P99 LOW PRESSURE BOILER EXAM
REVIEWED QUESTIONS AND COMPLETE
CORRECT ANSWERS
The fill line in an oil burner system is a line used to - ✔✔..
Resolution Result Verified Answers ,,,,Fill the storage tank with oil
The aquastat is located - ✔✔.. Resolution Result Verified Answers
,,,,Below the water line
The oil storage tank - ✔✔.. Resolution Result Verified Answers
,,,,Provides the supply of oil for combustion in the oil burner
The temperature in the storage tank for # 6 oil is - ✔✔.. Resolution
Result Verified Answers ,,,,100 and 130 degrees Fahrenheit
A suction cup - ✔✔.. Resolution Result Verified Answers
,,,,Circulates the oil throughout the system
The oil strainer removes the contaminants - ✔✔.. Resolution Result
Verified Answers ,,,,From the oil before the oil reaches the burner
,The vacuum gauge is a device that - ✔✔.. Resolution Result
Verified Answers ,,,,Measures
the pressure below atmospheric pressure
Excessive vacuum readings indicate that there - ✔✔.. Resolution
Result Verified Answers ,,,,Is an obstruction in the suction line
(such as a dirty oil
strainer)
Preheaters are used to heat the oil - ✔✔.. Resolution Result Verified
Answers ,,,,Before the
oil enters the burner for combustion
The oil is heated between - ✔✔.. Resolution Result Verified
Answers ,,,,160 and 180
Fahrenheit
The normal normal oil pressure for no. 6 oil burner is - ✔✔..
Resolution Result Verified Answers ,,,,Between 30 and 50 psi
A fill line in an oil burner system is a line used to: - ✔✔.. Resolution
Result Verified Answers ,,,,Fill the storage tank with oil.
The aquastat is located - ✔✔.. Resolution Result Verified Answers
,,,,Below the water line.
All heating, combustion, and cooking equipment shall be installed
with adequate clearances from _______ construction. - ✔✔..correct
answer,,,,Combustible
,The equipment must be provided with ______ or the building
construction shall be _____ _____. - ✔✔.. Resolution Result Verified
Answers ,,,,Insulation.
Fire Protected
During operation the surface of combustible construction materials
will not be raised to a temp higher than _____ degrees F. -
✔✔..correct
answer,,,,170 degrees
Equipment shall be so that the means of access for ordinary
operation and maintenance will not be _______. - ✔✔..correct
answer,,,,Hazardous
Acceptance Tests:
Boilers shall not be placed in operation until they have been _____
and ____ and an equipment ____ _____ has been issued by the ______. -
✔✔.. Resolution Result Verified Answers ,,,,Inspected and tested.
Use permit, commissioner
Periodic Inspections: All boilers must be inspected at least _____ a
_____ including chimney connections. - ✔✔.. Resolution Result
Verified Answers ,,,,Once a year
Owners Annual Statement: The owner of each boiler shall file an
_____ written statement with the ________, specifying the _____of each
boiler and ______ for inspection. - ✔✔.. Resolution Result Verified
Answers ,,,,Annual, commissioner, location, arrangement.
, Field Tests: all piping and oil storage tanks shall be _______ tested for
tightness by the ______ before the system is operated. - ✔✔..correct
answer,,,,Hydrostatically, contractor
The piping shall be tested at _____ times the max working pressure
applicable to that part of the piping system but at a pressure ____
than the test pressure required for the storage tank. - ✔✔..correct
answer,,,,1/2, less
The min pressure for testing tanks shall be ____ times the max
working pressure but in no case less than ____ psi. - ✔✔..correct
answer,,,,1 1/2, 25 psi
The hydrostatic pressure must be maintained until all ____ and _____
have been visually inspected for ___, but in no case less than _____
hour. - ✔✔.. Resolution Result Verified Answers ,,,,Joints,
connections, leaks, 1/2 hour.
A record must be kept of the pressure test showing the name of the
_____ and the _____ at which the piping and tank were tested. -
✔✔.. Resolution Result Verified Answers
,,,,Contractor, pressure
Gas piping must be tested by the _____ before operation. -
✔✔.. Resolution Result
Verified Answers ,,,,Contractor
For oil burning systems, ____ ____ giving instructions for the care and
operation of the system shall be permanently located in an easily
REVIEWED QUESTIONS AND COMPLETE
CORRECT ANSWERS
The fill line in an oil burner system is a line used to - ✔✔..
