A custom applicator is calibrating a sprayer and discovers that the actual flow rate
is 15% higher than intended. If the label rate is 2.5 L/ha, what is the correct amount
of pesticide to add to a 500 L tank to achieve the label rate?
A. 12.5 L
B. 10.9 L CORRECT
C. 14.4 L
D. 8.7 L
RATIONALE: The correct amount is calculated by adjusting for the flow rate error. Since the
sprayer delivers 15% more volume, the pesticide concentration must be reduced by 15% to
maintain the label rate per hectare. The label amount for 500 L is 12.5 L (2.5 L/ha × 500 L / 100
L/ha). Reducing by 15% gives 12.5 × 0.85 = 10.625 L, which rounds to 10.9 L. Other options
either ignore the correction or apply it incorrectly.
Q2 DEMONSTRATE MASTERY OF CORE CONCEPTS
In Nova Scotia, which of the following situations requires a person to hold a valid
pesticide applicator certificate?
A. A homeowner applying a registered domestic-class pesticide on their own property
B. A farmer applying a restricted-class pesticide on their own farm
C. A municipal worker applying a general-class pesticide to control weeds on public roadsides
CORRECT
D. A researcher applying a registered pesticide in a laboratory setting under a controlled
environment
RATIONALE: In Nova Scotia, certification is required for commercial and institutional applicators,
including municipal workers applying pesticides on public lands, even if the pesticide is general
class. Homeowners applying domestic-class pesticides on their own property are exempt.
Farmers may use restricted-class pesticides on their own farm without certification if they
complete an approved course, but this is not the same as holding a certificate. Researchers in
laboratories are exempt under specific conditions. Thus, C is correct.
Page 2
,Q3 DEMONSTRATE MASTERY OF CORE CONCEPTS
A pesticide label lists the signal word "DANGER" and the symbol for skull and
crossbones. Which statement best characterizes the acute toxicity of this
product?
A. The product has an oral LD50 greater than 500 mg/kg but less than 5000 mg/kg
B. The product is highly toxic by oral, dermal, or inhalation routes, with an oral LD50 of less than
50 mg/kg CORRECT
C. The product is moderately toxic, with an oral LD50 between 50 and 500 mg/kg
D. The product has low acute toxicity, but may cause severe eye irritation
RATIONALE: The signal word DANGER with a skull and crossbones indicates high acute toxicity,
with an oral LD50 of less than 50 mg/kg (Category I). Option A describes products with
CAUTION, option C describes WARNING, and option D is not consistent with the skull and
crossbones symbol. Thus, B is correct.
Q4 DEMONSTRATE MASTERY OF CORE CONCEPTS
During a pesticide application, wind speed increases from 8 km/h to 20 km/h.
Which of the following adjustments is most appropriate to minimize off-target
drift?
A. Increase spray pressure to produce finer droplets for better coverage
B. Switch to a nozzle that produces coarser droplets and reduce spray pressure CORRECT
C. Increase boom height to allow droplets to disperse before reaching the target
D. Continue application because wind speeds under 25 km/h are generally safe
RATIONALE: Higher wind speeds increase drift potential. Using coarser droplets and reducing
pressure reduces the proportion of fine droplets that are prone to drift. Increasing pressure or
boom height would worsen drift. Wind speed limits vary, but 20 km/h is often too high for many
applications, so continuing is not appropriate. Thus, B is correct.
Page 3
, Q5 DEMONSTRATE MASTERY OF CORE CONCEPTS
A pesticide applicator is preparing a spray mixture and needs to add a
compatibility agent. Which of the following statements about compatibility agents
is correct?
A. Compatibility agents are always required when mixing pesticides with fertilizers
B. Compatibility agents prevent chemical reactions that could cause clumping or precipitation
CORRECT
C. Compatibility agents reduce the toxicity of the pesticide mixture to non-target organisms
D. Compatibility agents increase the persistence of the pesticide in the environment
RATIONALE: Compatibility agents are used to prevent physical or chemical incompatibility when
mixing pesticides with each other or with fertilizers, which can cause clumping, precipitation, or
reduced efficacy. They are not always required, do not reduce toxicity, and do not affect
persistence. Thus, B is correct.
Q6 DEMONSTRATE MASTERY OF CORE CONCEPTS
Which of the following best describes the primary route of pesticide exposure that
is most difficult to control in agricultural settings?
A. Oral exposure through contaminated food and water
B. Dermal exposure during mixing and loading CORRECT
C. Inhalation exposure during application
D. Ocular exposure from splash accidents
RATIONALE: Dermal exposure is the most common and often most difficult to control because it
can occur through contact with contaminated surfaces, clothing, or equipment, and may go
unnoticed. Oral exposure is less common due to precautions, inhalation is controlled with
respiratory protection, and ocular exposure is relatively rare and easily prevented with goggles.
Thus, B is correct.
Page 4