circuit. Who is right 30 correct answers Wire gauges in an automobile generally range from gauge 0 to gauge ___? Fuse link correct answers To protect wiring before it gets to the fuse block a what is installed Both a and B correct answers Technician a says wiring spices are normally designated on automotive wiring diagrams buy a dot. Technician B says a G can be used on some schematics to designate ground. Who is right? 0.001 correct answers The unit mill, used to measure wire diameter, is equal to Wire harness correct answers A set of several wires wrapped in tape or enclosed in a plastic sheath is referred to as a what 1/4 mile correct answers A late model auto Mobile may contain more than ___ wire to link electrical/electronic components 4 correct answers lowest resistance in ohms per 1000 feet Wire length correct answers What is not important information conveyed by the wire code identification system Conductor resistance diagram correct answers What is not a type of wiring diagram Closed switch correct answers What is not A possible cause of an open circuit B only correct answers A vehicle keeps blowing it's fuse to the lighting system. Technician a says that a larger amp fuse might correct the trouble quickly and easily. Technician B says that installing a larger fuse could cause a serious electrical fire. Who is right