Resolution Result Verified Answers ,,,,Fill the storage tank with oil
The aquastat is located - ✔✔.. Resolution Result Verified Answers
,,,,Below the water line
The oil storage tank - ✔✔.. Resolution Result Verified Answers
,,,,Provides the supply of oil for combustion in the oil burner
The temperature in the storage tank for # 6 oil is - ✔✔.. Resolution
Result Verified Answers ,,,,100 and 130 degrees Fahrenheit
A suction cup - ✔✔.. Resolution Result Verified Answers
,,,,Circulates the oil throughout the system
The oil strainer removes the contaminants - ✔✔.. Resolution Result
Verified Answers ,,,,From the oil before the oil reaches the burner
,The vacuum gauge is a device that - ✔✔.. Resolution Result
Verified Answers ,,,,Measures
the pressure below atmospheric pressure
Excessive vacuum readings indicate that there - ✔✔.. Resolution
Result Verified Answers ,,,,Is an obstruction in the suction line
(such as a dirty oil
strainer)
Preheaters are used to heat the oil - ✔✔.. Resolution Result Verified
Answers ,,,,Before the
oil enters the burner for combustion
The oil is heated between - ✔✔.. Resolution Result Verified
Answers ,,,,160 and 180
Fahrenheit
The normal normal oil pressure for no. 6 oil burner is - ✔✔..
Resolution Result Verified Answers ,,,,Between 30 and 50 psi
A fill line in an oil burner system is a line used to: - ✔✔.. Resolution
Result Verified Answers ,,,,Fill the storage tank with oil.
The aquastat is located - ✔✔.. Resolution Result Verified Answers
,,,,Below the water line.
All heating, combustion, and cooking equipment shall be installed
with adequate clearances from _______ construction. - ✔✔..correct
answer,,,,Combustible
,The equipment must be provided with ______ or the building
construction shall be _____ _____. - ✔✔.. Resolution Result Verified
Answers ,,,,Insulation.
Fire Protected
During operation the surface of combustible construction materials
will not be raised to a temp higher than _____ degrees F. -
✔✔..correct
answer,,,,170 degrees
Equipment shall be so that the means of access for ordinary
operation and maintenance will not be _______. - ✔✔..correct
answer,,,,Hazardous
Acceptance Tests:
Boilers shall not be placed in operation until they have been _____
and ____ and an equipment ____ _____ has been issued by the ______. -
✔✔.. Resolution Result Verified Answers ,,,,Inspected and tested.
Use permit, commissioner
Periodic Inspections: All boilers must be inspected at least _____ a
_____ including chimney connections. - ✔✔.. Resolution Result
Verified Answers ,,,,Once a year
Owners Annual Statement: The owner of each boiler shall file an
_____ written statement with the ________, specifying the _____of each
boiler and ______ for inspection. - ✔✔.. Resolution Result Verified
Answers ,,,,Annual, commissioner, location, arrangement.
, Field Tests: all piping and oil storage tanks shall be _______ tested for
tightness by the ______ before the system is operated. - ✔✔..correct
answer,,,,Hydrostatically, contractor
The piping shall be tested at _____ times the max working pressure
applicable to that part of the piping system but at a pressure ____
than the test pressure required for the storage tank. - ✔✔..correct
answer,,,,1/2, less
The min pressure for testing tanks shall be ____ times the max
working pressure but in no case less than ____ psi. - ✔✔..correct
answer,,,,1 1/2, 25 psi
The hydrostatic pressure must be maintained until all ____ and _____
have been visually inspected for ___, but in no case less than _____
hour. - ✔✔.. Resolution Result Verified Answers ,,,,Joints,
connections, leaks, 1/2 hour.
A record must be kept of the pressure test showing the name of the
_____ and the _____ at which the piping and tank were tested. -
✔✔.. Resolution Result Verified Answers
,,,,Contractor, pressure
Gas piping must be tested by the _____ before operation. -
✔✔.. Resolution Result
Verified Answers ,,,,Contractor
For oil burning systems, ____ ____ giving instructions for the care and
operation of the system shall be permanently located in an easily
