FIREFIGHTER CERTIFICATION
EVALUATION TESTED QUESTIONS WITH
COMPLETE SOLUTION PACKAGE
●● duty of a ff2
Answer: coordinate an interior attack line at a structure fire
●● NFPA 1962 provides guidance for?
Answer: testing fire hose
●● hose service tests are performed? (3)
Answer: 1 annually
2 after repairs
3 after a vehicle has ran over the hose
●● service test procedures (4)
Answer: 1 connect hose to hose tester in straight runs no longer than
300ft per discharge
2 maintain test pressure in accordance with NFPA 1962 (3mins)
3 observe Mark's on hose; movement equals coupling slippage
4 all test results must be recorded
,●● inspect generators, lighting units and lighting accessories when?
Answer: periodically and after each use
●● when should you avoid starting a generator?
Answer: when it's under a load
●● what do you inspect electrical cords for?
Answer: frayed wiring or missing prongs
●● what do you use to wipe grease and oil from generators?
Answer: a clean rag
●● who is informed of something is wrong with equipment?
Answer: your supervisor
●● foam concentrate
Answer: raw foam liquid in its storage container
●● foam proportioner
Answer: device that introduces foam concentrate into the water stream
●● foam solution
, Answer: mixture of foam concentrate and water before the introduction
of air
●● Finished Foam
Answer: Completed product after air is introduced into the foam
solution.
●● what is class A foam commonly used for?
Answer: wildland and structural firefighting
●● batch mixing
Answer: difficult process that requires thorough clean up of vehicle tank,
pump, and hoselines
●● bank down method
Answer: stream is directed onto the object and allowed to run down onto
the fuel
●● rain down method
Answer: direct stream above fire and allow the foam to float gently
down onto the surface of the fuel
●● what are flammable liquids flash point?
EVALUATION TESTED QUESTIONS WITH
COMPLETE SOLUTION PACKAGE
●● duty of a ff2
Answer: coordinate an interior attack line at a structure fire
●● NFPA 1962 provides guidance for?
Answer: testing fire hose
●● hose service tests are performed? (3)
Answer: 1 annually
2 after repairs
3 after a vehicle has ran over the hose
●● service test procedures (4)
Answer: 1 connect hose to hose tester in straight runs no longer than
300ft per discharge
2 maintain test pressure in accordance with NFPA 1962 (3mins)
3 observe Mark's on hose; movement equals coupling slippage
4 all test results must be recorded
,●● inspect generators, lighting units and lighting accessories when?
Answer: periodically and after each use
●● when should you avoid starting a generator?
Answer: when it's under a load
●● what do you inspect electrical cords for?
Answer: frayed wiring or missing prongs
●● what do you use to wipe grease and oil from generators?
Answer: a clean rag
●● who is informed of something is wrong with equipment?
Answer: your supervisor
●● foam concentrate
Answer: raw foam liquid in its storage container
●● foam proportioner
Answer: device that introduces foam concentrate into the water stream
●● foam solution
, Answer: mixture of foam concentrate and water before the introduction
of air
●● Finished Foam
Answer: Completed product after air is introduced into the foam
solution.
●● what is class A foam commonly used for?
Answer: wildland and structural firefighting
●● batch mixing
Answer: difficult process that requires thorough clean up of vehicle tank,
pump, and hoselines
●● bank down method
Answer: stream is directed onto the object and allowed to run down onto
the fuel
●● rain down method
Answer: direct stream above fire and allow the foam to float gently
down onto the surface of the fuel
●● what are flammable liquids flash point?
