MASTER ELECTRICIAN CERTIFICATION
EVALUATION 2026 FULL QUESTIONS AND
SOLUTIONS
◉ Lighting system operating at 30V or less shall not be installed
within ____ feet of pools, spas, fountains, or similar locations..
Answer: 10'ft
◉ The working space in front of the electric equipment shall not be
less than ____ inches wide, or the width of the equipment, whichever
is greater..
Answer: 30" inches
◉ The minimum clearance for overhead feeder conductors not
exceeding 600V that pass over commercial areas subject to truck
traffic is ____ feet..
Answer: 18" feet
◉ A limited care facility is an area used on a ____hour basis for the
housing of four or more persons who are incapable of self-
preservation because of age, physical limitation due to accident or
illness, or mental limitations, mental illness, or chemical
dependency..
,Answer: 24hr
◉ For equipment rated 1200A or more and over 6ft wide that
contains over-current devices, switching devices, or control devices,
there shall be one entrance to and egress from the required working
space not less than 24inches. Wide and ____ nches high at each end of
the working space..
Answer: 6'foot 6"inches (78" inches)
◉ Rigid metal conduit that is directly buried outdoors shall have at
least ____inches of cover..
Answer: 6" inches
◉ In a health care facility, receptacles and attachment plugs in a
hazardous (classified) location within an anesthetizing are shall be
listed for use in Class 1, GroupC..
Answer:
◉ Infrared Lamps for commercial and industrial heating appliances
shall have over-current protection not exceeding ____ Amps..
Answer: 50Amps
◉ Panel boards equipped with snap switches rated at ____ or less
shall have over-current protection not exceeding 200A..
, Answer: 30Amps
◉ For cord and plug connected electric vehicle supply equipment is
used, the interrupting devices of a listed personnel protection
system shall be provided and shall be located in the power supply
cable not more than ____inches from the attachment plug..
Answer: 12" inches
◉ Equipment associated with electrical installation can be located
above or below other electrical equipment within their working
space when the associated equipment does not extend more than
—— inches from the front of the electrical equipment..
Answer: 6" inches
◉ A fixed storage type water heater of 120 gallons or less shall be
considered a continuous, load and the branch circuits conductors
shall have an ampacity of ____ % of the nameplate current rating.
Answer: 125%
◉ Ground-fault protection of equipment shall be provided from
solidly grounded which electrical services of more than 150V to
ground, but not exceeding 600V phase for each service
disconnecting means rated at 1,000A.
Answer:
EVALUATION 2026 FULL QUESTIONS AND
SOLUTIONS
◉ Lighting system operating at 30V or less shall not be installed
within ____ feet of pools, spas, fountains, or similar locations..
Answer: 10'ft
◉ The working space in front of the electric equipment shall not be
less than ____ inches wide, or the width of the equipment, whichever
is greater..
Answer: 30" inches
◉ The minimum clearance for overhead feeder conductors not
exceeding 600V that pass over commercial areas subject to truck
traffic is ____ feet..
Answer: 18" feet
◉ A limited care facility is an area used on a ____hour basis for the
housing of four or more persons who are incapable of self-
preservation because of age, physical limitation due to accident or
illness, or mental limitations, mental illness, or chemical
dependency..
,Answer: 24hr
◉ For equipment rated 1200A or more and over 6ft wide that
contains over-current devices, switching devices, or control devices,
there shall be one entrance to and egress from the required working
space not less than 24inches. Wide and ____ nches high at each end of
the working space..
Answer: 6'foot 6"inches (78" inches)
◉ Rigid metal conduit that is directly buried outdoors shall have at
least ____inches of cover..
Answer: 6" inches
◉ In a health care facility, receptacles and attachment plugs in a
hazardous (classified) location within an anesthetizing are shall be
listed for use in Class 1, GroupC..
Answer:
◉ Infrared Lamps for commercial and industrial heating appliances
shall have over-current protection not exceeding ____ Amps..
Answer: 50Amps
◉ Panel boards equipped with snap switches rated at ____ or less
shall have over-current protection not exceeding 200A..
, Answer: 30Amps
◉ For cord and plug connected electric vehicle supply equipment is
used, the interrupting devices of a listed personnel protection
system shall be provided and shall be located in the power supply
cable not more than ____inches from the attachment plug..
Answer: 12" inches
◉ Equipment associated with electrical installation can be located
above or below other electrical equipment within their working
space when the associated equipment does not extend more than
—— inches from the front of the electrical equipment..
Answer: 6" inches
◉ A fixed storage type water heater of 120 gallons or less shall be
considered a continuous, load and the branch circuits conductors
shall have an ampacity of ____ % of the nameplate current rating.
Answer: 125%
◉ Ground-fault protection of equipment shall be provided from
solidly grounded which electrical services of more than 150V to
ground, but not exceeding 600V phase for each service
disconnecting means rated at 1,000A.
Answer:
