J STD 001 COMPREHENSIVE EXAMINATION
TEST COMPLETE QUESTIONS WITH
ACCURATE SOLUTIONS
●● Electrical/mechanical components and wires to be soldered shall
meet the solderiability of what document or equivalent
Answer: J std 002
●● in the event of a conflict between this standard and applicable
engineering documentation the ____________ governs.
Answer: user approved engineering documentation
●● Straight through or lead/wires wrapped less than 180 degrees shall
show evidence of good wetting for _________%
Answer: 100
●● The IPC -T-50 document provides ______________
Answer: terms and definitions
●● Assemblies subjected to cleaning processes shall be free of
_________
Answer: visible residues
, ●● It is the responsibility of the __________to identify defects and
process indicators that are unique to the process assembly
Answer: manufacturer
●● The _________has the responsibility for identifying the class to
which the assembly is produced
Answer: user
●● Leads/wires with a wrap of 180 degrees or greater shall show
evidence of good wetting for a minimum of _______%
Answer: 75
●● Which class product includes continued performance and extended
life, uninterrupted service is desired but not critical?
Answer: class 2
●● When a wire/lead is wrapped more than 360 degrees and remains in
contact with the terminal. This condition is known as?
Answer: wire overwrap
●● The ______ ________ _________ is intended for use only after a
defect has been determined but is not completely identifiable.
Answer: referee magnification power
TEST COMPLETE QUESTIONS WITH
ACCURATE SOLUTIONS
●● Electrical/mechanical components and wires to be soldered shall
meet the solderiability of what document or equivalent
Answer: J std 002
●● in the event of a conflict between this standard and applicable
engineering documentation the ____________ governs.
Answer: user approved engineering documentation
●● Straight through or lead/wires wrapped less than 180 degrees shall
show evidence of good wetting for _________%
Answer: 100
●● The IPC -T-50 document provides ______________
Answer: terms and definitions
●● Assemblies subjected to cleaning processes shall be free of
_________
Answer: visible residues
, ●● It is the responsibility of the __________to identify defects and
process indicators that are unique to the process assembly
Answer: manufacturer
●● The _________has the responsibility for identifying the class to
which the assembly is produced
Answer: user
●● Leads/wires with a wrap of 180 degrees or greater shall show
evidence of good wetting for a minimum of _______%
Answer: 75
●● Which class product includes continued performance and extended
life, uninterrupted service is desired but not critical?
Answer: class 2
●● When a wire/lead is wrapped more than 360 degrees and remains in
contact with the terminal. This condition is known as?
Answer: wire overwrap
●● The ______ ________ _________ is intended for use only after a
defect has been determined but is not completely identifiable.
Answer: referee magnification power
