PATHFINDER WRITTEN SLING LOAD
COMPREHENSIVE STUDY GUIDE WITH
SOLUTIONS
◉ Types of Loads.
Answer: - High Density
- Low Density
- Aerodynamic
◉ Unique Characteristic of High Density Loads.
Answer: Offers best stability
(ex. HMMWV)
◉ Unique Characteristic of Low Density Loads.
Answer: Offers least stability
(ex. A22 Cargo Bag)
◉ Unique Characteristic of Aerodynamic Loads.
Answer: Unstable until the load is streamlined, then it becomes
stable
(ex. Downed Aircraft)
,◉ Maximum External Load capabilities....
Answer: will vary due to environmental conditions and helicopter
performance.
◉ What does ACL mean, what is it, and what is it based on?.
Answer: Allowable Cargo Load - the maximum load capacity for a
particular mission and determines what the helicopter can lift.
Based on type of aircraft, age of airframe, pilot experience, altitude
above sea level, temperature, humidity, and aviation unit's SOP.
◉ APEX Requirements for UH-1 Iroquois.
Answer: A nylon point of attachment, like 3 ft apex ring or basket
hitch, must be used to attach load to aircraft. In addition, 11k cargo
hook reach pendant or a polyester round sling can be used as the
point of attachment to the A/C to a UH-1 series aircraft.
◉ UH-1N/Y Cargo Hook Rated Capacity.
Answer: 5,000 lbs
◉ APEX Requirements of UH-60 Blackhawk.
Answer: When using 10k apex, aluminum apex spacer MUST be
used. This will center apex on cargo hook and prevent apex from
,lifting the keeper during oscillation of the load, which would result
in load being jettisoned from cargo hook.
When using 25k apex, spacer MUST BE REMOVED. If 25k apex
spacer used, air crew cannot jettison the load if required and cargo
hook must be manually operated by the crew chief or ground crew
on LZ.
*NEVER* use nylon point of attachment such as 3 ft apex ring
because it will bind on the load beam of the argo hook and prevent
the crew from releasing the load in an emergency situation.
◉ UH-60 Hook System Rated Capacity.
Answer: - A Model: 8,000 LBS
- L Model: 9,000 LBS
- M Model: 9,000 LBS
◉ APEX Requirements for CH-47 Chinook.
Answer: Requires no special apex in preparation and may accept all
configurations. (ex. 10k apex with and w/o spacer, 25k apex with or
w/o spacer, nylon multi-point configuration, etc.)
*DO NOT* attach single point loads to CH-47 D/F if there is nylon
point of attachment to A/C
◉ CH-47 D/F Cargo hook Locations and Rated Capacity.
Answer: - Center Cargo Hook: 26,000 lbs
, - CH-47 D/F Fore and Aft Cargo Hooks:
1. Each: 17,000 lbs
2. Combined: 25,000 lbs
3. Fore and Aft Cargo Hooks are 13 ft apart
◉ APEX Requirements for CH-53E Super Stalion.
Answer: Dual-point suspension system, uses a forward and aft cargo
hook, located 10 ft apart and must be used for dual-point loads (A/C
maximum lift capacity for this is 32,000 lbs with a max of 60% of
sling load on either forward or aft hook). A pendant is designed to be
used with the dual-point system to provide more clearance between
helicopter and hookup team.
Aircrew can open forward or aft cargo hook electrically or manually.
Manual release lever is on left side of cargo hook. In emergency,
ground crew open hook by moving manual release lever up.
Pendant cargo hook not opened electrically. Aircrew opens by
pulling on the lanyard inside of A/C. Ground crew can rotate manual
release knob on side of cargo hook to open hook but must also re-
latch the pendant cargo hook after it's opened each time.
Center cargo hook, suspended on end of pendant below fuselage
near the centerline, is used for single-point loads. Even though hook
capacity is greater (36,000lbs), aircraft max lift capacity is 32,000
lbs. Loads < 6,000 lbs may not jettison when needed so
COMPREHENSIVE STUDY GUIDE WITH
SOLUTIONS
◉ Types of Loads.
