MILLWRIGHT Answers Study Guide - Current Edition Solutions

MILLWRIGHT Answers Study Guide - Current Edition Solutions If the seal was not properly aligned or there is excessive wear in some bearing or shaft______ wear tracks will be the indicator. - answer - Unusual For removing hard to remove gasket materials found on sealing surfaces ______ is recommended. - answer - sharpened brass putty knife Apprenticeship training is - answer - Conducted on the job Charting alignment on a graph requires a chart that is divided into thousandths of an inch vertically for the indicator readings and into whole inches horizontally for the _______ measurements. - answer - Distance The orthographic drawing may contain a dash or ______ line - answer - Hidden In order to shoot through a test object and project an image onto a detector sheet or film radiography used as a source of penetrating _____. - answer - Radiation Which of the following task would you not perform with dividers? - answer - Measure angles The overspeed trip device is actuated when the turbine reaches a predetermined limit usually _______ percent above normal full load speed - answer - 10 Positive results in an offset measurement mean that the MTBM is ______ or on the 3 o'clock side - answer - High Coupling gap is set and then there is measured - answer - Offset misalignment In a hydraulic system movement depends on - answer - Pressure Fractional dimensions are used on objects ____ - answer - Such as furniture or utility items If the cause of the problem is not immediately understood the process of _____ is often the procedure of choice - answer - Elimination When applying sealant to the sealing glands flanges keep the sealant away from the inside edges of the flange by at least _______ inch - answer - 3/16 A stroboscope is triggered by _______ - answer - Transducer The page of threaded fasteners is measured with a ______ gauge. - answer - Thread Liquid penetrant highlights flaws in reveals ______. - answer - Surface cracks The tool used to cut external threads on a boat or rod is a____ - answer - Die A bill of materials may include information on ______ and other reference information - answer - Special processes Engaged gears always have the same ______ - answer - Surface speed Elevation of equipment is usually found in the - answer - General arrangements Inspect the police rollers in idlers for unevenness or _____ - answer - Vibrations When cutting then steel with oxy fuel cutting equipment all the torch say that the temp is pointing in the direction the torch is traveling at a ______ angle - answer - 15-20 degrees Labyrinth seals work best with materials such as - answer - Grease Lubrication is the application of any substances that reduces _____ - answer - Friction When the dial indicator is mounted on the complex reverse driven coupling jig the indicator is registered on the ____ - answer - Driver coupling Jig Pipe should be stored ____ - answer - racks The most common type of ball bearing is a _____ bearing - answer - Single deep groove radial Couplings that are installed after the driver and driven shafts have been aligned and the equipment has been fastened into position are _____ couplings - answer - Split When two or more numbers are multiplied to make another number they are called ______ of the third number - answer - Factors The continuous reading dial indicator starts at zero and _____ - answer - Increases clockwise Vibration with an a specific narrowband range can be detected by _____. - answer - Electronic filters Of the following types of O-rings you would select _______ for an application where temperatures may be -300°F or 500°F - answer - Teflon Special cleaning tips for cutting of bald head in notes is called a _______ tip - answer - Rivet cutting PCVs limit and regulate the _____ in the system - answer - Pressure The total distance that the chef travels from one piece to the other during one vibration cycle is the _____. - answer - Displacement A positive- contact sea