Escrito por estudiantes que aprobaron Inmediatamente disponible después del pago Leer en línea o como PDF ¿Documento equivocado? Cámbialo gratis 4,6 TrustPilot
logo-home
Document preview thumbnail
Vista previa 3 fuera de 28 páginas
Examen

ROPE RESCUE TECHNICIAN EXAM WITH VERIFIED QUESTIONS AND ANSWERS

Document preview thumbnail
Vista previa 3 fuera de 28 páginas

ROPE RESCUE TECHNICIAN EXAM WITH VERIFIED QUESTIONS AND ANSWERS when possible, ____ separate anchor sites should be employed to assure a safe and redundant rope rescue system - ANSWER-2 when setting up a contingency anchor system, you need to have - ANSWER twice as much rope when directing your team that is using an anchor with a change of direction greater than 180 deg (interior angle of 0 deg) remember the force placed on the anchor will be.... - ANSWER-twice the load on the system when constructing an anchor system so the load will be evenly spread, you should use the .... - ANSWER-redundant double loop what other equipment should the first rescuer have to climb a tower besides wearing a harness and having a radio - ANSWER-a small diameter rope or drop line a clutch has a center plate and the extension off the center plate for a carabiner attachment is the ___ - ANSWER-becket a litter basket requires _____ main lines to accommodate a horizontal lower with two attendants - ANSWER-2 when using a CLUTCH for ascending.... - ANSWER-add a rope grab with a foot loop above the CLUTCH. when using a CLUTCH lowering system, you should.... - ANSWER-first load and test the CLUTCH to confirm proper operation the first step for size up is - ANSWER-the dispatcher informing on the location of the incident the most common fall arrest system in the industry is the.. - ANSWER-full body harness, an energy absorber, and a lanyard to an anchorage in the ICS, the rigging team reports to... - ANSWER-rescue group supervisor PPE that meets the requirements set forth by the NFPA shall be - ANSWER properly marked which of the following is acceptable for high angle edge work - ANSWER move the litter to the edge and the edge men lower the litter over the edge until it is resting on the system adding a second tender on a high angle litter evacuation will - ANSWER increase the overall load by nearly 50% when you are backing over the edge, make sure.. - ANSWER-to observe the descender clears the edge when negotiating an edge, which is the most difficult - ANSWER-when the anchor is low when negotiating a difficult edge, be sure to.. - ANSWER-step down with one foot, then a short step with the other, to regain a balanced position the high angle litter tender is attached to the system with - ANSWER-two attachment points when lowering a load, a continuous whistle blast means - ANSWER-trouble

Vista previa del contenido

ROPE RESCUE TECHNICIAN EXAM WITH
VERIFIED QUESTIONS AND ANSWERS




when possible, ____ separate anchor sites should be employed to assure a safe
and redundant rope rescue system - ANSWER-2


when setting up a contingency anchor system, you need to have - ANSWER-
twice as much rope


when directing your team that is using an anchor with a change of direction
greater than 180 deg (interior angle of 0 deg) remember the force placed on the
anchor will be.... - ANSWER-twice the load on the system


when constructing an anchor system so the load will be evenly spread, you
should use the .... - ANSWER-redundant double loop


what other equipment should the first rescuer have to climb a tower besides
wearing a harness and having a radio - ANSWER-a small diameter rope or drop
line


a clutch has a center plate and the extension off the center plate for a carabiner
attachment is the ___ - ANSWER-becket


a litter basket requires _____ main lines to accommodate a horizontal lower
with two attendants - ANSWER-2


when using a CLUTCH for ascending.... - ANSWER-add a rope grab with a
foot loop above the CLUTCH.

,when using a CLUTCH lowering system, you should.... - ANSWER-first load
and test the CLUTCH to confirm proper operation


the first step for size up is - ANSWER-the dispatcher informing on the location
of the incident


the most common fall arrest system in the industry is the.. - ANSWER-full body
harness, an energy absorber, and a lanyard to an anchorage


in the ICS, the rigging team reports to... - ANSWER-rescue group supervisor


PPE that meets the requirements set forth by the NFPA shall be - ANSWER-
properly marked


which of the following is acceptable for high angle edge work - ANSWER-
move the litter to the edge and the edge men lower the litter over the edge until
it is resting on the system


adding a second tender on a high angle litter evacuation will - ANSWER-
increase the overall load by nearly 50%


when you are backing over the edge, make sure.. - ANSWER-to observe the
descender clears the edge


when negotiating an edge, which is the most difficult - ANSWER-when the
anchor is low


when negotiating a difficult edge, be sure to.. - ANSWER-step down with one
foot, then a short step with the other, to regain a balanced position

, the high angle litter tender is attached to the system with - ANSWER-two
attachment points


when lowering a load, a continuous whistle blast means - ANSWER-trouble


what voice communication should be given by any member of the rescue team
who sees something going wrong during a low angle victim evacuation -
ANSWER-stop


rescue rope logs should... - ANSWER-record the life history for an individual
piece of life safety rope


ropes should be inspected... - ANSWER-before being used


it is essential that every time a rescue rope is used and placed back in storage... -
ANSWER-an entry is made in the rope history log


which is an unacceptable way to treat a rope - ANSWER-stand on the rope to
help with rigging


a compound pulley system in which one hauling system pulls another hauling
system is a - ANSWER-piggyback system


a means of increasing a rescuer's ability to lift or move a load is called -
ANSWER-Mechanical Advantage


In a MA system, which pulleys create the MA - ANSWER-those attached to the
load


theoretical MA is best defined as.. - ANSWER-Output force divided by Input
force= MA

Información del documento

Subido en
1 de septiembre de 2026
Número de páginas
28
Escrito en
2026/2027
Tipo
Examen
Contiene
Preguntas y respuestas
$22.99

¿Documento equivocado? Cámbialo gratis Dentro de los 14 días posteriores a la compra y antes de descargarlo, puedes elegir otro documento. Puedes gastar el importe de nuevo.
Escrito por estudiantes que aprobaron
Inmediatamente disponible después del pago
Leer en línea o como PDF

Seller avatar
Los indicadores de reputación están sujetos a la cantidad de artículos vendidos por una tarifa y las reseñas que ha recibido por esos documentos. Hay tres niveles: Bronce, Plata y Oro. Cuanto mayor reputación, más podrás confiar en la calidad del trabajo del vendedor.
Vendido
14
Seguidores
1
Artículos
1390
Última venta
2 semanas hace



Por qué los estudiantes eligen Stuvia

Creado por compañeros estudiantes, verificado por reseñas

Calidad en la que puedes confiar: escrito por estudiantes que aprobaron y evaluado por otros que han usado estos resúmenes.

¿No estás satisfecho? Elige otro documento

¡No te preocupes! Puedes elegir directamente otro documento que se ajuste mejor a lo que buscas.

Paga como quieras, empieza a estudiar al instante

Sin suscripción, sin compromisos. Paga como estés acostumbrado con tarjeta de crédito y descarga tu documento PDF inmediatamente.

Student with book image

“Comprado, descargado y aprobado. Así de fácil puede ser.”

Alisha Student

Preguntas frecuentes