Answer: - High Density
- Low Density
- Aerodynamic
◉ Unique Characteristic of High Density Loads.
Answer: Offers best stability
(ex. HMMWV)
◉ Unique Characteristic of Low Density Loads.
Answer: Offers least stability
(ex. A22 Cargo Bag)
◉ Unique Characteristic of Aerodynamic Loads.
Answer: Unstable until the load is streamlined, then it becomes
stable
(ex. Downed Aircraft)
,◉ Maximum External Load capabilities....
Answer: will vary due to environmental conditions and helicopter
performance.
◉ What does ACL mean, what is it, and what is it based on?.
Answer: Allowable Cargo Load - the maximum load capacity for a
particular mission and determines what the helicopter can lift.
Based on type of aircraft, age of airframe, pilot experience, altitude
above sea level, temperature, humidity, and aviation unit's SOP.
◉ APEX Requirements for UH-1 Iroquois.
Answer: A nylon point of attachment, like 3 ft apex ring or basket
hitch, must be used to attach load to aircraft. In addition, 11k cargo
hook reach pendant or a polyester round sling can be used as the
point of attachment to the A/C to a UH-1 series aircraft.
◉ UH-1N/Y Cargo Hook Rated Capacity.
Answer: 5,000 lbs
◉ APEX Requirements of UH-60 Blackhawk.
Answer: When using 10k apex, aluminum apex spacer MUST be
used. This will center apex on cargo hook and prevent apex from
,lifting the keeper during oscillation of the load, which would result
in load being jettisoned from cargo hook.
When using 25k apex, spacer MUST BE REMOVED. If 25k apex
spacer used, air crew cannot jettison the load if required and cargo
hook must be manually operated by the crew chief or ground crew
on LZ.
*NEVER* use nylon point of attachment such as 3 ft apex ring
because it will bind on the load beam of the argo hook and prevent
the crew from releasing the load in an emergency situation.
◉ UH-60 Hook System Rated Capacity.
Answer: - A Model: 8,000 LBS
- L Model: 9,000 LBS
- M Model: 9,000 LBS
◉ APEX Requirements for CH-47 Chinook.
Answer: Requires no special apex in preparation and may accept all
configurations. (ex. 10k apex with and w/o spacer, 25k apex with or
w/o spacer, nylon multi-point configuration, etc.)
*DO NOT* attach single point loads to CH-47 D/F if there is nylon
point of attachment to A/C
◉ CH-47 D/F Cargo hook Locations and Rated Capacity.
Answer: - Center Cargo Hook: 26,000 lbs
, - CH-47 D/F Fore and Aft Cargo Hooks:
1. Each: 17,000 lbs
2. Combined: 25,000 lbs
3. Fore and Aft Cargo Hooks are 13 ft apart
◉ APEX Requirements for CH-53E Super Stalion.
Answer: Dual-point suspension system, uses a forward and aft cargo
hook, located 10 ft apart and must be used for dual-point loads (A/C
maximum lift capacity for this is 32,000 lbs with a max of 60% of
sling load on either forward or aft hook). A pendant is designed to be
used with the dual-point system to provide more clearance between
helicopter and hookup team.
Aircrew can open forward or aft cargo hook electrically or manually.
Manual release lever is on left side of cargo hook. In emergency,
ground crew open hook by moving manual release lever up.
Pendant cargo hook not opened electrically. Aircrew opens by
pulling on the lanyard inside of A/C. Ground crew can rotate manual
release knob on side of cargo hook to open hook but must also re-
latch the pendant cargo hook after it's opened each time.
Center cargo hook, suspended on end of pendant below fuselage
near the centerline, is used for single-point loads. Even though hook
capacity is greater (36,000lbs), aircraft max lift capacity is 32,000
lbs. Loads < 6,000 lbs may not jettison when needed so